II. A circular steel rod has a diameter of 50 mm. It touches the unyielding supports at point A and B when T, = 80 °C. Find the applied force P to the collar at its midsection so that, when T, 30 °C, the reaction at B is zero. Use E st = 200 GPa and the coefficient of linear expansion of steel is at 12 x 10^-6 m/m C.

Q: An L-shaped beam is being supported by a ball and socket support at O and two cables, AB and CD. A…

A:

Q: M y A 2L - В 30 Calculate the support reaction at the roller at A to the nearest whole number. Use…

A:

Q: Two cables DAC and ACB are rolled on two pulleys at A and C as shown in Figure 2. applied to the…

A: givenQ=1800Nsystem is shown as below

Q: A sphere (m = 10 kg) is supported at the end of a The tor- slender rod (L = 300 mm) as shown in Fig.…

A: Given data: The increase in the height of the mass m can be determined as, The potential energy of…

Q: A mass of 35 kg is suspended from a weightless bar AB which is supported by a cable CB and a pin at…

A:

Q: The mechanical system consists of two identical steel rods (A = 30 mm?, E = 200GPA, a = 15x106/°C)…

A: (a) Moment acting about point B is PA0.2=Pc0.08PA=0.4Pc⋯⋯⋯(1) According to the compatibility…

Q: 4.24 - Determine the nodal displacements and slopes, the forces in each element, and the reactions.

A:

Q: For the material indicated determine the required diameter of the rod.

A:

Q: (1) 130 10 in 65 16 cord B 45 45 Zo in For the bent rod and load shown, (a) the tension in cord Be…

A: Draw free body diagram of system Find the tension in BC and reaction at A and direction.

Q: If the temperature of the 85 mmmm diameter post CD is increased by 60 ⚫C, determine the force…

A:

Q: If a wire of length L, linear expansion (a) and Young's modulus is įsothermic (Y) undergoes a very…

A:

Q: In the system shown the ABC bar is subjected to a charge Fz = P (in kN) at the same time as a moment…

A: There are three types of stresses produced by the given loading in the question which are- 1. The…

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.