One conductor of a three-phase line is open. The current flowing to the 4-connected load throughreference and assuming that line c is open:00The magnitude of the zero sequence current in phase a (I) in A is:SparkSelect one:O A 10O B. 17,3O C. 30O D. 0

Let Ia , Ib and Ic are the line currents flowing through the load and I0 is the zero-sequence…

One conductor of a three-phase line is open. The current flowing to the A-connected load through reference and assuming that line c is open: The magnitude of the zero sequence current in phase a (I) in A is: Spark Select one: OA 10 OB. 17,3 OC.30 O D.0

One conductor of a three-phase line is open. The current flowing to the A-connected load through reference and assuming that line c is open: The magnitude of the zero sequence current in phase a (I) in A is: Spark Select one: OA 10 OB. 17,3 OC.30 O D.0

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: A single phase circuit with a given load 3 ohm resistance and inductive reactance of 4 ohms as…

A: The question is about active power, reactive power and apparent power, power factor.

Q: Determine the Branch Currents using Kirchhoff’s Laws: a.) Branch bd b.) Branch cd c.) Branch ca

A: Assigning current to the three different loops as shown in the figure- Applying KVL to each loop,…

Q: Two magnetically-connected circuits have the following characteristics: • A series-opposing…

A: Transformer coils with series opposing. primary winding reactance =jXL1 = j 8 ohm secondary winding…

Q: TWO transformers A and B are connected in parallel to a load of (2+j1.5) ohm. Their impedances in…

Q: ww v, 202 152 ww 302 50 mH

Q: Four conductors meet at a junction. the current are i1= 5sinwt, i2= 3sin(wt + 90) and i3=…

A: The solution can be achieved as follows.

Q: Voltage

Q: Two single phase generators operating in parallel have no-loads emfs of E₁ = 24020° V and E₂ =…

Q: In the system shown in Figure 1, the transformers are connected star-star with both star points…

A: It is given that: MVAbase=15XT1=XT2=XT3=0.04 pu

Q: UIN: 14V = 6A in the direction shown. choice of node or loop I = 6A R=20 R= 1O 1ER, = 10 R- 10 R- 20…

Q: Two reverse parallel scr are used to control the voltage on a 10 ohm load over a 230V, 50HZ 1- phase…

Q: A single phase 120V AC sourc controls power to a resistve load 202 using integral cycle control. a)…

A: Note: As per our policy, I have attempted the first three subquestions. Given data: The source…

Q: A 20 Ohm resistor is in series with a 30 Ohm Inductive reactance. If they are connected to a 40 Volt…

A: In this question, we need to determine the angle between phase voltage and voltage across inductive…

Q: What are FACTS (Flexible Alternating Current Transmission Systems), and how do they improve the…

A: Flexible Alternating Current Transmission Systems (FACTS) are a set of advanced power electronics…

Q: Describe the concept of three-phase power in electrical systems and its advantages over single-phase…

A: In this question, we need to describe the concept of three phase power in electrical system and also…

Q: 50. A series resistance-capacitance (R-C) circuit is connected to 230-volt, 50 cycle AC source. The…

Q: Define three cases on which real and reactive power flow gets affected. Draw the phasor diagrams of…

A: The three cases on which real and reactive power flow gets affected are as following, CASE-1 When…

Q: 8- A 1-phase transformer, 15 kVA, 660/250V, 50HZ, Regi= 2.7879N and Xeg1 = 5.57579 the secondary…

A: Solution- Up regulation =VNL-VFLVFL VNL = No load voltage VFL = Full load voltage Transformer…

Q: Connect three single-phase transformers in Y-Y, with subtractive polarity, so that the line-to-line…

A: Given: Connect three single-phase transformers in Y-Y, with subtractive polarity, so that the…

Q: Three loads are connected in parallel across a 1400-V rms, 60-Hz single-phase supply as shown in…

A: Given circuit is,Asked to find,Total Active, reactive and apparent power, supply power…

