In the figure, a climber leans out against a vertical ice wall that has negligible friction. Distance a is 0.925 m and distance L is 2.15 m. His center of mass is distance d = 0.95 m from the feet-ground contact point. If he is on the verge of sliding, what is the coefficient of static friction between feet and ground? com a x HsNumber i Units

In the figure, a climber leans out against a vertical ice wall that has negligible friction. Distance a is 0.925 m and distance L is 2.15 m. His center of mass is distance d = 0.95 m from the feet-ground contact point. If he is on the verge of sliding, what is the coefficient of static friction between feet and ground? com a x HsNumber i Units

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter6: Applications Of Newton’s Laws Of Motion

Section: Chapter Questions

Problem 11PQ: In Problem 10, the mass of the sign is 25.4 kg, and the mass of the potted plant is 66.7 kg. a....

See similar textbooks

Similar questions

A crate of mass 100.0 kg rests on a rough surface inclined at an angle of 37.0with the horizontal. A massless rope to which a force can be applied parallel to the surface is attached to the crate and leads to the top of the incline. In its present state, the crate is just ready to slip and start to move down the plane. The coefficient of friction is 80of that for the static case. (a) What is the coefficient of static friction? (b) What is the maximum force that can be applied upward along the plane on the rope and not move the block? (c) With a slightly greater applied force, the block will slide up the plane. Once it begins to move, what is its acceleration and what reduced force is necessary to keep it moving upward at constant speed? (d) If the block is given a slight nudge to get it started down the plane, what will be its acceleration in that direction? (e) Once the block begins to slide downward, what upward force on the rope is required to keep the block from accelerating downward?
Jamal and Dayo are lifting a large chest, weighing 207 lb, by using the two rope handles attached to either side. As they lift and hold it up so that it is motionless, each handle makes a different angle with respect to the vertical side of the chest (Fig. P5.76). If the angle between Jamals handle and the vertical side is 25.0 and the angle between Dayos handle and the vertical side of the chest is 30.0, what are the tensions in each handle? FIGURE P5.76
To maintain a constant speed, the force provided by a car’s engine must equal the drag force plus the force of friction of the road (the rolling resistance). (a) What are the drag forces at 70 km/h and 100 km/h for a Toyota Camry? (Drag area is 0.70m2 ) (b) What is the drag force at 70 km/h and 100 km/h for a Hummer H2? (Drag area is 2.44m2 ) Assume all values are accurate to three significant digits.
Two blocks connected by a string are pulled across a horizontal surface by a force applied to one of the blocks, as shown below. The coefficient of kinetic friction between the blocks and the surface is 0.25. If each block has an acceleration of 2.0m/s2to the right, what is the magnitude Fof the applied force?
Two children push on opposite sides of a door during play. Both push horizontally and perpendicular to the door. One child pushes with a force of 17.5 N at a distance of 0.600 m from the hinges, and the second child pushes at a distance of 0.450 m. What force must the second child exert to keep the door from moving? Assume friction is negligible.
A freight train consists of two 8.00105kgengines and 45 cars with average masses of 5.50105kg . (a) What force must each engine exert backward on the track to accelerate the train at a rate of 5.0010-2m/s2if the force of friction is 7.50105Nassuming the engines exert identical forces? This is not a large frictional force for such a massive system. Rolling friction for trains is small, and consequently, trains are very energy-efficient transportation systems. (b) What is the force in the coupling between the 37th and 38th cars (this is the force each exerts on the other), assuming all cars have the same mass and that friction is evenly distributed among all of the cars and engines?
A uniform pole is propped between the floor and the ceiling of a room. The height of the room is 7.80 ft, and the coefficient of static friction between the pole and the ceiling is 0.576. The coefficient of static friction between the pole and the floor is greater than that between the pole and the ceiling. What is the length of the longest pole that can be propped between the floor and the ceiling?
A piece of bacon starts to slide down the pan when one side of a pan is raised up 5.0 cm. If the length of the pan from pivot to the raising point is 23.5 cm, what is the coefficient of static friction between the pan and the bacon?
Use the second condition for equilibrium (net =0 ) to calculate Fpin Example 9.1, employing any data given or solved for in part (a) of the example.
Two children push on opposite sides of a door during play. Both push horizontally and perpendicular to the door. One child pushes with a force of 17.5 N at a distance of 0.600 m from the hinges, and the second child pushes at a distance of 0.450 m. What force must the second child exert to keep the door from moving? Assume friction is negligible.
Review. A rifle bullet with a mass of 12.0 g traveling toward the right at 260 m/s strikes a large hag of sand and penetrates it to a depth of 23.0 cm. Determine the magnitude and direction of the friction force (assumed constant) that acts on the bullet.
A physics major is cooking breakfast en she notices that the frictional force between her steel spatula and Teflon trying pan is only 0.200 N. Knowing the coefficient of kinetic friction between the two materials, she quickly calculates the normal force. What is it?