Given the sketch shown below, the diameter of the plunger Dp = 8 cm. The Ram diameter is Dr = 48 cm. The efficiency is 100%, the stroke of the plunger is 18 cm. The ram has to raise a load F2 = 2kN. Find: A) the force f1 exerted on the plunger. B) the number of strokes needed to raise the load given above by a distance of 10 cm. C) the volume of oil pumped if the load moves by 20 cm ( using plunger force in a ) D) what will be the new diameter of the ram piston if the new load force is 16 times the force exerted in the plunger the diameter of the plunger is kept to 8 cm.

Q: A) Perform an analysis of the stenosed artery (diameter D and length L)using the Bernoulli equation…

A: (A) Draw the diagram of stenosed artery which is narrowed by atherosclerosis. Here section 1 is…

Q: Given the velocity components ; Vz = 2 Xz ; Vg=3Xs find a) Material and spatial form of movement b)…

A: Given : To find : a) Material and spatial form of movement b) material speed c) Velocity gradient

Q: 1) M H h On the cylindrical container above with a cross section area A we open a hole as shown with

A: Givencylindrical container below with A=cross section area of container Ah= area of the hole

Q: A cylindrical container is filled with a liquid until it reaches a height of one meter with respect…

A:

Q: cylindrical swimming pool has a diameter of 34ft, the sides are 7ft high, and the depth of the water…

A: Given: The diameter of poold=34 ft The height of poolh=7 ft The depth of waterd=5 ft The water…

Q: A 4-inch diameter cylinder moves a 25000 Ib load 24 inches in two seconds. Determine: a. The…

A: Given data,D=4instroke length L=24 inLoad =25000lbtime t =2s

Q: An incompressible fluid flows through a pipe that has two sections: a wide section with a diameter…

A: Introduction In fluid dynamics, an incompressible flow is a flow in which the density is constant…

Q: A 140 m long pipeline runs between two reservoirs, both ends being under water, and the intake end…

A: Given:Length of the pipe, L=140 mDifference between the water levels in the two reservoirs, H=40 ma…

Q: 1. À Pelton wheel performance data are collected in the following table. Turbine speed (RPM) 3000…

A: Given: P=1 barQ˙=18.4 L/min=0.3067 L/s=0.0003067 m3/secN=3000 rpmT=2.4 Ncm=0.024 N.md=25 mm=0.025…

Q: Hydraulic motor calculations Theoretical flow = 1.5 GPM RPM output = 100 RPM Mechanical power =…

A:

Q: a) A suction pump. Consider a pipe that is inserted vertically into water. By suction, the pipe is…

A: According to Bartleby guidelines, we can solve three subpart of a question at a time. Please post…

Q: A wind generator is installed. It is determined that the capacity factor of the installation is 29%…

A:

Q: a) Develop an equation for the head (in ft) developed by the pump described by the chart as a…

A: To find the equation for head developed by the pump and pump efficiency from the above chart for the…

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.