Host A sends the information of size 3000 bytes to Host B using TCP protocol. As long as Host B receives each packet in size 1000 bytes, Host B must acknowledge Host A. We assume the header size in each packet is 40 bytes, the starting sequence number used by Host A is 1000, and the window size of the sender side is 3000 bytes. What is the value of SND.NXT when the second packet is sent out, but only acknowledged for the first 300 bytes of the first packet?  Question 7 options:

Q: In IPv4, the address format is a 32-bit numeric number that is frequently written as four octets…

A: Dear Student, The answer to your question is given below -

Q: Suppose that a TCP sender is sending segments with 100 bytes of payload. It sends five segments with…

A: In TCP connection, when a segment is transmitted successfully, receiver responds with acknowledgment…

Q: Host A sends the information of size 3000 bytes to Host B using TCP protocol. As long as Host B…

A: Option B is not correct because of the SND.UNA packet sequence would be from 1000 to 1999 but not up…

Q: An ISP is granted a block of addresses starting with 180.100.0.0/16. The ISP needs to distribute…

A:

Q: SMTP (Simple Mail Transfer Protocol) is the standard protocol for transferring mail between hosts…

A: Let's break down the effect of each rule in the provided packet filter rule set for allowing inbound…

Q: Consider a simple application-level protocol built on top of UDP that allows a client to retrieve a…

A: This is very simple. Let's see the function of the Stop and Wait Protocol: In Stop and Wait, Only…

Q: es. The delay be re shown. The 1

A:

Q: Suppose the segments arrive at Host B in the order Q, P, and R. What is the acknowledgment number on…

A: Acknowledgement number indicates the next expected byte.  The last byte number received by host B is…

Q: A router needs to transmit an IPv4 datagram with a total size of S bytes. The link layer of the…

A: ATM Adaption Layer 5 (AAL5) is used to send variables of length packets up to 65,535 octets in size…

Q: Host A and B are communicating over a TCP connection, and Host B has already received all bytes up…

A: Given data: Host A and B are communicating over a TCP connection, and Host B has already received…

Q: Host A sends the information of size 3000 bytes to Host B using TCP protocol. As long as Host B…

A:

Q: For NAT Network Address Translation Scenario: Jenny Bello is a small business owner selling and…

A: We need to answer questions related to private IPv4 address.

Q: Consider the figure below in which a TCP sender and receiver communicate over a connection in which…

A: Given that,number of segments TCP sender sends an initial window = 5Initial value of the sender…

Q: SMTP (Simple Mail Transfer Protocol) is the standard protocol for transferring mail between hosts…

A: IP Address:Each device connected to a computer network that employs the Internet Protocol is given a…

Q: SMTP (Simple Mail Transfer Protocol) is the standard protocol for transferring mail between hosts…

A: Introduction: Simple Mail Transfer Protocol (SMTP) is a protocol for sending emails. It is a…

Q: When Snort generates an alert message, it will usually start with a line like the one shown below:…

A: snort is an instruction detection system(IDS) that detects and alerts on unusual network activity.

Q: Host A sends the information of size 3000 bytes to Host B using TCP protocol. As long as Host B…

A: Please find the answer in step 2

Q: A subnet mask is a 32-bit number that masks an IP address, and divides the IP address into network…

A: 1) JUMP 2)15.0.0.0 below is the explanation.

Q: It is theoretically feasible for two hosts to communicate with one another by sending packets back…

A: Multiple packets may be delivered between two hosts over a single network connection when data is…

Q: A router has the following four active flows, and each flow has packets to transmit. Given FQ is…

A: Given, A router has the following four active flows, and each flow has packets to transmit. Given FQ…

Q: TCP is a connection-oriented protocol. This means that. a. there is a direct physical connection…

A: EXPLANATION: TCP (Transmission Control Protocol) is a network protocol that connects two hosts and…

Q: ASN.1 is an ISO standard used in many internet‑related protocols, especially those in the area of…

A: ASN.1 (Abstract Syntax Notation One) is an essential ISO standard that plays a crucial role in…

Q: Host A sends the information of size 3000 bytes to Host B using TCP protocol. As long as Host B…

A: As per bartleby policy I can attend only first part Please find the answer in step 2

Types Of Protocols

A network protocol is a collection of rules that governs the exchange of data between devices connected to the same network. In other words, network protocols are rules that specify how devices communicate or transfer data over a network. The sender and receiver systems must obey the standards to facilitate communication between them.