H.W.4: Two 6-in.-wide wooden boards are to be joined by splice plates that will be fully glued onto the contact surfaces. as shown in Figure 2 . The glue to be used can safely provide a shear strength of 120 psi. Determine the smallest allowable length L that can be used for the splice plates for an applied load of P= 10.000 lb. Note that a gap of 0.5 in. is required between boards (I) and (2).

H.W.4: Two 6-in.-wide wooden boards are to be joined by splice plates that will be fully glued onto the contact surfaces. as shown in Figure 2 . The glue to be used can safely provide a shear strength of 120 psi. Determine the smallest allowable length L that can be used for the splice plates for an applied load of P= 10.000 lb. Note that a gap of 0.5 in. is required between boards (I) and (2).

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

please explain in neat hand writing so I can undertstand
- once answered correctly will UPVOTE!!
please help solve and explain and include FBD please
Problem 17 A joint shown has the basic layout shown in the diagram below. (All dimensions on the diagram are in inches.) A single pin of diameter 0.5 inches (A = 0.2 in2) holds together the yoke and bar as shown. The material has an ultimate strength in tension of 80 ksi, and an ultimate strength in shear of 45 ksi. The load P has a value of 10000 lb. By examining the shear stress in the pin, the normal stress in the yoke, and the normal stress in the bar, find the overall factor of safety for the joint. P=10,000 lb YOKE -0.5 PIN BAR P=10,000 lb 1.5- 20 1.5 0.5 0.5
• Bars (1) have a cross-sectional area of A₁ = 0.65 in.2 and a length, L₁= 7 ft. • Bars (1) are made of cast iron with an elastic modulus of E₁ = 24,000 ksi, a coefficient of thermal expansion, a₁ = 12.3 x 10-6/°F and yield strength of oy = 120 ksi. • Bar (2) has a cross-sectional area of A₂ = 1.45 in.² and a length, L₂ = 5.5 ft. • Bar (2) is made of stainless steel with a coefficient of thermal expansion, a₂ = 10.6 × 10-6/°F. • The stress-strain diagram provided below presents the results of the stainless steel's (i.e., Bar (2)) bar tension test. • There is a gap of A = 0.1 in. in the connection at B and a = 3 ft. • All bars are unstressed before a load P = 12 kips is applied and the temperature increases by AT = 40°F. Stress-strain diagram for stainless steel bar: (1) a Stress (ksi) L2 Rigid bar 120 100 80 60 40 20 0 0 0 B (2) P a (1) C Upper scale L₁ Connection details at node C Lower scale. C 0.025 0.050 0.075 0.100 0.125 0.150 0.175 0.006 0.008 0.010 0.012 0.014 0.002 0.004 Strain…
the answers are pmax=195kN and the angle is 57.8. can you explain?