Nitrogen from a gaseous phase is to be diffused into pure iron at 700 degrees Celsius. If the surface concentration is maintained at 0.1 wt% N, what will be the concentration 1mm from the surface after 10 hours? The diffusion coefficient for nitrogen in iron at 700 degrees Celsius is 2.5x10^-11 m^2/s

Q: In an open vessel with a diameter of 0.3 m, there is water that evaporates into the atmosphere at…

A: Given = Diameter = 0.3 mT = 350Kx = 1 mmheight = 5 cmPAo = 41.8 kN/m2 (350 K)PT = 101.3 kN/m2DAB =…

Q: 27.12 We are interested in the diffusion of CO₂ gas out of a randomly porous adsorbent material slab…

A: Let, the carbon dioxide (CO2) and air be denoted by species A and B respectively. the unaccomplished…

Q: For the carburizing process of the titanium plate, the temperature of which needs to be heated to a…

A: To determine the below conditions, we will use the error function. This is denoted by "erf". This is…

Q: A gas mixture containing nitrogen is refractory with an inner radius (R1) of 4 cm and an outer…

A: The diffusivity of Nitrogen gas = 2×10-4m2/s radius of the inner radius of the shell R1 = 4cm The…

Q: A situation arises where steady state equimolar counter diffusion is occurring in a section of…

A: The molecular diffusivity of the given system for equimolar counter diffusion is to be calculated.

Q: Identity of the salt: NaCl a. Mass of salt [g] b. Molar Mass of salt [g/mol] c. Moles of salt [mol]…

A: (a) Change in temperature =? For trial 1, the initial temperature is Ti = 20.9oC, and the final…

Q: 5) A test tube contains 10 cm of salt water having density 1.01 g/cm^3 and 10 cm of fresh water is…

A: To estimate the time it will take for the fluid in the test tube to reach nearly uniform salinity…

Q: A dilute solution of solute A in solvent B is passed through a tubular-membrane separator, where the…

A:

Q: Estimate the liquid phase diffusion coefficient for the following systems at 25oC: 1. Toluene in…

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part…

Q: Knowing that the diameter of the NO gas molecule is 459 pm, determine the viscosity and the…

A:

Q: Q3: A plate of iron is exposed to a carburizing (carbon-rich) atmosphere on one side and a…

A:

Q: Hydrogen in solution in a thick slab of nickel is removed by subjecting one face of the slab to a…

A: Given, The diffusion coefficient of hydrogen in nickel is DH = 7.77×10-7exp-41200RT m2/s   The…

Q: Vapour and the partial press. of water is 0.8 atm. Derive the equation for this case and calculate…

A: Given T=303 K P=1 atm l=0.02 m KG=3.425 x 10-2 kmolm2 s press PA1 =0.8 atm  PA2=0 PB1=0.2 atm  PB2=1…

Q: 23.) Nitrogen gas concentration across a 2 mm thick palladium sheet changes by 4 kg/m°. Considering…

A: Given data: Thickness of palladium sheet = 2 mm Concentration change of N2 gas across the palladium…

Q: A quiescent body of water has a depth of 600 mm. The DO level at the bottom after 16 days is 3.5…

A: The DO of the water body is to be determined.

Q: The effective use of a drug is achieved by its controlled release, and film-coated  pellets,…

A: Given: The effective use of a drug is achieved by its controlled release, and film-coated  pellets,…

Q: EMD in a Tube.Two bulbs are connected by a straight tube, 0.001 m in diameter and 0.15 m in length.…

A: (a) The rates and directions of the mass transfer are to be calculated.   The given question…

Q: A narrow cylindrical tank of 1 m length up to 0.96 m depth of organic liquid (MA=46 kg/kmol) filled…

A: As given  cylindrical tank of 1 m length Molecular diffusion coefficient in air at 25 °C and 1 bar…

Q: One surface of a 285 K and 2.0 mm thick urea (A) - ethanol (B) solution, an organic liquid is in…

A: Temperature = 285 K Thickness of film = 2 mm Concentration of urea in ethanol = 3 % by weight…

Q: Compare the diffusion coefficients of carbon in BCC and FCC iron at the allotropic transformation…

A: a)diffusion coefficients of carbon in BCC and FCC iron at the allotropic transformation temperature…

Q: A membrane can separate gas mixture because different gases have different permeability through the…

A: The mixture of gases can be separated by separation membrane on the basis of different permeability…

Q: Estimate the diffusion coefficient for methyl phenyl sulfide in water at 25°C.

