Answered: In an oscillating LC circuit, the total… | bartleby

Related questions

Question

In an oscillating LC circuit, the total stored energy is (4.6540x10^-1) J and the
maximum charge on the capacitor is (4.139x10^-5) C. When the charge on the
capacitor has decay to (3.68x10^-6) C, what is the energy stored in the inductor?
Express your result in mJ with three significant figures.
Note: Your answer is assumed to be reduced to the highest power possible.

Expert Solution

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

A sinusoidal voltage Δv = 45.0 sin(100t), where Δv is in volts and t is in seconds, is applied to a series RLC circuit with L = 170 mH, C = 99.0 µF, and R = 60.0 Ω. e) What If? For what value of the inductance (in H) in the circuit would the current lag the voltage by the same angle ? as that found in part (d)? f) What would be the maximum current (in A) in the circuit in this case?
An LC circuit like that in the figure below consists of a 3.80-H inductor and an 830-pF capacitor that initially carries a 105-μC charge. The switch is open for t < 0 and is then thrown closed at t = 0. Compute the following quantities at t = 2.00 ms. C Qmax L S eee (a) the energy stored in the capacitor J (b) the energy stored in the inductor J (c) the total energy in the circuit
A 24.0-mH inductor has a reactance of 1.50 ko. (a) What is the frequency of the ac current that passes through the inductor? (b) What is the capacitance of a capacitor that has the same reactance at this frequency? The frequency is tripled, so that the reactances of the inductor and capacitor are no longer equal. What are the new reactances of (c) the inductor and (d) the capacitor? (a) Number i (b) Number (c) Number pi i (d) Number i Units Units Units Units >
The charge on the capacitor of an LC circuit with capacitance C and inductance L obeys the following equation. Find the maximum current in the circuit. q= Q cos [t/(LC)0.5] Q Q/(LC) 0.5 zero QQ²/(LC) 0.5 imax 1/(LC) 0.5
An electrical engineer designed an RL circuit similar to the one shown in the figure, with E = 6.00 V, L = 2.00 mH, and R = 3.40 N. L R (a) What is the inductive time constant of the circuit (in ms)? 0.588 ms (b) Calculate the current in the circuit (in A) 250 µs after the switch is closed. 0.61 A (c) What is the value of the final steady-state current (in A)? 0.98 Apply Ohm's law. A (d) After what time interval (in ms) does the current reach 80.0% of its maximum value? 1.17 1o[1 - exp(- ). with i = 0.800I,: Use your value from part (c) for I, and the inductive Apply the equation for the current as a function of time in an RL circuit, i = I, time constant found in part (a). ms Need Help? Read It ll