A resistor and an inductor are connected in series to a battery with emf 240 V and negligible internal resistance. The circuit is completed at time t = 0. At a later time t = T the current is 5.00 A and is increasing at a rate of 20.0 A>s. After a long time the current in the circuit is 15.0 A. What is the value of T, the time when the current is 5.00 A?

A resistor and an inductor are connected in series to a battery with emf 240 V and negligible internal resistance. The circuit is completed at time t = 0. At a later time t = T the current is 5.00 A and is increasing at a rate of 20.0 A>s. After a long time the current in the circuit is 15.0 A. What is the value of T, the time when the current is 5.00 A?

Similar questions

Two circuits contain an emf produced by a moving metal rod, like that shown in the drawing. The speed of the rod is the same in each circuit, but the bulb in circuit 1 has one-half the resistance of the bulb in circuit 2. The circuits are otherwise identical. The resistance of the light bulb in circuit 1 is 40 02, and that in circuit 2 is 80 Q. Determine (a) the ratio 3₁/32 of the emfs and (b) the ratio 1₁/12 of the currents in the circuits. (c) If the speed of the rod in circuit 1 were twice that in circuit 2, what would be the ratio P₁/P2 of the powers in the circuits? (a) 1/2= Number i (b) 1₁1/12 = Number i (c) P₁/P₂= Number i X X X X X X X xLx X Units Units X Units X X x Conducting rail X X X X x x
A 1.61 H inductor and a 19.8 ohm resistor are connected in series and the circuit is connected to a 11.5 V battery. After the current stabilizes and is current, the battery is disconnected and bypassed to allow the circuit to discharge. What is the current in the circuit 122 ms after disconnecting the circuit from the battery?
An Alternating Current (AC) circuit has frequency v = 60 Hz. In such circuit there are 3 elements. The first one is a long thin solenoid with 4 × 104 turns/m, length of 10.0 cm and a cross-sectional area of 20.0 cm². The second one is a resistor with resistance R = 10.02. The third one is a parallel-plate capacitor is composed of two circular plates with radius 10.0 cmseparated by a gap of 0.05 mm. a) Calculate the angular frequency, w, of the circuit. b) Calculate the self inductance of such inductor and the inductive reactance. c) Calculate the capacitance of such device and the capacitive reactance. d) Draw the following functions on the same graph. Represent them as closely as possible to reality using the values you calculated so far. Use the graph on the back. IR cos (@t) VR IXL COS (@t+. VL = IXL COS VC = IXc cos wt- - - 元|2 元|2
The first question has been answered.
esc 7 The I vs t graph shown below is for an LR circuit without a battery. I(A) 4 3. 2 1. 2 2 F2 3 4 #3 80 F3 5 t(s) Determine the time constant of the LR circuit. T = If L=6 H, determine R. R = 2 a S4 4 45 MacBook Air A 6 4
What is the steady state value of the magnetic energy stored in the inductor?
A circuit contains a 9 V battery, a 5 MΩ resistor, a 10 H inductor, and a switch. When the switch is closed, what isthe current in the circuit after 1 μsec?
A loop of wire has a self-inductance of 5.5 mH. You pass a current of 9.0 Amps though the loop, and then drop the current to 0 at a contastant rate over 3.5 seconds. What is the EMF generated?
Consider the circuit depicted in the diagram. a.Write the equation that results from applying the loop rule to loop akledcba. b. If the current I2 going through the center of the loop is 55 A, what is the current I1, in amps?
Where a 44 V battery is connected to three resistors and an inductor with values R1 = 96 Ω, R2 = 24 Ω, R3 = 40 Ω, and L = 16 H. The switch has been OPEN for a LONG TIME. IMMEDIATELY AFTER we CLOSE the switch, what is the current in R3? 0.743 A 0.324 A 0.000 A 1.100 A
The leads of an alternate current generator with peak voltage AVmax = 100.0V are placed across a 10.02 resistor. What is the average power dissipated by the resistor? 2.00 kW 0.150 kW 0.0500 kW 0.100 kW 1.00 kW 0.500 kW