A: As per the question given , The temperature of the methyl phenyl sulphide is 25 degc = 298 K We need…

Q: As part of a process to fabricate materials with ordered pore arrays, the diffusion‐limited solvent…

A: No of cylindrical pores = 16 Diameter of each pore = 0.1 cm Depth of each pore = 0.5 cm Maximum…

Q: rate of acetic acid (A) diffusion

A:

Q: Consider the device shown below that will be used to humidity an air stream. In the current process,…

A: Temperature of the system, T = 40°C = 313 K The pressure of the system, P = 1.0 atm Species A is…

Q: A block of unknown metal has the following dimensions: 1cm× 1cm×3cm. The block's mass is 27g. What…

A: Since density is defined as the mass contained per unit volume

Q: A plate of BCC iron is exposed to a carburizing (i.e, carbon-rich atmosphere) on one side and a…

A: Given: Temperature = 700°C=700+273K=973K position 1(z1)=2mm=2mm×m1000mm=0.002m position…

Q: Which of the following is the time required for the evaporation of 5 grams of 15 grams of spherical…

A: Naphthalene ball is evaporated into still air.

Q: Linear Growth Regime B X =1 A Diffusion-limited Regime X = VB 1 Oxidation Time Figure 1 Comment the…

A: The diffusion of gas molecules (oxygen or water) through any oxide film is analyzed with the help of…

Q: consider diffusion of a drug across a two-layer membrane mounted in between two compartments (donor…

A: To calculate the flux of the drug from the donor to the receiver chamber, we can use Fick's first…

Q: Q06/ At one point in a sample rectifying column, the vapor contains 70% (by mole) benzene and…

A: Assuming that the latent heats are equal for both the components and that there is no heat loss, no…

Q: Carbon is diffused on the surface of a steel plate by carburization heat treatment. Steel contains…

A: Given data: Steel contains 0.20% carbon carburization process is applied at 1000oC in methane gas…

Q: A wet cake of solids has a thickness of 0.8 cm is dried by blowing air with a moisture content of 5…

A:

Q: As nitrogen 1s not used in the reaction, so nitrogen needs to be purged out

A: (a.) streams entering the reactors are fresh feed and the recycle stream. overall balance, reactor…

Q: Consider a mixture containing equal moles of He, O2, and CH4. Determine multicomponent diffusion…

A:

Q: Porous silica gel of 1.0 mm particle diameter, with a particle density of 1.13 g/cm3 , an inclusion…

A: Porous silica gel is used to adsorb the propane from helium by the adsorption separation operation.…

Q: ) To provide a diffusion barrier that prevents reactions between nickel and tantalum, a layer of…

A: Given data: Flux of nickel atoms = 1.574 × 1012 atoms/cm2.s Diffusivity of nickel ions in MgO= 4 ×…

Q: A cylindrical tube connects two large gas tanks (Tank-1 and 2). Both tanks contain mixture of carbon…

A: Given Data  The cylindrical tube connects two large tanks (Tank 1 and 2). The tanks contain CO2 and…

Q: A sheet of steel 1.5mm thick has nitrogen atmospheres on both sides and is permitted to achieve a…

A: Given that  thickness = 1.5 mm  DAB = 6.05 X 10-11m2s JA = 1.5 x 10-7kgm2sCA = 4.97CB = 2.5 kg/m3

Q: 6. Problem setups. Let's consider two cases of diffusion. On the left, we have cells embedded in a…

A: Given:Concentration of Oxygen

Q: Since a gas X diffuses 1.25 times faster than CO2(g), find the molecular weight of gas X and…

A:

Q: A steel machine part is to be carburized in a furnace. The steel initially has a carbon content of…

A: