conducting rod with length of 20cm is pulled along the a rotated U-shaped (see the figure)  conductor assuming that resistance is negligible). what is the magnitude of the induced emf if the magentic field has a constant value of 22.5 mT and the constant velocity at which the rod is pulled is 8m/s.

Q: Give an order of magnitude estimate, based on Faraday’s law, of the maximum induced emf detected by…

A:

Q: A car generator turns at 400 rpm when the engine is idling. Its 300 turn, 5.1 cm by 8.15 cm…

A: Given that,n = 400 (rpm)Number of turns : N = 300Here we need to find magnetic field :Now,As we know…

Q: rectangular loop and a circular loop are moving out of a uniform magnetic field region to a…

A: Given  A rectangular loop and a circular loop are moving out of a uniform magnetic field region to a…

Q: A car alternator produces peak output Vo to charge the car's 12 V battery. Suppose the alternator…

A: Given Data :The maximum voltage output is The diameter of coil is Revolution frequency is The…

Q: S -0000 Consider the above circuit. You have assembled the above circuit and the EMF source is a 4V…

A: A DC circuit is given containing inductor and capacitor

Q: rectangular loop of wire is located close to a long straight wire initially carrying a current I =…

A: According to Faraday second law  Induced emf = rate of change of magnetic flux

Q: Problem 4: Suppose a 55 cm long, 12 cm diameter solenoid has 1000 loops. Part (a) Calculate the…

A:

Q: The time variation of the current in a 3H inductor is given by I=5+7t-7t^2, with I in amperes and t…

A:

Q: A small rectangular loop of wire is located close to a long straight wire initially carrying a…

A: Given value--- Current = 106 Amp. time interval = 1/136 s. We have to find--- Find the average…

Q: Figure shows a RL circuit and a conducting rod. RL circuit has ɛ = constant t= 1 s. A conducting rod…

A:

Q: A loop of wire in the shape of a rectangle of width w and length L and a long, straight wire…

A: As per our company guidelines we are supposed to answer only first 3-sub part. Kindly repost other…

Q: Problem 7: A conducting rod spans a gap of length L = 0.075 m and acts as the fourth side of a…

A:

Q: For a classroom demonstration, a professor built an RL circuit similar to the one shown in the…

A: Introduction: RL circuit is a circuit which consists of Inductors and Resistors combinations and…

Q: Determine the magnitude of the induced emf: A loop wire initially encloses a square region of flux,…

A: Initial side length of the square region is 3 cm = 3 × 10-2 m Therefore, initial area, Ai = (3 ×…

Q: A air-filed solenoid 3.3 m diameter and length 23 cm, has 100 turns. If the current increases from 9…

A: (a) Let d denotes the solenoid’s diameter, A denotes the area, l denotes the solenoid’s length, N…

Q: The magnetic flux through the loop increases according to the relation shown below. What is the…

A:

Q: What percentage of the final current I0 flows through an inductor L in series with a resistor R ,…

A: The decay of current in LR circuit is, I=I01-e-tτ

Q: Example: If a coil conductor is connected to a 3 kQ resistor, what would be the rated voltage and…

A: Example: The rated voltage(V) and the current(I). Given, Number of turnsN=3rate of change of…

Q: For a toroidal solenoid, suppose the number of turns is 291, the area is 4.89 cm 2, and the radius…

A:

Q: Tia needs to produce a solenoid that has an inductance of 3.33 ?H She constructs the solenoid by…

A:

Q: On a clear day at a certain location, the Earth's magnetic field has a magnitude of 0.500 × 10-4 T.…

A: The energy density of a system is defined as the total energy stored in the system per unit volume.…

Q: A loop of wire in the shape of a rectangle rotates with a frequency of 208 rotation per minute in an…

A:

Q: the battery long after the switch has been closed A 1,8 MF Capacitor is charges to 55 V by abort…

A:

Q: Basic of electrical circuits (a) A 5 μH inductor is driven by a current I(t) = 10 sin (27 10t) mA.…

A:

Q: An MRI technician moves his hand from a region of very low magnetic field strength into an MRI…

A: Initial magnetic field is Bi=0R=1.00 mJ  =1.00 mJ×10-3 J1 mJ  =10-3 J Final magnetic field is…

Q: A four pole machine generates 250V when operated at 1500rpm. If the flux per pole is 1.085x10^6…

A: In this case, a four-pole machine generates some voltage while operated at a certain speed. The…

Q: A copper wire of length L is fashioned into a circular coil with N turns. When the magnetic field…

A: The induced emf generated in the wire can be obtained as The magnetic flux is given by

Q: A wire 0.5 m long cuts through a 0.4 T field at a speed of 20 m/s. What is the induced EMF? If the…

A:

Q: A 5300-pF capacitor is charged to 85 V and then quickly connected to an inductor with 75-mH…

A:

Q: A loop of wire enclosing an area A is placed in a region, where the magnetic field is perpendicular…

A:

Q: Give an order of magnitude estimate, based on Faraday’s law, of the maximum induced emf detected by…

A: The given values are,

Q: )An MRI technician moves his hand from a region of very low magnetic field strength into an MRI…

A: Magnetic field strength 4.40 TDiameter of the ring 2.20 cmTime taken to move into the field: 0.35 s

Q: A 510-turn solenoid has a radius of 8.00 mm and an overall length of 14.0 cm. What is its…

A: Solution:-Given thatNumber of turns (N)=510Radius (R)=8 mm=0.008 mOverall length (L)=14 cm=0.14 m

Q: The figure below shows a circular conducting loop in the presence of an outward non-uniform magnetic…

A: Given: The magnetic field is 0.0006t3. The radius of the coil is 4.8 m. The resistance of the coil…

Q: 3) Figure shows a RL circuit and a conducting rod. RL circuit has ɛ = 30 V, R=10 N, and the time…

A: Value of resistance= 10 ohms Time constant= 1 sec Applied voltage, = 30 v

Q: inductor: € == dI dt Lenz's Law: The induced EMF will fight the change in current through an - Ld…

A: Since you posted two questions, we will solve only first question and for the solutions of other…

Q: The induced emf of a dc machine running at 750 rpm is 220 V. The percentage increase in field flux…

A: Given that,Initially, Induced emf, E1=220 VoltSpeed of motor, N1=750 rpm.When, Emf, E2=250 VoltSpeed…

Q: An inductor that has an inductance of 16.0 H and a resistance of 24.0 2 is connected across a 100 V…

A: inductance=16 Hresistance=24Ωvoltage=100 v

Q: Shrinking Loop. A circular loop of flexible iron wire has an initial circumference of 160 cm , but…

A: