7. It is then connected in series with a [ inductor. What is the total energy stored in this circuit? Express your answer in joules. U= Submit Part B imaz= What is the maximum current in the inductor? Express your answer in amperes. - ΑΣΦ Submit Part C OF ΠΙΑΣΦ q= Request Answer Submit Request Answer ? Request Answer What is the charge on the capacitor plates at the instant the current in the inductor is maximal? Express your answer in microcoulombs. 17 ΑΣΦΑ ? ? J A μC

Q: A 96.0 A current circulates around a Part A 1.80-mm-diameter superconducting ring. What is the…

A: Magnetic field.

Q: What is the speed of a 10 g bullet that, when fired into a 12 kg stationary wood block, causes the…

A:

Q: (b) What If? If an image of opposite characteristic, i.e., virtual if the image in part (a) is real…

A: Solution:   b) As per the given data, we have to get the image having the opposite character that we…

Q: Is the final pressure of the air greater than, less than, or equal to 1.0 atm? Explain. 3D 100 cm…

A: Since we answer up to three subparts, we will answer the first three. Please resubmit the question…

Q: 3) 3. Three objects, a solid cylinder, a solid sphere, and a hollow sphere, are placed one meter up…

A: Solution:-Given that

Q: b. Find the energy level splitting by spin-orbital coupling (you can utilize Hellmann-Feynman…

A:

Q: 2. Two very large flat sheets are oriented parallel to each other and are oppositely charged. The…

A: The electric field intensity at a point is the force experienced by a unit positive charge placed at…

Q: Use the work-energy theorem to find its maximum height. Express your answer with the appropriate…

A:

Q: A cannonball is fired horizontally (launch angle (1) of 0°) from a height h above the ground, as in…

A:

Q: EAz, EAy = 0,0.300 N/C Two point charges are placed on the x axis. (Figure 1)The first charge, q1 =…

A:

Q: • Part B Figure 1 of 1> If L = 240µH , what is the resonance frequency in Hz? Express your answer in…

A: Here, Vmax= 10 V Imax= 2A R = 2.5 Ω Now,   The Phase angle   cosϕ =12 ⇒ϕ =60tanϕ =XL-XCRXL-XC =Rtanϕ…

Q: Problem 4: A block with a mass of m = 18 kg rests on a frictionless surface and is subject to two…

A: Given: The mass of the block is 18 kg. The force F1 is 9.5 N. The force F2 is 19.25 N with an angle…

Q: Consider the circuit shown in the figurea Suppose the four resistors in this cirout have the values…

A: Given:-   R1=11Ω                   R2=6.5Ω                   R3=6.2Ω                   R4=12Ω…

Q: (f) Determine the total distance traveled between t= 0 and t= 0.56 s. cm

A: part F: Frequency is f=2.70 Hz So time period will be T=1f=12.70 s Amplitude is A=3.40 cm

Q: A point charge q = +5 µC is at the center of a sphere of radius 0.6 m. (a) Find the surface area of…

A:

Q: a) Determine the speed the pendulum reaches at its lowest point (assume no air resistance or…

A: WE KNOW THAT     Loss on gravitational  potential energy =  gain in k.E   h= R - R cosθ     θ=30°…

Q: You have a pulley 12.6 cm in diameter and with a mass of 2.0 kg. You get to wondering whether the…

A: Given: The diameter of the pulley is d=12.6 cm=0.126 m, The mass of the pulley is m=2.0 kg, The…

Q: Electricity is distributed from electrical substations to neighborhoods at 15000 V. This is a 60 Hz…

A: Given, V1=15000 Vf=60 HzV2=120 V

Q: A Review I Constants For lunch you and your friends decide to stop at the nearest deli and have a…

A: for reference purpose i solved part a also part b answer in step 2

Q: (b) How long (in s) would it take to reach the ground if it is thrown straight down with the same…

A:

Q: A spring of force constant 300.0 N/m and unstretched length 0.220 m is stretched by two forces,…

A: The work done to stretch the spring is equal to the elastic potential energy stored in the spring.…

Q: Part (b) What is the y-component of the momentum of mass m, before the collision? Give answer in kg…

A:

Q: The wire shown in figure 'c' has linear charge distribution P = 1x 10-6 C/m. What is the electric…

A: Given, R=10 cmρL=1×10-6 C

Q: Learning Goal: A car is traveling at a constant velocity of magnitude vo when the driver notices a…

A:

Q: Revie Two point charges are placed on the x axis. (Figure 1)The first charge, q1 = 8.00 nC , is…

A: Given: EAx=0 N/CEAy=0.300 N/Cr=15m-12m

Q: Part b

A: Part B: The energy of the system is conserved as there isn’t any dissipative force acting on…

Q: A particle moves along the x-axis, its position given by (t): t > 0, where t is measured in seconds…

A: Solution: The position of the particle is given as a function of time. Let us draw the position-time…

Q: work is done by the force if the object i

A:

Q: QUESTION 1 Problem #1: a. What is the acceleration due gravity on the surface of Venus? (Mvenus =…

A:

Q: Water contents in oil was measured 4 times by each of two methods with the following results: Method…

A: Given: The standard deviations of the water contents in oil is given.

Q: For a planet to have an atmosphere, gravity must be sufficient to keep the gas from escaping. The…

A:

Q: Part (f) Enter an expression for the tension in the string, in terms of the defined quantities and…

A:

Q: (b) Let the eastward-moving car have a mass of 1,350 kg and a speed 30.0 km/h and the…

A:

Q: A rocket-powered hockey puck moves on a horizontal frictionless table. The figure below shows the…

A: Given,

Q: The circuit shown contains a voltage source with emf = 8.99 V, a resistor with resistance R = 165…

A:

Q: PartB: What1 the change in prers ure, in pascals,07 bluool atthe brain due To sitingup, neglecting…

A: As person sits up and height was raised due to this as a result heart needs to create more pressure…

Q: A 50-g pencil (uniform slender rod) falls down onto the table with a velocity of v = 0.29 m/s just…

A:

Q: Part b

A:

Q: b. A positive charge with twice the value of the initial charge is now placed to the right of the…

A:

Q: Part B What is the force when the temperature of the gas is increased to 119 °C? Express your answer…

A: Given  Side length l = 0.12 m  So  Area of one side A = l2 = (0.12)2  = 0.0144 m2  Volume of cube V…

Q: A uniform solid disk with a mass of 29.5 kg and a radius of 0.407 m is free to rotate about a…

A: Angular acceleration is a vector quantity which has the same direction as the torque and torque is…

Q: Part B Calculate the angular separation 01 at which two point sources of wavelength 00 nanometers…

A:

Q: Problem 11: Consider two current-carrying wires, separated by a distance d= 2.7 cm, as shown in the…

A: Write the given values of this problem. d=2.7 cm or 0.027 mI1=7.5 AI2=13 A

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention.