Two magnetically-connected circuits have the following characteristics: • A series-opposing connection of coils (dot convention). The primary side is connected to a voltage source that has a magnitude of 230 V and a phase angle of 45 degrees. The primary-side inductive reactance is jXL1-j8 Ohm. • The secondary side is connected to a resistive load of 10 Ohm. . The secondary side inductive reactance is jXL1 =j5 Ohm. . The mutual inductive reactance is jM=jl Ohm. The magnitude of the voltage across the resistive load is:

Two magnetically-connected circuits have the following characteristics: • A series-opposing connection of coils (dot convention). The primary side is connected to a voltage source that has a magnitude of 230 V and a phase angle of 45 degrees. The primary-side inductive reactance is jXL1-j8 Ohm. • The secondary side is connected to a resistive load of 10 Ohm. . The secondary side inductive reactance is jXL1 =j5 Ohm. . The mutual inductive reactance is jM=jl Ohm. The magnitude of the voltage across the resistive load is:

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Three load units A, B and C are connected in parallel and take currents that are respectively 12, 10 and 15 amperes. Assuming IA to be the reference phasor, IB leads IA by 30°, and IC lags IA by 65°, calculate the total current and the angle it makes with the reference.
19. How many degrees are the current and voltage out of phase with each other in a pure inductive circuit?
Find the average and rms value of the waveform shown in Figure-2. Em 3x ot- Figure-2
4. An alternating current varying sinusoidally with a frequency of 50 Hz has an ms value of 40 A. Find: a. The instantaneous value of 0.0025 seconds after passing through maximum positive value, b. The time measured from the maximum value when the instantaneous current is 14.14 A.
To find: The loop currents using elimination & substitution methods
The circuit shows an unbalanced electrical installation powered by a positive sequence symmetrical three- phase network of 380 V compound voltage. The loads are single phase. Load 1 absorbs an active power of 950 W with f.d.p. 0.5 inductive. Load 2 absorbs an active power of 1,140 W with f.d.p. Unit. Load 3 absorbs from the network an active power of 760 W with f.d.p. 0.5 capacitive. Taking the network voltage URN as the phase reference, calculate: a) complex expressions of the line currents IR. Is. and IT RO- SO- To- : IR Is IT UL-380 V CARGA 1 P₁ = 950 W cos p1=0,5 ind. CARGA 2 P₂=1.140 W cos p₂=1 CARGA 3 P3=760 W cos p3=0,5 cap.
I need the answer as soon as possible
(4) For f = 60 Hz, V=120 v-rms and number of turns N = 500. Find rms flux linkages of the coil. (a) 5.3222x10 Wb (b) 4.2824x10 Wb (c) 6.3662x10 Wb (d) 7.3552x10 W b
Design a circuit limit a 25 V rms sinusoidal voltage to a maximum positive amplitude of 18 V of using 12 V dc source.
Please show your detailed solution
The circuit shows an unbalanced electrical installation powered by a positive sequence symmetrical three- phase network of 380 V compound voltage. The loads are single phase. Load 1 absorbs an active power of 950 W with f.d.p. 0.5 inductive. Load 2 absorbs an active power of 1,140 W with f.d.p. Unit. Load 3 absorbs from the network an active power of 760 W with f.d.p. 0.5 capacitive. Taking the network voltage URN as the phase reference, calculate: a) complex expressions of the line currents IR. Is. and IT RO- SO TO IR Is IT U₁-380 V CARGA 1 P₁ =950 W cos p1=0,5 ind. CARGA 2 P₂=1.140 W cos p₂=1 CARGA 3 P3=760 W cos p3=0,5 cap.
Need asap