Answered: If heat absorbed by the engine 15,000…

If heat absorbed by the engine 15,000 Joule and Low temperature of 450 K High temperature of 850 K, what is the efficiency by the Carnot engine? %3D O 52.94 % O 74.50 % O 47.06 % O 15.34 %

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: 7. What is the potential energy of the 100-N block? 3 2 m Datum a. 50 J b. 100 J

A: Weight of the block = mg = 100 N . Height above datum = h =2 m . The potential energy depends upon…

Q: An electric heater supplies (R+2.5)kW of power in the from of heat to water. If in 5.5 hours, 350kg…

A: Given data- Power (P) = (R+2.5)kW=(83+2.5)kW=85.5kW Time (t) = 5.5 hours Mass of water (m) = 350kg…

Q: 2. A system is cooled at constant volume from state 1 to state 2, the internal energy decreasing 88…

A: For a cyclic process net changes in internal energy becomes zero so we can find changes in internal…

Q: Convert a pressure head of 10 m water column to kerosene of specific gravity equal to 0.8 and to…

Q: Q1; If a system has 30J of heat added to it, and the total change in its internal energy is 10J, how…

A: Given, Heat ,Q = 30 J Change, In internal energy, ∆U…

Q: A Carnot engine uses hydrogen as its medium. The volumes at the beginning and end of the reversible…

Q: A power nozzle throws a jet of water which is 30 mm in diameter at a velocity of 40 m/s. What is the…

A: Given data: Diameter of nozzle=30 mm Velocity=40 m/s It is asked to find the power exerted by…

Q: exchanger using 250 kPa steam of 90% quality. The heat losses to the surrounding air have be…

A: Given:- quantity of light oil =2m3/min temperature heated= 20 degree Celsius to 100 degree Celsius…

Q: Air undergoes a polytropic process in a piston-cylinder assembly from p₁ = 1 bar, T₁ = 295 K to p2 =…

Q: in of a light oil are to be heated from 20C to 100C (with zero vaporization) in an exchanger using…

A: Given:- heated temperature=20 degree Celsius to 100 degree Celsius quantity of light oil =2m3/min…

Q: What is the equivalent value of T58 in degrees Fahrenheit, Rankine, and kelvin

A: Given temperature = 58 oC

Q: Prob-3 A cyclic machine, shown in Fig. below receives 300 kJ from a 1000 K energy reservoir. It…

A: The high temperature of the energy reservoir TH=1000 KThe low temperature reservoir, TL=400 KEnergy…

Q: certain fluid has an enthalpy 1800 KJ/kg and 500 KJ/kg work flow. Find the internal energy.

Q: S-13.6 Problem 2: (30 points) If a horizontal force of 890 N is developed by the water jet leaving…

Q: ntly), but with 10 kg of air at 800 kPa, heated at constante pressure up to 400°C. Use the values…

Q: Which of the following equations is used to determine the energy loss from transitions and fittings?…

Q: Which of the following statements is INCORRECT? O Evaporation from an open water surface is usually…

A: Evaporation from open surface is estimated by pan evaporation. In evaporation Water changes into…

Q: 88 A machine lifts an object of weight Wat constant speed through a vertical distance h. The…

Q: In which atmospheric pressure water vaporizes at 110 °C? a. 14.7 psi b. Water only vaporizes at 100…

A: Atmospheric pressure = Atmospheric pressure is the pressure within the atmosphere of the Earth.…

Q: A flocculation tank contains 1800 m³ of water, which is mixed using paddles at an average velocity…

A: Given- Volume of water = 1800 m3 G=100/s Dynamic viscosity- μ=0.798×10-3 N-s/m2 It is needed to find…

Q: 3 A flocculation tank contains 1800 m³ of water, which is mixed using paddles at an average velocity…

A: Given data: Volume, V=180 m3 Velocity gradient, G=100s Viscosity, μ=0.798×10-3 Nsm2

Q: A heat engine with 0.305 mol of a monatomic gas undergoes the cyclic procedure shown in the pV…

A: Using the given data, we can calculate the temperature at stage 1 (T1) and stage 3 (T3), and then…

Q: what is TH, in °F? "C, what is TL, in °C?

