In the following structure, bolt B has a diameter of 1.75” and bolt A has a diameter of 2.50”. Bar BC is circular and has a diameter of 1.50”. Determine: a. The shear stress at point A. b. The shear stress at point B. c. The axial stress in bar BC.

Q: Q/Normal and shear stresses acting at the point is shown in Figure 1- Determine the principal…

A:

Q: 5 - An aluminum circular shaft, fixed at both ends, is loaded by torques applied at points B and C,…

A: Given Data  Shear modulus (G) = 85 GPa  Diameter of shaft (d) = 40mm  Length of AB (LAB) = 0.5m =…

Q: The member shown has a rectangular cross section, determine the state of stress that loading…

A:

Q: 2.28. The three bars shown in Fig. 2-45 support the vertical load of 5000 lb. The bars are all…

A: I have attached the image below Explanation:Step 1:Step 2:

Q: Problem 4 : For the shown Mohr circle: a) What is the state of stress at the reference point A.…

A:

Q: The stresses shown in the figure act at a point in a stressed body. Determine the normal and shear…

A: Given: Sx=7200 psi Sy=2300 psi  θ=64o  To find: Normal and shear stresses

Q: Two forces P1 and P2, of magnitude P1 = 15 kN and P2 = 18 kN, are applied as shown to the end A of…

A: Given:P1=15 kN     =15000 NP2=18 kN     =18000 NRadius c=20 mmThe axial force and bending moment…

Q: a b 45 MPa 60° a

A: Given: Shear stress  To find: Normal stress and principal stress on inclined plane

Q: the stress system shown, calculate the magnitude of the shear stresses on Ty and the angle a, (72…

A:

Q: In the stepped shaft given in the figure, what will then be the P force provided that the stress in…

A: Given data in question Load 120 kNDiameter 50 and 75 mmLength750 & 1000 mmTo find out Load P

Q: For the element with stresses as shown below, find: . The magnitudes and directions of major and…

A: To determine-

Q: The member is loaded as shown. The diameter of the member is 32 mm. 1) Calculate all internal…

A:

Q: 5-8 Draw the shear, bending moment, and axial force diagrams and the qualitative deflected shape for…

A: Solution-

Q: Part 2 * Your answer is incorrect. The z-component of momemt M will cause compression at A and B,…

A:

Q: 1. The member is loaded as shown. The diameter of the member is 32 mm. 1) Calculate all internal…

A:

Q: A bar of length 3 m is fixed at both the ends as shown in figure initial stress in bar is 30 MPa…

A: Length of the bar L=3 m, Bar is fixed at both ends, Initial stress in the bar σi=30 MPa(tensile) at…

Methods to Determine Vertical Stress

The load applied to the soil is transferred to the underground. The presence of water at soil pores and solid grains above the soil are the primary components that are responsible for the effective load transfer. Due to the load acting, the internal component of the soil or the underground formations undergoes deformations or a tectonic shift. The amount of deformation depends upon the amount of load acting on the soil surface, which indeed, depends on the weight of everything present above the soil. Due to this, the underground soil element develops internal stresses which try to resist the tectonic changes.