A 2.2 Henry inductor and a 177Ω resistor are connected in series with a 24V battery. A long time later the battery is removed from the circuit and replaced with a conducting wire so the inductor is in series with the resistor. After 10.716 ms have gone by what is the magnitude of the current through the resistor in mA?
Q: A 7.50 nF capacitor is charged to 12.0 V, then disconnectedfrom the power supply and connected in…
A: The charge on a capacitor is given by, Q = CV where, C is the capacitance of the capacitor, and V is…
Q: When the switch S is toggled to the left, the capacitor C charges through the resistor R. When the…
A: Resistor used for charging VC=ε1-e-tRCR=-tCln1-VCε=-1.30 s8.50 μFln1-755 V1260 V1 μF10-6 F=1.67×105…
Q: 16 0 20 N 8 Ω Consider the shown DC circuit. The current in the 82 resistor is 0.7 A going to the…
A: Given data The current from the 8 Ω Resistor is given as i8 = 0.7 A. The net resistance in the upper…
Q: the battery immediately after the switch is closed and through the battery a long time after the…
A:
Q: The figure below shows a capacitor, with capacitance C = 20.0 µF, and a resistor, with resistance R…
A: C = 20μFR = 75k.ohm = 75000 ohm E = 21 volts
Q: ww 22. 3R R ٤٠ DC Circuit In this circuit R = 10.0 and ε = 5.0 V. a. What current flows through the…
A:
Q: A 2.4 Henry inductor and a 187Ω resistor are connected in series with a 24V battery. A long time…
A:
Q: A C, A QUESTION 30 In the figure, R=10.0 k2; R₂ = 15.0 k2;C= 0.400 μF; e = 20.0 V. First, the switch…
A: Given:- R1 = 10 kΩ and R2= 15 kΩ C = 0.40μF ε=20 V The circuit as First, the switch is closed for…
Q: a. What is the voltage output (in V) of a transformer used for rechargeable flashlight batteries, if…
A:
Q: For the circuit shown in the figure, the inductors have no appreciable resistance and the switch has…
A: Step 1:
Q: Consider a 27.5 mH inductor that has a resistance of 4.25 Ω. a) What is the time constant, τ, of…
A:
Q: An inductor that has an inductance of 15.0 H and a resistance of 30.0 Q is connected across a 100-V…
A: An RL circuit is made by connecting a resistor and an inductor in series or in parallel. The…
Q: The switch in the circuit shown in the figure has been open for a long time. The resistors in the…
A:
Q: A wire 2 m long moves perpendicular through a 0.08 I field at a speed of 7 m/s. What EMF is induced?…
A: Given: l=2mB=0.08Tv=7m/sR=0.50ΩUsing:Emf:ξ=BlvI=ξR
Q: A circuit consists of a battery and a resistor R1 (unknown) and has a current I, (also unknown).…
A: The initial circuit consists of a single battery, connected with a single resistor R1. A current I1…
Q: A circuit consists of a large electromagnet that has an inductance of 48.0 H and a resistance of…
A: Inductance (L) = 48 H Resistance (R) = 7.9 ohm Vb = 250 V Maximum current (Im) = VbR= 2507.9= 31.645…
Q: A circuit consists of a 0.8 H inductor and a 3.5 ohm resistor. At t = 0 the current through the…
A:
Q: Consider a 23 mH inductor that has a resistance of 4.15 Ω. Time constant is 0.00554. If the…
A: Given that L=23 mH R=4.15Ω Time constant τ=0.00554 s
Q: A transformer is used to charge a cell phone. The number of turns on the primary coil is 600. The…
A: Given data: Number of turns of primary coil is, Np=600. Magnitude of input voltage is, Vp=120 V.…
Q: E2 E1 R2 R1 2. Find the charge on the capacitor after the switch has been left open for some time,…
A:
Q: A moving coil ammeter gives a full scale deflection for a current i = 60 mA and its coil has a…
A: Current for full scale deflection of a moving coil ammeter (i) = 60mA Resistance of coil (Rc) = 0.5…
Q: The capacitor in the circuit shown below is initially uncharged. The switch is closed at t = 0 s.…
A: The objective of the question is to find the current in the circuit at a specific time after the…
Q: d , P 3,
A: Given, The voltage, ε=9.6V Resistance, R=2100Ω The radius of a circular plate, a=0.95m The gap…
Q: Consider a transformer, used to recharge rechargeable flashlight batteries, that has 500 turns in…
A:
Q: A 2.20 mF capacitor initially has charge 4.20 mC. You connect it in series with a 4.00 MΩ resistor…
A: Given C=2.20mF=2.20x10-3F qo=4.20mC=4 20x10-3C R=4.00MΩ=4.00x106Ω At t=0 switch is closed.
