Answered: A charged capacitor (C=1μF) is… | bartleby

Related questions

Question

A charged capacitor (C= 1μF) is connected in a single loop circuit with an inductor (L= 3mH).
▾ Part A
At some time after the switch is closed, the charge on the capacitor is q=2.3µC. At that moment, determine the magnitude of the rate of change of the current.
V—| ΑΣΦ + d C
?
Amps/s
Submit
Request Answer
++++++
с
Lelle

Expert Solution

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

A 5.50 nF capacitor is charged to 12.0 V, then disconnected from the power supply and connected in series through a coil. The period of oscillation of the circuit is then measured to be 8.60 x 10-5 s. For related problemsolving tips and strategies, you may want to view a Video Tutor Solution of An oscillating circuit. Part C Calculate the total energy of the circuit. Express your answer with the appropriate units. ΜΑ 7 0 ? U = Value Units Submit Request Answer Part D Calculate the maximum current in the circuit. Express your answer with the appropriate units. D ΜΑ 7 0 ? Imax = Value Units Submit Request Answer
b
Suppose the rod is quickly moved to the right at a constant speed of 31.9 m/s. During this time, a current of ________ is induced in the _______direction
Part A A charged capacitor with C = 640 µF is connected in parallel to an inductor that has L = 0.450 H and negligible resistance. At an instant when the current in the inductor is i = 1.80 A , the current is increasing at a rate of di/dt = 89.0 A/s. During the current oscillations, what is the maximum voltage across the capacitor? Express your answer to three significant figures and include the appropriate units. ? HA Vmax = Value Units Submit Request Answer
Problem2 Two long solenoids are arranged coaxially (one inside the other, centered on the same axis). Both have length L 1.0m. The inner solenoid has r1 1.6 cm, n1 220 turns per centimeter, and resistance Ri = 10Ω. The outer solenoid has radius r2 = 1.8 cm, n2 = 120 turns per centimeter, and resistance R2 5.3 Ω. Since the length of the solenoids is much longer than their diameter, we can ignore the fringing of the magnetic field at the ends and treat the solenoids as infinitely long when calculating the magnetic fields (i.e., we can assume that the magnetic field inside is uniform along the entire length). (a) If the inner solenoid initially carries a current I 1.5 A that then drops to zero at a steady rate over a time interval Δt-: 25 ms, and if the outer inner solenoid is not connected to any battery, what is the current induced in the outer solenoid during this time interval? (b) If instead it is the outer solenoid that initially has a current I 1.5A that then drops to zero at a…
Needs Complete typed solution with 100 % accuracy.
The inductor in the RLC tuning circuit of an AM radio has a value of 500 mH Part A What should be the value of the variable capacitor in the circuit to tune the radio to 749 kHz ? Express your answer in farads. 15. ΑΣΦ c=159.56 6 Submit Previous Answers Request Answer Provide Feedback ? X Incorrect; Try Again; 5 attempts remaining
A 1.80 cm x 1.80 cm square loop of wire with resistance 1.10×10-² has one edge parallel to a long straight wire. The near edge of the loop is 1.20 cm from the wire. The current in the wire is increasing at the rate of 100 A/s.
Magnetic resonance imaging instruments use very large magnets that consist of many turns of superconducting wire. A typical such magnet has an inductance of 40 HH. When the magnet is initially powered up, the current through it must be increased slowly so as not to "quench" the wires out of their superconducting state. One such magnet is specified to have its current increased from 0 AA to 150 AA over 230 minmin. Part A What constant voltage needs to be applied to yield this rate? Express your answer with the appropriate units.
Consider the circuit R2 ww R1 ww B 2 R5 ww 25 R4 R3 E ww i3- E2