One of the engineers in the electric-power industry came up with the idea of using inductors to store electrical energy generated during low-demand hours to help meet customer requirements during high-demand hours. What inductance would be needed to store adequate electrical energy to run a 1000 W heater for one hour using an inductor carrying a 200 A current? Elektrik enerjisi sektöründeki mühendislerden biri, talebin yüksek olduğu saatlerde müşteri gereksinimlerini karşılamaya yardımcı olmak adına düşük talep saatlerinde üretilen elektrik enerjisini depolamak için indüktörler kullanma fikrini ortaya atmıştır. Bir indüktör kullanarak 1000 W'lik bir ısıtıcıyı bir saat boyunca çalıştırmak için yeterli elektrik enerjisini 200 A akımda depolamak için gerekli indüktans değeri nedir? 50 H 2.5 H 0.8 H 90 H 25 H 0.05 H 360 H 180 H 100 H

One of the engineers in the electric-power industry came up with the idea of using inductors to store electrical energy generated during low-demand hours to help meet customer requirements during high-demand hours. What inductance would be needed to store adequate electrical energy to run a 1000 W heater for one hour using an inductor carrying a 200 A current? Elektrik enerjisi sektöründeki mühendislerden biri, talebin yüksek olduğu saatlerde müşteri gereksinimlerini karşılamaya yardımcı olmak adına düşük talep saatlerinde üretilen elektrik enerjisini depolamak için indüktörler kullanma fikrini ortaya atmıştır. Bir indüktör kullanarak 1000 W'lik bir ısıtıcıyı bir saat boyunca çalıştırmak için yeterli elektrik enerjisini 200 A akımda depolamak için gerekli indüktans değeri nedir? 50 H 2.5 H 0.8 H 90 H 25 H 0.05 H 360 H 180 H 100 H

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

An LRC circuit contains a 700-Ω resistor, a 7.00-Hcoil, and an unknown capacitor. The circuit resonates at1000 Hz. What is the value of the capacitance ?? The resonant frequency of an LRC circuit is 425 Hz.If the resistance is 300 Ω and the capacitance is 200 nF, what is the value of the inductance ??
6.43 The current in an 80-mH inductor increases from 0to 60 mA. How much energy is stored in theinductor?..
A series RL circuit is built with 110 2 resistor and a 5.0-cm-long, 1.0-cm-diameter solenoid with 800 turns of wire. What is the peak magnetic flux through the solenoid if the circuit is driven by a 20 V, 5.0 kHz source? ΕΧΕΙ ΑΣΦ VAΣ ? mWb
Please answer it within 30 minutes. I will upvote!
0.2 H inductor and 146 ohm resistor are connected to a 12V battery. When will the current will reach 84% of its final value ??
....
A battery is used to charge a capacitor. When the stored energy in the capacitor is 1 µj, it is disconnected from the battery in the circuit and connected in series with an inductor which has inductance of 6 µH. What is the current in the inductor when the capacitor charge is half of its initial maximum value? (Resistance is negligible.) O 0.2 A O 0.5 A O v2 A O 2 A O 20 A
A loop of wire has a self-inductance of 5.5 mH. You pass a current of 9.0 Amps though the loop, and then drop the current to 0 at a contastant rate over 3.5 seconds. What is the EMF generated?
An electric current contains a battery that produces a voltage of 60 voltsV , a resistor with a resistance of 13 ohms, and inductor with an inductance of 5 henrys H  . Using calculus, it can be shown that I I t    (in amperes, A), when t seconds after the switch is closed is 13 5 60 1 13 t I e          1.4.1 Use this equation to express the time t as function of the currentI 
An inductance L, a capacitance C, and a resistance R are connected in series with a voltage source V(t). Given that q(0) i(0) 0, what is the second order differential equation whose solution is the current i(t) where t> 0? a. L+ IR + = 0 b. L+ iR + = v(t) +R d. e. None of the above
Two coils are placed close together in a physics lab to demonstrate Faraday's law of induction. A current of 7.00 A in one is switched off in 1.30 ms, inducing a 3.00 V emf in the other. What is their mutual inductance (in mH)?
198.914 b) Suppose this solenoid is connected to an AC circuit inside a physics laboratory. If the length of the solenoid is I = 63 cand the diameter is d-14 cm calculate its self inductance I Self inductance, L Ce you 4.8235e-4 to the the sig igit 4.8235 x 104