Given the following sections: Station 2 + 020 a b + 2.5 +3.15 2.65 Station 2 + 080 d 2.5 -2.5 -3.65 Base for cut = 12 m, Sideslope for cut = 1.5:1 Base for fill = 12 m, Sideslope for fill = 2:1 Required: 1. What is the stationing of the end of excavation? 2. Find the volume of fill by end area method. 3. Compute the volume of excavation by end area.

Given the following sections: Station 2 + 020 a b + 2.5 +3.15 2.65 Station 2 + 080 d 2.5 -2.5 -3.65 Base for cut = 12 m, Sideslope for cut = 1.5:1 Base for fill = 12 m, Sideslope for fill = 2:1 Required: 1. What is the stationing of the end of excavation? 2. Find the volume of fill by end area method. 3. Compute the volume of excavation by end area.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A shovel having a 6-cy bucket whose cost per hour, including the wages to an operator, is $85 will excavate well-blasted rock with a swell percent of 60%, and load trucks under the stated condition below. The maximum digging height of the machine is 30 ft. Determine the cost per bank cubic yard. Use the average fill factor for well-blasted rock and assume the optimum height of cut for this material is 50% of the maximum digging height. Condition Height of excavation (ft) Angle of swing (degrees) Efficiency factor (min per hr) Edit View Insert Format Tools Table 24 75 40 Cycle Time 9 sec 6 sec 4 sec Load Swing loaded Dump Swing empty 5.sec
Why does the Hydraulically placed earth fills are not recommended?
Calculate the net cut/fill for Station A, B, C and D, and draw the Mass Diagram Ordinate of the earthwork. The details of the cut and fill is given below. The location between each station is 6 meters apart. Station A - Cut (30 m³), Fill (10 m?) Station B- Cut (10 m2), Fill (20 m?) Station C- Cut (60 m?), Fill (20 m?) Station D- Cut (10 m?), Fill (50 m2)
Draw the figure to illustrate your understanding of all the problems.Show complete formulas and solutions.Round off to 3 decimal places. Enclose all finalanswers in a box.
Show complete solution and answer in 4 decimal places The areas of the cross-section of an excavation are 3,897.23 sqm, 4,596.01 sqm, and 3, 786.30 sqm. The spacing of each cross-section from each other is 9.80m. a) Find the volume of Excavation by End Area Method. b) Find the Loose Volume of the soil excavated if it has a swell factor of 15.5%. C) A Dump Truck is rented Php 20,000 per day and can make 7 trips in a day. Find the cost of hauling if 5 Dump Trucks with a capacity of 10 cu. m. per trip is used.
Draw the figure.
Prove the following mathematical relationship with the drawing if necessary
The areas in cut of two points of level sections that are 75m apart are 36sqm and 72sqm. Side slope is 3H:2V and base width is 10m. Determine the Volume of excavation using the PRISMOIDAL METHOD and correct the computed volume using the formula for PRISMOIDAL corrections. Please answer in 3 decimal places and provide figure
What is the area of cut in square metre? what is the average cut in metres? what is the volume of cut in cubic metres? what is the area of the fill in metre square? what is the average fill? what is volume of full in cubic metres? QUESTION 3. Determine the fill and cut volumes of the 10 m by 10 m grid below. A B 0.7 F 0.7 C 0.8 F 0.8 C 2 1 2
Q3). Calculate the cross section area of cut and fill for the followings: St. 1) h= 2m cut at center line, s left = 5, and s right = - 3 St. 2) h = 0.6m fill at center line, s left = 9, and s right=7 St. 3) h=0 at center line, s left =-6, and s right - 10. (bo= 10 m, n = 1 in cut, and n = 2 in fill) for all sections.
Match the excavator to the job: 1. Excavation for a 1” water line to your home. Length of trench= 50 feet, depth of trench 5 feet 2. Excavating the vertical face of a gravel pit from a location in the bottom of the pit 3. Excavating with a long reach in a pond filled with water removing gravel from bottom of pond. 4. Excavating in a deep vertical pit for a pump station foundation pit walls have steel sheet piling to protect from cave-ins. A. Clamshell bucket on crane B. Dragline bucket on crane C. Hydraulic excavator D. Hydraulic shovel