Answered: It is required to lay out an exact…

It is required to lay out an exact distance of 100m using 50m tape that is 0.02m too long compute the distance measured with the tape to make the points the proper distance apart.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: A line measured with a 50-m steel tape was recorded as 352.70 m. If the tape is 50.08 m long during…

Q: If the surveyor is at Point A, and recorded the location of Line AB to be 200 degrees 35 minutes in…

A: Given data Angle of line AB = θAB = 200°35' Angle of Line AC = θAC = 280°15' Length of line AB (LAB)…

Q: The latitude for the figure can be given as (0 = 50° 34¹) 0 245m 161.34m O 155.62 O 160.43m O 165m O…

Q: The distance between points is exactly 100 ft. This measurement is read correctly on steel surveyors…

A: To determine the actual distance for the measured distance. Given, Measured distance, say L =…

Q: A h = difference in height between A and B I= length of tape stretched from A to B 'B d = horizontal…

A: The given data is: Horizontal distance between A and B (d) = 80 m Vertical distance between A and B…

Q: A 50m tape that is 0.02m too short is used to measure distance AB. If the correct distance of AB is…

A: Given, True Length of the tape(L) = 50m Incorrect length of the tape(L1) = 50-0.02= 49.98 Correct…

Q: 1) 2 points B &C were observed from point A where the instrument was set up at a height of 1.25m.…

Q: The latitude for the figure can be given as (0 = 50° 34¹) 0 245m 161.34m O 155.62 O 160.43m O 165m O…

A: 155.62 is the correct answer.

Q: The measured slope distance of a line was 882.50 m. The following table shows the slopes for the…

A: It is required to determine the correction for slope. Here, a is the slope angle, and L is the…

Q: PROBLEM: A surveyor sets up a transit at point P which is located in the middle portion of a…

A: Given data shows the closed traverse of a four sided part of a land. It is asked to find the area of…

Q: 1. The length of line AB measured with a 50-m tape is 856.245 m. The tape used is found out to be…

Q: As per plan, the distance between two telephone poles is 2356.35 meters. If the location of one is…

A: Using tape length and slope correction formula

Q: Given are the interior angles of a heptagon. Determine the discrepancy for the givenobservation and…

Q: A distance between point (A) and (B) is (170m) was measured by a tape of (20m) length, the it was…

A: It is required to find the actual measured distance between A & B i.e (l) Given data, Correct or…

Q: An unknown line was paced by a surveyor and gathered the following data: 489, 482, 489, and 483. He…

A: Given: The paced data for the unknown line is 489, 482, 489, and 483. The distance of the new line…

Q: An offset is 15 m long and the scale of plotting is 1 cm 30 m. If the accuracy in linear measurement…

A: Solution:- We know that limiting error is:

Q: The length of a line AB measured with a 50-m tape is 364.85m. When the tape is compared with a…

Q: If the value of an angle of elevation is computed to be π/4 radians, determine the equivalent…

A: Given: value of angle of elevation = π4 radians i) to determine equivalent value in Degree: 1…

Q: Determine the correct length of a line 256.32 m long measured using a 50 m steel tape at30°C. The…

Q: A 100 – m tape weighing 6.08 kg was used to measure a line. It was supported at the end points,…

A: Solution:

Q: The observed lengths of the sides (in feet) of a five- sided closed polygon traverse are as follows:…

A: To compute the linear misclosure and the relative precision for the given five-sided closed polygon…

Q: Choose the letter of the answer. A line was measured and found out to be 512.21 m. it is then found…

Q: The latitude for the figure can be given as (0 = 50° 34') 0 245m 161.34m O 155.62 O 160.43m O 165m O…

A: Given data in question Length Angle To find out Latitude

Q: 3. What must be the actual measurement to a (GML) meters distance using L(10) meter tape that is…

Q: The distance between two points on a vertical photograph is ab and the corresponding ground distance…

A: Distance between two points on vertical photograph is ab. Corresponding distance on ground is AB.…

Q: .b\ In measuring a straight line, you come across: 1.a pond, 2. a tall building. Describe how you…

A: Obstruction while chaining and ranging

Q: he distance between two points is found to be 220.45 m using a 100 m tape that is found to be X…

A: l×L=L'×l'where,l=designated tape length,L=true length of line,L'=wrong length of line,l'=actual but…

Q: XI. Area by Simpson's Rule or Trapezoidal Rule Simpson's rule: The given below is a series of…

Q: A 100-meter tape weighing 5.08 kg was used to measure a line. It was supported at the end points,…

A: The measurements done with the chain and tape encounter any errors during the due course of the…

Q: 4. Using tape in measuring angles, the sides of a triangle measure 1063.55, 1752.77 and 1253.8 m.…

A: We are required to calculate the angles of the triangle.

Q: The true length of a line is known to be 200 m. When this is measured with a 20 m tape, the length…

A: True length of line L = 200 m Measured length L' = 200.80 m Actual length of tape AL = 20m It is…

Q: Compute the east coordinates of point Q in the below figure if you know the east coordinates of…

Q: A distance of 17.44 m is measured with a tape. During measurement, the other end was discovered to…

Q: The latitude for the figure can be given as (0 = 50° 34') 245m 161.34m O 155.62 160.43m 165m…

A: To find out the latitude of the given line.

