II. b) What is the difference between liquid-liquid, solid-liquid and solid-phase extraction? Complete the table below and sort the following examples in the correct column: Steeping tea, washing an organic phase (workup), brewing beer, chemical desalting of crude oil, activated carbon sugar decolorization.

II. b) What is the difference between liquid-liquid, solid-liquid and solid-phase extraction? Complete the table below and sort the following examples in the correct column: Steeping tea, washing an organic phase (workup), brewing beer, chemical desalting of crude oil, activated carbon sugar decolorization.

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

Determine the number of grams (to 3 decimal places) of solid NaNO3 to make 1.0litres of 1000 ppm of Na+ (this is NOT 1000 ppm (NaNO3). Show your math
Are Water and organic liquids two different kinds of solvents ?
Should we ignore changes in density of water when dealing with high concentration of sludge or liquid chemicals, explain your answer?
What is the gravitational force of attraction for two protons separated by 75 pm?
Describe in outline how you would determine the molar mass of cyclohexane, C_6H_12, a volatile liquid experimentally. State and explain any two precautions taken in the determination process.
The ubiquitous single-cell yeast (S. cerevisiae) is roughly spherical with a “typical” diameter of 5 μm. Let’s make a rough approximation of how many water molecules are in a yeast cell.a) What is the molar volume of liquid water? You may assume dH2O = 1.00 g/mlb) What is the volume occupied by a single water molecule?c) Approximately how many molecules of water are in a “typical” yeast cell?Assume the cell is composed completely of pure water with density equal to 1.00 g/mL (a more realistic estimate is ~70% water content by volume, but don’t worry about this).
What is the absolute difference in your total concentration of iodine in the CH₂Cl2 phase, in mol/L, between your 'best two' determinations in Part 2 of the experiment? Use your own lab-obtained data. Report your answer to the correct number of significant figures and only include the numerical value (no units).
Would the compound methane, CH4 be soluble or insoluble in water under normal laboratory conditions? Explain your answer.
When a solution of 1.00 g of ‘X’ in 100 ml of water was shaken with 10 ml of diethyl ether, 0.60 g of X was transferred to the solvent (ether) layer. When another solution of 0.5 g of ‘X’ in 100 ml of water was shaken with 5 ml of petroleum ether, 0.3 g of X was extracted by the solvent. Which of these ethers is a better solvent? Justify your answer using calculations.
What is the freezing point of a ethanol solution if that same solution boils at 79.5 ℃? The normal boiling point and freezing point of pure ethanol (C2H5OH) are 78.29 ℃ and -114.2 ℃, respectively. For ethanol, Kb = 1.23 ℃/m and Kf = 1.99 ℃/m.Please enter your response in standard notation to one decimal place.
Based on the data below, which explanation BEST explains what state of matter the compound being dissolved was? Measurement Initial Condition Final Conditions Effect Temperature 30°C 40°C Rate of dissolving decreaser Pressure 1.0 atm 2.0 atm Rate of dissolving increased The compound was a gas because the change in pressure increased the rate of dissolution. The compound was a gas because the increase in temperature caused the rate of dissolution to increase. The compound was a solid because the increase in temperature caused the rate of dissolution to increase. The compound was a solid because the change in pressure increased the rate of dissolution.
Complete and balance the following equations. Na2O2 (s) + H₂O(1) → Express your answer as a chemical equation including phases. ΑΣΦ ? A chemical reaction does not occur for this question.