Q: High-voltage transmission with lower power losses is possible with A. alternating current B. cross…

A: Given: High voltage transmission

Q: An RLC series circuit connected to a 110 – volt and 50 – cycle AC source, contains the following…

A: In this question, A RLC circuit connect with 110V , 50Hz battery. Find the all data as per given…

Q: Calculate the value of the impedance seen by the source if the step-down transformer turns ratio a;…

Q: What can you say about the flow of power as a function of time between a balanced three-phase source…

A: Concept: A definition of a function is that a relation from a set of inputs to a set of possible…

Q: 8. The two winding transformer and the autotransformer of the circuit shown in Figur Determine the…

A: given transformer and autotransformer

Q: A three-phase transformer bank is connected wye–delta. The primary voltage is 12,470 V, and the…

A: Yes, it is possible to connect the two remaining transformers in the open delta configuration in…

Q: onsider a three winding transformer with the following particulars: = 50-40° A. Assume that V₂ is 1=…

A: Solution- THREE WINDING TRANSFORMER Given, Z1=Z2=Z3 = 0.02+j0.08 ohmV2 = 400 VI2 = 60∠-30° AI3…

Q: 7. Three load units A, B, and Care connected in parallel and take currents that are respectively 11…

Q: a. As an electrical engineer, explain about the power system in Figure Q2 with respect to the…

Q: Two 7970-V:230-V single-phase transformers with impedance with respect to their secondaries of 1.5 +…

Q: (b) A symmetrical three-wire three-phase supply as shown in Figure Q2(b) is connected to a balanced…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: One advantages of load balancing is that each phase conductor carries the ? current value

A: We need to tell about advantage load balancing is that each phase conductor carries the equal…

Q: Two 7970-V:230-V single-phase transformers with impedance with respect to their secondaries of 1.5…

A: Primary Voltage = 7900VSecondary Voltage = 7970 VLoad Impedence = 30+j40 ohms1st transformer…

Q: Two power system areas operating at a nominal frequency of 60 Hz are connected with a tie line, and…

Q: Three load units A, B and C are connected in parallel and take currents that are respectively 12, 10…

A: In this question, 3 loads are connected in parallel then find the total current IT ? If Three…

Q: The three phases of a generator can be connected in either delia (D) or wye (Y) connection. List two…

A: Advantages of three-phase system over a single-phase system: Greater power output: A three-phase…

Q: A source of AC emf E₁ = 120/30º volts with an impedance of Z₁ = 2/0° ohms is connected in parallel…

A: In this question we will find load current for parallel connected AC source....

Q: A source of AC emf E₁ = 100/0º volts with an impedance of Z₁ = 20/0° ohms is connected in parallel…

A: In this question we will find current through load impedance for two parallel connected source....

Q: current - 1=?, and the power factor - cosp =?. 4. An out of balance three phase star connected load…

A: In this question we need to find a RMS current through neutral .

Q: 150 kVA, 2800-240 V, 50 Hz transformer. Regis = 0.0082N , Xeq.Ls = 0.0223N Step down transformer…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: Consider the three single-phase two-winding transformers shown in Figure. 3. The high-voltage…

Q: Three single phase transformers each having a 240 V primary and two 250 V secondaries, as shown in…

A: The primary voltage of the single-phase transformer is 240 V and the secondary voltage is 250 V.…

Q: If a 3-phase short circuit occurs at the terminals of an alternator, the current in the armature…

Concept explainers

Single Phase AC Circuit

Alternating Current (AC) is a type of electric power in which the electric current changes, both in magnitude and direction, at regular intervals. This AC Circuits can deliver power in either a Single Phase system or a Three Phase system.

