Question 3It uses flame to atomize samples to detect traces of metals.Atomic AbsorptionO Plasma EmissionO UV-Vis SpectroscopyO Flame Emission

Atomic Absorption: The technique uses basically the principal that free atom(gas) generated in an…

Answered: It uses flame to atomize samples to…

It uses flame to atomize samples to detect traces of metals. Atomic Absorption Plasma Emission O UV-Vis Spectroscopy O Flame Emission

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter25: Instruments For Optical Spectrometry

Section: Chapter Questions

Problem 25.6QAP

See similar textbooks

Similar questions

1
What is single-crystal X-ray analysis ?
What is commonly determined using Atomic Spectroscopy? Bodn energy Elemental composition Concentration Structure
Explain how a scanning electron microscope (SEM) can be used in combination with an energy dispersive X-ray spectrometer (EDS) to perform elemental analysis on extremely small particles by placing the statements in the order that they occur.
Name: Intensity 80 1s 70 Peak X 8 7 Due: Wed., 3/1/23 Peak Y Page 2 / 9 40 Binding Energy (MJ/mol) D t 8 I 2 2. A sample containing atoms of C and F was analyzed using x-ray photoelectron spectroscopy. The portion of the spectrum showing the Is peaks for atoms of the two elements is shown above. Which of the following correctly identifies the 1s peak for the F atoms and provides an appropriate explanation? (A) Peak X, because F has a smaller first ionization energ than C has. (B) Peak X, because F has a greater nuclear charge than C has. (C) Peak Y, because F is more electronegative that C is. (D) Peak Y, because F has a smaller atomic radius that C has. + 0 AP Chemistry Sign out
Note: The Emission Intensity of the original solution is not given since the calibration method is standard addition.
What are the side effects of X-ray irradiation?
You have been asked to determine which heavy metals, if any are in a sample of sewage sludge. Why is atomic absorption spectroscopy not a good technique for the job and why is ICP- atomic emission spectroscopy a better choice?
A 0.1860 g rock sample containing an unknown amount of Ca was dissolved in HCI and diluted to 100.0 mL. Aliquots of 5.00 mL from this solution were added to different volumes of a 2.08 µg/mL. Ca standard solution and diluted to 200.0 mL. The emission intensity of these solutions was measured using atomic emission spectroscopy. The results are shown in the table. Unknown volume (mL) Standard volume (mL) Final volume (mL) Emission Intensity 0.00 200.0 5.00 200.0 10.00 200.0 15.00 200.0 20.00 200.0 Find the weight percent of Ca in the rock sample and its uncertainty using the method of standard additions. weight percent: 5.00 5.00 5.00 5.00 5.00 8.27 x10-5 Incorrect % Ca .03 Incorrect 227.0 413.0 637.0 831.01 1021.0
In El-MS, the presence of 2 elements in a molecule is plainly obvious due to A+2 peaks. a.) what are these two elements? b.) two other elements are obvious, just not as plainly. What are they?
Question 10 Which of the following statements is false about single beam absorption instruments? A Test tube is used as sample holder B) Tungsten bulb is used as a source Photovoltaic cell as detector Beam splitter is used to get parallel beam
True or False: Emission spectroscopy can be used toidentify the components of paint’s pigments