Answered: A four pole machine generates 250V when… | bartleby

Related questions

Question

A four pole machine generates 250V when operated at 1500rpm. If the flux per pole is 1.085x10^6 Maxwells, the number of armature slots is 45 and the armature winding has two parallel paths, Calculate (a) the total number of armature conductors, (b) the number of conductors each slot.

Expert Solution

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

What voltage is induced in a 1.00 m diameter loop 50.0 m from a 2.00 X 106 A lightning strike, if the current falls to zero in 25.0 μS
A 7.50 nF capacitor is charged to 12.0 V, then disconnectedfrom the power supply and connected in series through a coil. The periodof oscillation of the circuit is then measured to be 8.60 * 10^-5 s.Calculate:the maximum current in the circuit
The generator of a car idling at 1.638E+3 rpm produces 11.6 V. What will the output be at a rotation speed of 2.762E+3 rpm, assuming nothing else changes? Answer in units of V.
A 24-V battery is connected in series with a resistor and an inductor, with R = 7.4 and L = 6.2 H, respectively. (a) Find the energy stored in the inductor when the current reaches its maximum value. (b) Find the energy stored in the inductor one time constant after the switch is closed. J
A flat circular coil has 80 turns of diameter 20 cm with a total resistance of 40 ohm. The plane of the coil is perpendicular to a uniform field. At what rate should the field change for the thermal power dissipated in the coil to be 2 W? Needs Complete typed solution with 100 % accuracy.
A DC motor has a rotor and field coils connected in series with a resistance of 3.2 Ω. When it spins at full load on a 120 V line, the emf rotor is equal to 105 V. (a) What is the current that the motor receives from the line? (b) What is the power required for the engine? (c) What is the mechanical power developed by the engine?
In the figure, R = 11.0 Ω, C = 6.82 μF, and L = 54.0 mH, and the ideal battery has emf = 32.0 V. The switch is kept in position a for a long time and then thrown to position b. What are the (a) frequency and (b) current amplitude of the resulting oscillations?
A dc motor with its rotor and field coils connected in series has an internalresistance of 2.00 Ω. When running at full load on a 120 V line, itdraws a 4.00 A current. What is the power delivered to the motor?
A typical wall outlet voltage in the United States is 120 volts. Personal MP3 players require much smaller voltages, typically 302.1 mV. If the number of turns in the primary coil is 35753575, calculate the number of turns NS on the secondary coil of the adapter transformer.
Consider the RL direct current circuit shown. The circuit contains R = 4.0 Ω, L = 10 mH, & ε = 12 V. The circuit is charging. (a) Determine the time constant for the circuit? (b) What is the maximum current in the circuit? (c) What is the current one time constant (t = τ )? (d) When the current is 0.5 A, what is the strength of the magnetic field in the solenoid, with n = N/ℓ = 319x103 turns/m. ( T×m/A)
A galvanometer has a coil resistance of Rgaly I = 2.55 A. If the galvanometer deflects full scale for a current of Igalv 45.2 Q. It is to be made into an ammeter with a full-scale deflection equal to 175 mA, what size shunt resistor should be used? size of shunt resistor: Ω
To ignite a mixture of gasoline and air inside an internal combustion engine--like in your car--a spark is generated by a high voltage across the spark plug, usually in the 10's of thousands of volts, but the battery is only 12 V. This massive increase in voltage is achieved through a transformer called the 'ignition coil'. A typical ignition coil has a primary with 300 turns wrapped around a radius of 2 cm over a linear distance of 15 cm. The secondary has 60,000 turns of wire over the same cylinder. The spark is generated when the current is suddenly shut off to the coil. Assuming that the magnetic field is uniform inside the primary and secondary coils, and that all of the magnetic field lines that go through the primary go through the secondary, what voltage is generated in the secondary coil if the current in the primary coil drops from 10 A to 0 A at a steady rate over the course of 50 mirco-seconds? Give your answer to 2 significant digits. Hint: Remember the definition of flux…

SEE MORE QUESTIONS