Q: Consider a circuit with a power source that provides a sinusoidal (A/C) voltage. When the switch is…
A:
Q: A 5-µF capacitor is charged to 30 V and is then connected in series with a 10-µH inductor and a 50-Ω…
A:
Q: The figure shows an ideal battery of voltage V, a resistor of resistance R = 12.0 2, and an…
A: Given: R=12ohm C=3.5mu.F To find: Current through the resistor at time t after the switch S is…
Q: R1 R2 3. Given that the battery has a potential of 12V, resistors R1 = 1N and R2 = 32, and…
A:
Q: 6.54 H inductor and a 85.4 ohm resistor are connected in series and the circuit is connected to a…
A: Inductance, L = 6.54 H Resistance, R = 85.4 ohm Voltage, V = 14.8 V Time, t = 2.65 ms = 0.00265 s
Q: V 25. In the circuit of Figure P27.25, the switch S has been open for a long time. It is then…
A: a Time constant before switch is closed,Resistance R1 and R2 are in…
A 2.2 Henry inductor and a 177Ω resistor are connected in series with a 24V battery. A long time later the battery is removed from the circuit and replaced with a conducting wire so the inductor is in series with the resistor. After 10.716 ms have gone by what is the magnitude of the current through the resistor in mA?
Step by step
Solved in 3 steps
- The figure below shows a simplified model of a cardiac defibrillator, a device used to resuscitate patients in ventricular fibrillation. S R Rorso + When the switch S is toggled to the left, the capacitor C charges through the resistor R. When the switch is toggled to the right, the capacitor discharges current through the patient's torso, modeled as the resistor Rorso allowing the heart's normal rhythm to be reestablished. HINT The voltage across a charging capacitor is AV = E(1 - e-t/(RC)) and the voltage across a discharging capacitor is AV = AV maxe-t(RC) Click the hint button again to remove this hint. (a) If the capacitor is initially uncharged with C = 8.25 µF and Ɛ = 1270 V, find the value of R (in ohms) required to charge the capacitor to a voltage of 795 V in 1.20 s. (b) If the capacitor is then discharged across the patient's torso with Rorso = 1240 0, calculate the voltage (in V) across the capacitor after 4.50 ms. VA large power plant generates electricity at 12.0 kV. Its old transformer once converted the voltage to 330 kV. The secondary of this transformer is being replaced so that its output can be 775 kV for more efficient cross-country transmission on upgraded transmission lines. If the power output is 1,000 MW and line resistance is 2.3O N, what are the old and new line power losses (in MW)? old line losses MW new line losses MWA resistor and an inductor are connected in series to a battery with emf 240 V and negligible internal resistance. The circuit is completed at time t = 0. At a later time t = T the current is 5.00 A and is increasing at a rate of 20.0 A>s. After a long time the current in the circuit is 15.0 A. What is the value of T, the time when the current is 5.00 A?
- Consider the RL circuit in the figure with R=10.00 Ω, L1=1.80 H, L2=3.90 H, and V=5.0 V. At time t=0, the switch is closed to connect the circuit to a constant emf. How long (in seconds) does it take for the current to reach a value of Imax/2.71828 of its maximum value, where Imax is the maximum current through the circuit?A circuit consists of a large electromagnet that has an inductance of 48.0 H and a resistance of 7.90 Ω, a dc 250 V power source, and an open switch - all connected in series. How long after the switch is closed is the current equal to 28.5 A?Part (a) What is the magnitude, in amperes, of the current induced in the loop at t = 1.0 ms? I1 = ______ A Part (b) What is the magnitude, in amperes, of the current induced in the loop at t = 20.0 ms? I2 = ______ A
- To get the maximum current, the connection should be in parallel. If you create a parallel connection with 30V DC source and three resistors with R1 = 50Ω, R2 = 75Ω, and R3 = 100Ω, how do you calculate for the total current (IT) and the current flowing in each resistor (I1, I2, I3), and the total voltage (VT) and the voltage across each resistor (V1, V2, V3)? How do you also determine the power dissipated by each resistor (P1, P2, P3) and by the whole circuit (PT)??An array of solar panels produces 8.65 A of direct current at a potential difference of 148 V. The current flows into an inverter that produces 60-Hz alternating current with Vmax = 84.8 V and Imax = 14.7 A. What is the power efficiency of the converter? O 48.7% O 97.4% O 68.9% O 205%The magentic field through a single loop of wire 16.0 cm in radius and of 8.5 ohm resistance changes with time as shown in the figure. Calculate the emf in the loop as a function of time. What is the emf at t=5.0 s? What is the current at t= 1.0 s?
- A0.2 H inductor and a 146 Ohm resistor are connected to a 12 V battery. After how much time will the current reach 84% of its final value?A circuit consists of a 0.80 H inductor and a 3.5 ohm resistor. At t = 0 the current through the inductor is 1.2 A. At what time is the current through the inductor equal to 0.40 A?A 1.61 H inductor and a 19.8 ohm resistor are connected in series and the circuit is connected to a 11.5 V battery. After the current stabilizes and is current, the battery is disconnected and bypassed to allow the circuit to discharge. What is the current in the circuit 122 ms after disconnecting the circuit from the battery?