In the stepped shaft given in the figure, what will then be the P force provided that the stress in the AB part is two times that of the BC part? 75mm P 50mm 120 KN B 120 KN 750 mm- -1000 mm

Q: How is the punch list prepared?

A: A punch list can be defined as a document that is prepared when the project nears the completion and…

Q: By whom  are computers used for project administration/

A: Project administration is the part of project management. There are so much responsibilities in…

Q: Could you show the calculations for the table

A: The discharge through the section = Q = 100, 150, 200, and 250 cfs The slope of the section = S =…

Q: Which equations did you use to calculate these values? Or which machinery book did this info come…

A: Given problem, What is source of the database of the given material?

Q: How does the diameter of a chair bar affect the number of chairs required

A: This question is related to the Design of RCC structure from civil engineering. In this question ask…

Q: How did you derive the formula?

A: Given: h1= 200 mm   h2 =80 mm   k1=0.004 cm/sec,   H1 = 100 mm   H2 = 150 mm. Required: To explain…

Q: What are the other sources for change orders?

A: The change order can referred as a variation order, it is a work that has been excluded or added to…

Q: Describe the Project Delivery System?

A: The project delivery system is a process which is used to assign the responsibilities of the…

Q: What is expert determination?

A: Experts are often assigned by justices and adjudicators in national courts and arbitration…

Q: What do you mean by fail safe design

A: Fail-safe designs are the methods of designs in which various techniques can be used to mitigate…

Q: what are the four sources of written information a dafter has to be able to use

A: sources of written information a dafter : 1.As per the guidelines given by the National Institute of…

Q: What are Quantity Variations?

A:

Q: Why are still cameras are used in the construction project?

A:

Q: What is Micropiles?

A: - A Micropile is a type of friction pile having diameter less than equal to 305 mm which can be…

Q: What is a punch list and when should it be developed?

A: The objective of the question is to understand the concept of a punch list in the field of civil…

Q: Describe and discuss in detail what is a Sovent System?

A: For any drainage system, traps are used to prevent sewer gases from the entering into the buildings.…

Q: What type of information is included in Construction Dairy?

A: The Construction diary is a record of all the worksite progression of the construction project as…

Q: What is the Project Delivery System?

A: The process of designing and construction of a project for an owner is known as Project Delivery…

Q: What is structural database testing, and how is it distinguished from other types of testing?

A: The 3 types of Database Testing are Structural Testing Functional Testing Non-functional Testing…

Methods to Determine Vertical Stress

The load applied to the soil is transferred to the underground. The presence of water at soil pores and solid grains above the soil are the primary components that are responsible for the effective load transfer. Due to the load acting, the internal component of the soil or the underground formations undergoes deformations or a tectonic shift. The amount of deformation depends upon the amount of load acting on the soil surface, which indeed, depends on the weight of everything present above the soil. Due to this, the underground soil element develops internal stresses which try to resist the tectonic changes.