Given a pressure at point A equivalent to 67 N/m^2, calculate the pressure at point B if d1=37 cm, d2=17cm, d3=55 cm, d4=29 cm, and d5=31cm. The density of oil, mercury, and water are 981 kg/m^3, 14,070 kg/m^3, and 1050 kg/m^3 respectively.

Given a pressure at point A equivalent to 67 N/m^2, calculate the pressure at point B if d1=37 cm, d2=17cm, d3=55 cm, d4=29 cm, and d5=31cm. The density of oil, mercury, and water are 981 kg/m^3, 14,070 kg/m^3, and 1050 kg/m^3 respectively.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: If H = 4 m, D = 10 m, h = 0.4 m and k = 0.0001 cm/s, the porewater pressure at A is most nearly…

A: Given data in question Flownet Upstream and downstream head Coefficient of permeability To find…

Q: A circular tank of diameter 3 m contains water up to a height of 4 m. The tank is provided with an…

Q: Find pressure at 10 m depth

A: This question is related to the fluid properties from fluid mechanics.

Q: In the figure shown, with 35 liters/sec of sea water (w = 12.68 kN/m) flowing from 1 to 2, the…

Q: SITUATION 2. A triangular tank facing downward has unit weight equal to 27 kN/m3 and weighs 0.6 kN.…

Q: A tank is 11 meters long, 6 meters wide, and 4 meters high. The tank is filled with gasoline, which…

A: Density of liquid = 750 kg/m3 g = 9.8 m/s2 Determine a. Hydrostatic pressure on the bottom of the…

Q: A dam is used to store water, and a circular gate which is hinged at its bottom edge is used to…

A: given: h1=1mh2=6m location of c.g from water surface (h¯)=1+62=4m

Q: Analyze the figure below and determine the absolute pressure in the tank. Take the density of water…

A: Please refer the attached image for complete solution. THANK YOU.

Q: In figure, if the cylinder volume 5.4239 m3. The buoyancy force is

A: According to given data Volume of cylinder =0.4239 m3 Taking density of water = 1000 kg/m3Taking…

Q: Consider a hydraulic jack being used in a car repair shop, as in the figure. The pistons have an…

Q: If H = 4 m, D = 10 m, h = 0.4 m, k = 0.0001 cm/s and y = 0.2 m, the porewater pressure at C is most…

Q: Take sea water to be 3% heavier than fresh water and assume it is incompressible. What is the…

Q: A body weighs 1000 kg when exposed to a standard earth gravity g = 9.81 m/sec2. What is its weight?…

A: Solution 1: Weight of a body is define as the gravitational force on a mass of body. So,…

Q: What is the water pressure (in psi) at a dep of water is 50 °F, the specific we emperature 1 35 ft 2…

A: yw = 62.4 lbf/ft3p1 = 0 atm z1 = 250 ft z2 = 215 ftTo find the water pressure (p2 ) -

Q: 36 m/s 36 m/s →→ water jet ↓5 cm block

Q: Assuming sea water to be incompressible and unit weight is 64 lb/cuft, what is the pressure in tons…

Q: . Determine the difference in pressure between points A and B from the figure above. Kerosene…

A: The unit of pressure is kPa , but in option it is given in m.

Q: (2) In the following Figure below, determine the gauge pressure at point A Density of mercury = 13.6…

Q: As illustrated in the figure, an inclined circular gate with a diameter of 4.6 meter has water on…

Q: To what height will the jet of fluid rise for the conditions shown in the figure?

