In the heat of solution experiment If 10 ml of the solution of oxalic acid is diluted to 100ml amd 25 ml of this diluted solution was found to need 40 ml of NaOH ( 0.2 M) to reach the end point Calculate the molar solubility of oxalic acid if the mass of the original solution before dilution ) of oxalic acid was 11.1g. (Molar mass of oxalic acid is 90 g/mol)

In the heat of solution experiment If 10 ml of the solution of oxalic acid is diluted to 100ml amd 25 ml of this diluted solution was found to need 40 ml of NaOH ( 0.2 M) to reach the end point Calculate the molar solubility of oxalic acid if the mass of the original solution before dilution ) of oxalic acid was 11.1g. (Molar mass of oxalic acid is 90 g/mol)

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

How many grams of solid potassiumfluoride should be added to 2.00 L of a 0.236 M hydrofluoric acid solution to prepare a buffer with a pH of 3.773? The Ka of hydrofluoric acid is Ka = 7.1 x 10-4 Provide your answer with 3 S.F. , no units and no scientific notation
Bromthymol blue has a Ka value of 1.0 \times 10-7, is yellow in its HIn form and blue in its In form. Suppose we put a few drops of this indicator in a strongly acidic solution. If the solution is then titrated with NaOH, at what pH will the indicator color change first be visible?
Im trying to solve for x. is there a better way to solve for x without factoring? Im bad attaht and always mess it up during tests
What is the pH of a buffer system that is 0.25 M in NH3 and 0.26 M in NHẠC?? Кь NH3 %3D 1.8 х 10:5 NOTE: Even though this system involves the weak base NH3 and its conjugate acid NH4*, it is still possible to use the Henderson-Hasselbalch equation using pKą for the weak acid NH4* and the ratio of [conjugate base]/[conjugate acid]. You do not need to convert the equation and use a pКь value.
(Asking this question again because I'm getting 2 different answers.)
make a recipe with full written out steps for 100mL of the TES buffer 30 mM TES has pH of 7.2 and the pKa=7.55 4 mM MgCl2 4 mM NaCl 40 mM 2-mercaptoethanol acid and base stocks are 2 M MgCl2 and NaCl stocks are 0.5 M 2-mercaptoethanol stock is 1.4 M
0.250 M of NaOH is used to carry out the titration of a weak diprotuce solid. It is used until the second equivalence point has been surpassed. The equivalence points are easily seen at 12mL and 24 ml, but the mass of the unknown solid was never documented. Using pKa values, the identity of the unknown is presumed to be ascorbic acid. How many grams of ascorbic acid was there to begin with? (For reference, ascorbic acid's molar mass is 176.12 g mol, the pKa1 is 4.10, and the pKa2 is 11.79)
For each scenario below, select the color of the solution using the indicator thymol blue during the titration. When you first add indicator to your Na2CO3 solution, the solution is basic (pH ~10), and the color is [Select] At the equivalence point for the titration, the moles of added HCI are equal to the moles of Na2CO3. One drop (or less!) past this is called the endpoint. The added HCI begins to titrate the thymol blue indicator itself. At the endpoint, the indicator color is [Select] When you weren't paying attention and added too much HCI (~12 mL extra), the color is [Select] When you really weren't paying attention and reached the second equivalence point of Na2CO3, the color is ✓ [Select] blue yellow red orange green Question 9
6. A student carried out a non-aqueous titration at chemistry laboratory using 0.1N solution of HCIO4 acid. She obtained with 0.06 N as the calculated normality of HCIO4 acid after the standardization. Standardized HCIO4 acid was titrated with 0.2 g of Ephedrine hydrochloride in mercuric acetate solution. Calculate the percentage of Ephedrine hydrochloride. Volume of titrant consumed at end point was 25 mL. Note: 1 ml of 0.1 M HCIO4 acid is equivalent to 0.02017 g of Ephedrine hydrochloride.
Solve it asap
Determine the [H3O+H3O+] of the eight buffer solutions made by mixing 1.10 M acetic acid and 0.900 M sodium acetate solutions according to the following volumes. The pKa for acetic acid, CH3CO2HCH3CO2H (HAc), is 4.745. You will also need this information in your post-lab. It is highly suggested you write these calculations down (both unrounded and rounded values) to use later. Solution 1.10 M Acetic Acid (mL) 0.900 M Sodium acetate (mL) [H3O+H3O+] (M) 1 8.00 2.00 Solution 1 Concentration 2 7.00 3.00 Solution 2 Concentration 3 6.00 4.00 Solution 3 Concentration 4 5.00 5.00 Solution 4 Concentration 5 4.00 6.00 Solution 5 Concentration 6 3.00 7.00 Solution 6 Concentration 7 2.00 8.00 Solution 7 Concentration 8 1.00 9.00 Solution 8 Concentration Solution 1 Concentration: M Solution 2 Concentration: M Solution 3 Concentration: M Solution 4 Concentration: M…
5