"he and hi are KJ/kg " m (h2 - hi) mgh 2505 - 2500 = 0.00981 (h) 509.68 m v? 2(9.81) V = 10 exis

Q: centrifugal pump operating under steady flow conditions delivers 2,270 kg/min of water from an…

A:

Q: A centrifugal pump operating under steady flow conditions delivers 2,270 kg/min of water from an…

A:

Q: The initial condition of air in an air compressor is 100 Kpa and 25 degrees Celcius and discharges…

A: Given Volume of cylinder can be determined as Determine clearance volume for given compressor

Q: A pump operates at 600 W, the mass flow rate of the liquid is 1 kg/s, at the inlet the fluid is…

A: Given data pump operates at 600 W, the mass flow rate of the liquid is 1 kg/s, at the inlet the…

Q: A DC driven pump running at 100 rpm delivers 30 litres per second of water at 40°C against a total…

A:

Q: Consider the system shown below for water with mass flow rate of 5 kg/s.

A: The properties of saturated liquid at a pressure of 35 kPa and 0 quality are h1=303.79 kJ/kg   The…

Q: A centrifugal pump having extemal and intemal diamcters as 750 mm and 400 mm respectively is…

A: Answer:  (a) 16 o (b) 123 kJFor a step-by-step solution have a look through the attached pictures of…

Q: A 1.6 m' tank is filled with air at a pressure of 5 bar and a temperature of 100°C. The air is then…

A: The molecules in an ideal gas do not interact with each; they continuously undergo collisions and…

Q: For a 10-ton-capacity refrigeration system, the pressure of refrigerant in the evaporator is 150…

A:

Q: 28. A centrifugal air compressor compresses 200 cfm from 12 psia to 90 psia. The initial specific…

A:

Q: A steam turbine receives a steam flow rate of 2kg/s and the power output is. 700 kW. The heat loss…

A: For solution refer below images. NOTE:- For specific enthalpy unit should be in KJ/kg.

Q: Air enters the tower at the rate of 60 kg/s.  The entrance enthalpy is 86 KJ/kg and exit enthalpy of…

A:

Q: (a) Calculate the required size of a receiver that must supply air to a pneumatic system consuming…

A:

Q: What would be the necessary bore and stroke of a single acting four- cylinder, 350 rpm ammonia…

A: Sir question (a) is solved. please post a question (b) to get a solution.

Q: SA centrifugal air compressor compresses 200 cfm from 12 psia to 90 psia. The initial specific…

A: A centrifugal air compressor compresses 200 cfm from 12 psia to 90 psia. The initial specific volume…

Q: A hollow steel propeller shaft, 20 ft. long with 15 in outer diameter and 12 in. inner diameter,…

A:

Q: A pump operates at 600 W, the mass flow rate of the liquid is 1 kg/s, at the inlet the fluid is…

A: Given: The power of the pump is P=600 W. The initial velocity of liquid is v1=0 m/s. The final…

Q: Leftover air at 20ºC and 100kPa is driven by a fan through a horizontal galvanized conduit of 1 m in…

A:

Q: A turbine passes 67.5 kg/h of steam at 200 km/h at 8 MPa and leaves at 0.5 MPa as wet steam with a…

A:

Q: Steam enters the turbine at the rate of 2.5 kg/s with enthalpy of 3200 kj/kg and exhaust enthalpy of…

A:

Q: A hydraulic vane pump running at 1800 rpm develops 2 L/s flow at 750 kPa. Volumetric efficiency is…

A: Given         Flow rate, Q = 2 L/s              Speed, N = 1800 rpm Overall efficiency = 0.8  Find…

Q: Q.2: A refrigeration system using refrigerant 22 is to have a refrigerating capacity of 80 kW. The…

A: Refrigerant=R22Refrigerating capacity, Q˙e=80 kWEvaporating temperature, Te=-8oCCondensing…

Q: A single acting, twin cylinder, Ammonia compressor with bore equal to stroke is driven by an engine…

A: given; ⇒lets take bore =D⇒stroke=L⇒then;⇒bore(D)=stroke(L)⇒number of cylinder (K)=2⇒speed of engine…

Q: Air enters an adiabatic compressor at 100 kPa and 17 C and leaves at 600 kPa and 211 C. The mass…

A: Given data as per question Mass flow rate =5 kg/min The temperature at entry =170 c =290 k The…

Q: An air cooled refrigerant condenser (similar to the ones used for home air conditioners) is shown,…

A:

Q: A boiler requires 100 000 m3/hr of standard air. The mechanical efficiency of fan to be installed is…

A:

Q:

A: Given : The Gas flow rate The Surface pressure The Compressor inlet pressure The pressure increased…

Q: Q . It is proposed to pump 8,000 kg/h of toluene at 114 oC and 1.1 atm abs pressure from the…

A: Write the given data:

Q: 4. to convert the kinetic energy of water into the mechanical shaft energy. Water enters the…

A:

Q: Dr. Ayser Muneer Turbomachines Example (5-2) An inward flow reaction turbine is supplied with water…

A:

Q: water source in the municipality is from an open reservoir and will supply to a pressure tank that…

A: Since the question asked by you contains more than three sub-parts, so according to our guidelines,…

Q: Identify what is the system in this problem and write the general energy balance equation (no need…

A:

Q: he condensing pressure for a Rankine engine is 0.001325  MPavac. Calculate the following for steam…

A:

Forms of Energy

Energy is described as the capability to accomplish a task, like the ability to push a block by applying force on it. It is a quantitative property that is used to accomplish work on an object.