Question

One conductor of a three-phase line is open. The current flowing to the 4-connected load through
reference and assuming that line c is open:
00
The magnitude of the zero sequence current in phase a (I) in A is:
Spark
Select one:
O A 10
O B. 17,3
O C. 30
O D. 0

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Analysis of Single Phase and Three Phase System

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

2. A single-phase are distributor AB is fed from end A and has a total impedance of (0.3-0.3) ohm. At the far end, the voltage V-240V and the current is 100A at a p.f. of 0, 8 lagging. At the mid-point M. a current of 100 A is tapped at a p... of 0.6 lagging with reference to the voltage V_{M} at the midi-point. Calculate the supply voltage V Lambda j sending current I_{N} and the phase angle between V_{A} and V_{E}
A d.c. serier generator, having an external characteristic which is a straight line through zero to 50 V 200 A is connected as a booster between a station bus bar and a feeder of 0.3 ohm resistane. Calculate the voltage difference between the station bus-bar and the far end of the feeder qa current of (i) 200 A and (ii) 50 A.
If the line-to-line primary voltage and line current is 1.0 at 0 degrees, what is the secondary line- to-line voltage for the following three-phase transformers? Assume a turns ratio of N = 10. Express answer in polar form. a. Delta-to-Delta: b. Delta-to-Wye: c. Wye-to-Delta: d. Wye-to-Wye:
If the load is connected to the generator thgrough an inductive line and the voltage at the load side is the same as the voltage at the terminals of the generator, which of the following must be true? O A. The reactive power is flowing from the generator to the load and from load to the generator at the same time. O B. The load is disconnected, and no power is delivered to the load. O C. The load has a poor power factor and it's absorbing too much reactive power. O D. None of the other choices are correct O E. The generator is unable to produce reactive power; therefore, the reactive power is flowing from the load to the generator.
60. An RLC series circuit connected to a 110-volt and 50-cycle AC source, contains the following series resistances and reactances: R1=10 ohm, R2= 15, XL1=20 ohms, XL2=25 ohms, XC= 40 ohms. Find the real power. a. 65.3899 b. 392.4372 c. 397.848 d. 588.6559
X₂=0.1 1 XL +03 Soto X₁ = 0.2 X = 0.1 X = 0.1 Above is the one-line diagram of a simple power system. Each generator is represented by an emf behind the subtransient reactance. All impedances are expressed in per unit on a common base. All resistances and shunt capacitance are neglected. The generators are operating on no load at their rated voltage with their emfs in phase. A symmetrical fault occurs at bus 1 through a fault impedance Z, =j0.08 per unit. a) Using Thevenin's Theorem, determine the impedance to the point of fault and the fault current in per unit. b) Find the bus voltages and line currents during the fault. 2 O oto
Describe the concept of three-phase power in electrical systems and its significance in power distribution.
a single-phase transformer serves a 7.2kw resistive loadlocated 200 ft from the transformer. each conductor from the transformer to load has an impedence of (0.78+j0.052) ohms per 1000ft. if the voltage at the load terminal is 240v, the magnitude of the voltage (v) at the transformer secondary is most nearly:
What is the colour of neutral conductor in single -phase a.c. supply, a. Orange O b. Red O c. Black O d. Green
Two power system areas operating at a nominal frequency of 60 Hz are connected with a tie line, and have the following characteristics: Area 1: R1 = 0.01 pu and D1 = 0.8 pu on a base of 1200 MVA Area 2: R2 = 0.02 pu and D2 = 1 pu on a base of 600 MVA The power flow direction on the tie line is from Area 1 to Area 2. Using a common base of 1000 MVA, what is the change in prime mover power (in MW) in Area 2 (APmech2) for a load increase of 125 MW in Area 1?
8. The two winding transformer and the autotransformer of the circuit shown in Figure are ideal. Determine the conducting and transformed currents of auto transformer. N1=200 NBC=20 N2=100 NBA=30 10A B 200 V 50,Hz C N1: N2
8. The two winding transformer and the autotransformer of the circuit shown in Figure are ideal. Determine the conducting and transformed currents of auto transformer. N1=200 NBC=20 N2=100 NBA=30 10A B 200 V 50,Hz N1 : N2 lellll