An electrostatic precipitator (ESP) with 5600 m2of collector plate area is 96 percent efficient inreating 185 m³/s of flue gas from a 200 MWthermal power plant. It was found that in order toachieve 97 percent efficiency, the collector platearea should be 6100 m2. In order to increase theefficiency to 99 percent, the ESP collector platearea (expressed in m2) would be

Answered: Image /qna-images/answer/1594bb3d-c767-4d69-b75d-222189dbf2e6.jpg

An electrostatic precipitator (ESP) with 5600 m? of collector plate area is 96 percent efficient in reating 185 m³/s of flue gas from a 200 MW nermal power plant. It was found that in order to chieve 97 percent efficiency, the collector plate rea should be 6100 m2. In order to increase the efficiency to 99 percent, the ESP collector plate area (expressed in m2) would be

An electrostatic precipitator (ESP) with 5600 m? of collector plate area is 96 percent efficient in reating 185 m³/s of flue gas from a 200 MW nermal power plant. It was found that in order to chieve 97 percent efficiency, the collector plate rea should be 6100 m2. In order to increase the efficiency to 99 percent, the ESP collector plate area (expressed in m2) would be

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

(b) Yield of BOD analysis at 20°C with dilution factor, p=0.1 are as tabulated in Table Q2. Table Q2 (i) Plot graph 20°C, k20. Time (day) 0 1 2 3 4 5 BOD, Dissolve Oxygen, DO (mg/L) 6.9 5.7 4.9 4.2 3.7 3.3 vs time and determine the reaction rate constant, k at
The specifications of an electrostatic precipitator system used for collection of particles 150 μm in diameter are given below: Height of plates = 7.5 m Length of plates = 6 m Number of plates = 5 Gas flow rate = 19.5 m³/s Drift velocity = 0.18 m/s The collection efficiency of precipitator (in %) is
2. Families in a community in a developing country use large, 200.0 L drums to un-treated surface water. You are designing a device that is designed to dose the volume with a coagulant, stir to allow flocculation, then add chlorine tablets to disinfect the water. The water is 25 °C and initially contains 1.0E+09 particles per L. The initial particles can be assumed to be spherical, 15.0 micrometers in diameter, and with a density of 1.675 g/mL. a. If the drums have a diameter of 572 mm, how long will it take for the particles to completely settle without any coagulation or flocculation? (answer in seconds) You have determined that you can achieve complete destabilization of particles by achieving an ionic strength of 0.01 M or higher. If you use alum (Al2(SO4)3) as a coagulating agent, what mass of alum must be added per batch of 200 L? (answer in grams) How many joules of energy would be required to stir the drum at a mixing intensity of 150 s-' for 20 minutes? If the drum is stirred…
An ion exchange softener of 5 m3 volume is used to treat the raw water for a community. The absorptive capacity of medium is 90 kg/m3 at particular flow rate. The rate of flow from source is 25000 m3 /day. Determine the limiting hardness in treated water if ion exchanger softener is regenerated on daily basis
Biomass and substrate mass balance equations can be merged giving QwXR/VX=Y/X (Qo/V) (So-S)-kd (i) Prove that X= SRT/HRT Note that HRT = t and SRT = tc. (ii) If you are an engineer working in a wastewater consultancy company, and obtained the following data: - SRT = 20 days HRT 20 hours = (Y(So-S)/1+kd(SRT)). So = 350 mg/L S = 100 mg/L Y = 0.15 kd = 0.22 per day Calculate the increment of MLSS (%) required in the aerobic tank if the discharge BOD5 in the effluent needs to achieve 10 mg/L.
Poorly treated municipal wastewater is continuously discharged directly into a lake. The discharge from the wastewater plant into the lake occurs at a flow of Qd = 1 m3/hr. The concentration of phosphate (PO43, M = 95 g/mol) in the discharge flow (Cxd) that is decaying with first-order kinetics is 100 mg/L. The lake is a well-mixed water body of 100 m3. (Phosphate is naturally uptaken by algae with a first- order decay rate constant equal to 0.20/day.) The concentration of phosphate in the incoming river (Cx,r) is 10 mg P/L. The incoming river flow rate is Q, = 10 m3/hr. %3D a) Which of the following equations represent the correct mass balance equation? O va = CxQr - CxdQd -QoutCxvout" kCx,outV %3D O 0 = Cx,Qr + CxdQd -QoutCxvout" kCx,outV X,r O 0 = CxQr + CxdQd -QoutCxvout- kV O 0 = Cx,dQr + Cx,,Qd -QoutCxout- kCxoutV
An open tank contains 6.5 m of water covered with 3.5 mof kerosene (Specific weight = 8 kN/m3). Find thepressure at the interface and at the bottom of the tank. Explain your answer
A large fuel tank is in the shape of a cylinder. The material for the top and bottom ofthe cylinder costs $20/m^2, while the material for the lateral surface costs $15/m2. The volume of the cylinder must be 120m^3. Determine the dimensions of the most economical cylinder.Surface Area Formula use: ?? = 2??^2 + 2??ℎ Volume Formula use: ? = ??^2ℎ
Solve it
An oil of density 850 kg/m3 is pumped in a pipe of diameter 20 cm. The discharge is measured as 0.015 m/s. The drop in pressure in a length of 800 m of pipeline, both ends of which are at the same elevation is measured as 98 kPa. Assuming Re < 2000, calculate the value of absolute viscosity of the oil.
The value of the equivalent area of 160 liters is . . ft^3 O 6.76 O 4.85 5.13 O 5.65 O other answer
Read the question carefully and give me all right solutions. If you don't know the solution please leave it but don't give me wrong solution. If the initial dissolved oxygen of a 3 mL sample is 7.5 mg/L and after day 5 is 5.5 mg/L, with a k rate determined to be 2 mg/L. what is the BOD5 ? Ultimate BOD ? BOD 2 ? BOD 10? . Create a BOD graph (time vs BOD) .