A: Reversible process: - It is defined as the process in which system and surrounding can reach from…

Q: The atmosphere is stable with a lapse rate of -0.2 degree C/100 m. The surfaces air temperature is…

Q: An insulated Thermos contains 110 cm3 of hot coffee at 83.0°C. You put in a 15.0 g ice cube at its…

Q: Lauren has worker building her house on a hot summer day. She prepares a drink for them by adding a…

Q: Consider 4.8 pounds per minute of water vapor at 100 lb/in², 500°F, and a velocity of 100 ft/s…

Q: Consider 5.0 pounds per minute of water vapor at 100 lb/in2, 500°F, and a velocity of 100 ft/s…

Q: If a horizontal force of 890 N is developed by the water jet leaving the pipe on the 90° deflector…

A: Solution-The given values are as follows, Horizontal force(F)=890NEfficiency(η)=90%To DetermineThe…

Q: A flocculation tank contains 1800 m³ of water, which is mixed using paddles at an average velocity…

A: Given data- volume V=1800 m3,velocity gradient G=100/s,dynamic viscosity μ=0.798×10-3 Ns/m2, To…

Q: calcujate the reading of o barometer în mm of mercury 97.9 kPa corres ponding to an atmospheric…

Q: Determine the kinetic energy in joules, of a 2 gram riffle bullet traveling at 1640 ft/s

Q: A flocculation tank contains 1800 m³ of water, which is mixed using paddles at an average velocity…

A: Given data in question Volume Velocity gradient Temperature Dynamic viscosity To find out…

Q: What is the equivalent head (cm) of the kerosene (specific gravity = 0.8), if the head of water is…

A: Given- Specific gravity G=0.8, Head of water hw=500 cm=5 m, It is needed to find the equivalent head…

Q: Draw a sketch of typical specific energy diagram

Q: An instrumental for the analysis of trace hydrocarbons in air, or in the products of combustion uses…

Concept explainers

Thermal Processes

Some of the key areas where thermal processes find their application are:

Question

If heat absorbed by the engine = 15,000 Joule and Low temperature of 450 K High temperature of 850 K, what is the
%3D
efficiency by the Carnot engine?
52.94 %
O 74.50 %
O 47.06 %
15.34 %

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

5. Find the total weight of a 10 ft³ tank of oxygen if the oxygen is tank itself weighs 150 lb, and the pressurized to 500 psia, the temperature is 70°F? (a) 302 (b) 203 (c) 102 (d) 333 5
I need the answer as soon as possible
I need the answer as soon as possible
In the graph below, each unit on the horizontal axis is 1.90 103 m³ and each unit on the vertical axis is 0.200 atm. (a) Determine the change in internal energy of the gas if 2042 J of heat is added as it expands in volume along the direct path CA. 1306 J (b) To get the same change in internal energy, how much heat must be added to the gas as it goes along the path CBA? J just need help for part b B A
A spring-loaded piston-cylinder device contains 1.5 kg of carbon dioxide. This system is heated from 200 kPa and 25 °C to 1200 kPa and 300°C. Determine the total heat transfer to and work produced by this system.
I need the answer as soon as possible
at 38 degrees celsius and 218 kpa gage, the specific weight of a certain gas was 15.0 n/m^3. determine the gas constant of this gas in j/(kg-kelvin).
An object is launched at a velocity of 20 m/s in a direction making an angle of 25° upward with the horizontal. Find the total flight time of the object. * 1.41 sec 141 sec 1,72 sec What mass of water can be heated from 25.0° C to 50.0° C by the addition of 2825 J? * 27 kg 27 gm 22 gm
A condensing coil has 12 fins per inch. How many fins per centimeter doesthe coil have? Round the answer to the nearer hundredth.
Question 3.3 When the air with a pressure of 0.1 MPa and a specific volume of 0.8 m³/kg was provided into a compressor at a flow rate of 0.25 kg/s, its pressure became 0.7 MPa and its specific volume became 0.2 m³/kg. Through the compression, the specific internal energy was increased by 80 kJ/kg, and there was heat loss of 50 kJ/s to the environment. In this case, calculate the work [k]/s = kW] that the compressor did in unit time. Potential energy and kinetic energy can be negligible.
Steam enters a turbine at 30 bar, 300°C (u = 2750 kJ/kg, h = 2993 kJ/kg) and exits the condenser as saturated liquid at 15 kPa (u = 225 kJ/kg. h = 226 kJ/kg). Heat loss to the surrounding is 50kJ/kg of steam flowing through the turbine. Neglecting changes in kinetic energy and potential energy, the work output of the turbine (in kJ/kg of steam) is
Calculate the change in 5 m long copper wire when its temperature changesby 60º C.