Q: The correct distance between two point is 220.45m using a 100m tape that is x meter too long the…

A: Given: The correct length is 220.45 m. The length to be laid is 220.406 m. The length of the tape is…

Q: 1- The true and the nominal length of this tape if the standardization correction for 75 m distance…

A: Given data : n=5 Distance measured l'=350m

Q: Convert the following distances given in feet to meters: (a) 537.52 ft (b) 9364.87 ft

A: 1 feet=0.3048 meter537.52 feet=537.52X0.3048=163.836096 meters

Q: A line is laid out using a 50-m tape. The standard error of each tape length laid out is assumed to…

A: To Determine :- Question 1. The standard error of the length of the line. Question 2. The correct…

Q: The distance between two points on a vertical photograph is ab and the corresponding ground distance…

A: Distance between two points on vertical photograph is ab. Corresponding distance on ground is AB.…

Q: On a vertical photograph of flat terrain, the scaled distance between two points is ab. Find the…

A: Photo distance, ab = 1.66 in.Map distance AB = 4.56 in. Map scale Smap = 1:9600 We know that ,

Concept explainers

Methods of Surveying

Surveying is the practice to determine the relative three-dimensional positions of various points on the earth’s surface. This is done by computing the vertical and horizontal distances, angles between the points, collecting the observations, and plotting them on a map of any appropriate scale. Accuracy can be achieved by using the latest instruments like a theodolite, tachometer, etc. Leveling is a subdivision of surveying where the objective is to locate the elevation of objects considering a datum level.

Question

It is required to lay out an exact distance of 100m using 50m tape that is 0.02m too long compute the distance measured with the tape to make the points the proper distance apart.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Determine the correct length of a line 256.32 m long measured using a 50 m steel tape at 30°C. The steel tape was calibrated at 18°C.
A 50m tape was used to measure a line DE. The adjusted distance of line DE is 120.23m long. If the tape is 0.04 too short, what is the measure distance?
42. A 30-m steel tape is used to measure the distance of a line. The measured distance is 457.65 m. After the tape was calibrated, it was found that it is 16 mm too short. What is the correct length of the line? +8 8 A. 457.406 m C. 457.921 m D. 457.125 m B. 457.894 m
Surveying: Measurement of Horizontal Distances
C. Stadia Formula: D. D = (f/i)s + (f+c) Percentage Error: % Error Length Width observed value - actual value x 100 actual value COMPUTATIONS: SKETCH: Stadia Intercept 0.29 m 0.15 m Horizontal Distance Stadia Method Distance Tape Method Distance 28.8 m 15.08 m (Show computations on the computed horizontal distance using stadia formula and the percentage of error.) % Error (Draw a top view of a basketball court based on the data (taped distance) given data and don't forget to label its dimensions.)
I need the answer as soon as possible
Situation E. A 100m tape is used to measure a distance between A and B which was recorded as 350.65m. It was found that the tape is 0.02m too short. 11. What is the correct measured distance AB? 12. If the same tape is used to layout a distance BC = 450m, what is the correct layout distance BC?
As per plan, the distance between two telephone poles is 356.35 meters. If the location of one is known in the field and the second is to be laid with a 100 m tape known to be 0.02 meter too long, along an average ground slope of 1%. Determine the actual length to be laid along the ground surface. Given: Nominal Tape Length L1 Required Distance to be Laid out Di correction due incorrect tape length Ci Ground slope S Solution correction per tape length (correction 100-m length) incorrect tape length Ci slope correction (approximate method) CSL cumulative correction per tape length (all sources of tape corrections) C total correction (correction for Di) tot C Tape too long (+) or too short (-)? write the sign only Is the total correction to be added or to be subtracted? Correct Distance to be laid out DC
As per plan the distance between two telephone poles is 356.35 meters. If the location of one is known to be in the field and the second is to be laid with a 100 m tape known to be 0.02 meter too long, along an average ground slope of 1%. Determine the actual length to be laid along the ground surface.
line from A to B =5 cm on a map with scale =1/2500. This line must be fixed on ground surface if the ground surface is inclined by 5° Find the measured distance using 29.95 tape (True length) to fix the line.
Provide the detailed figure and complete solution. For all the computed values with decimals, use four (4) digits after the decimal.
Consider the following four observations for angles: A, B, and C of a plane triangle: Angle A Angle B Angle C 44° 28'16" 65° 56'11" 69° 35'23" 44° 28'13" 65° 56'11" 69° 35'26" 44° 28'19 65° 56'7" 69° 35'18" 44° 28'11" 65° 56"8" 69° 35'26" A Determine relative weights for angles A, B, and C. Express your answers, separated by commas, to six significant figures. 15. ΑΣΦΑ vec x Xb √√√x1x1 a x-10 wt A wto OMIC T₂