Q: 3. The figure below shows a large open tank filled with water, which exits through a pipe. If the…

A: We have to determine the value of reading on the pressure gauge at the point C with respect to the…

Q: A body, with a volume of 2 cubic meter, weighs 40 KN. Determine its weight when submerged in a…

Q: A vertical cylindrical tank with a diameter of 6 m and a depth of 2 m is filled with water to the…

A: given data : Diameter =6 mheight = 2 mγw20∘c=9.79 KN/m3γw50∘c=9.69 KN/m3

Q: A vertical conduit is carrying oil (S=0.95) as shown in figure 2. A differential mercury manometer…

A: Given data, the specific gravity of the oil is 0.95. we have to Determine the difference in…

Q: A vertical wall shown in the figure is 20 meters wide. Determine the height, h, of the oil in the…

Q: = Air has a gas constant of R = 287 [J/(kg C)]. At standard temperature 15°C and pressure, air has a…

A: (1) Gas constant(2) Standard temperature(3) Dynamic viscosity(4) Density(5) Flow rate/Discharge(6)

Q: Two springs support two identical blocks as shown. Ifs 1.2m, calculate the weight of each block. Im…

A: Given:- Two identical blocks are supported by two spring The stiffness coefficient of both the…

Q: P, = 90kPa ethyl alcohol,p = 773.3 kg/m³ 60 m oil,p = 899.6 kg/m³ 10 m water,p = 979 kg/m³…

Q: Question 3 A triangular water trough is "a" metres wide and "a" metres deep, as shown in Figure 3.…

A: Given data:- The density of water is, ρw=1000 kg/m3 (Ignore the atmospheric pressure) g=9.81 m/s2…

Q: If H = 4 m, D = 10 m, h = 0.4 m and k = 0.0001 cm/s, the porewater pressure at A is most nearly…

A: Pore water pressure is the pressure of groundwater contained in gaps between particles within a soil…

Q: Q2:- Calculate the absolute pressure at point B as shown in fig.(2). Neglect the density of air (25…

Q: If we measure y₁ = 5.05 ± 0.10 cm with m₁-50.00 ± 0.10 g and y2=29.70 ± 0.10 cm with m2=315.56 ±…

A: SolutionThe spring constant (k) is given by the formula: k = (m1 + m2) * g / (y2 - y1) where g is…

Q: TION ASAP!!!

A: Using equation :h=xSmSw-1x=b-ch=1.00-0.651.601-1h=0.21m

Q: Open to atmosphere, pa hi= 38cm -Mercury (13,593 kg/m³) Water h,=76 cm B and C are at the same…

A: Atmospheric pressure- It is the pressure exerted by the atmosphere and it is measured by Barometer.…

Q: A jet of water coming out of a nozzle at a speed of 30 m/s hits a vertically fixed plate. Find the…

Q: Refer to the given figure. Given: a = 42cm, b= 15cm, and c= 34cm Water a C 40 cm Gate Unknown liquid…

Q: The spring is fixed to block A and block B is pressed against the spring. If the spring is…

Q: 1. If in figure , the pressure at m is 20 Ib per sq.in., what is the corresponding pressure at n…

A: Pressure is defined as the force exerted by the unit area. The pressure of the fluid is calculated…

Q: Aceite 65 kPa SG = 0.72 75 cm Aire Ageua 30 cm -Mercurio h frgua SG = 13.6

Q: The spring is fixed to block A and block B is pressed against the spring. If the spring is…

Q: ed. A liquid of specific weight of 9KN/m^3 entirely fills the container. Consider H = 8m, R =2.4m,…

Concept explainers

Pressure and Stress

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 3 layered density tower includes 30 cm glycerin (D = 1260 kg/m3), 25 cm oil (D = 950 kg/m3), and 20 cm gasoline (D = 740 kg/m3). What is the absolute pressure against the bottom of a container?
As shown in the figure, determine the gage pressure on the bottom of the tank in kPa. Considering the total gage pressure at the bottom of the tank what will be the absolute pressure if the barometric pressure if 725 torr?
As illustrated in the figure, an inclined circular gate with a diameter of 3.9 meter has water on one side. Calculate the location (meters) of the center of pressure along with the inclination of the gatefrom the bottom. a = 2.5 meters 30⁰
A concrete dam given in the figure has water 13 m deep acting on its vertical sides. The coefficient of friction between the soil and the dam is 0.60. - 23.5. How far in meters is Yconcrete m³ the vertical resultant force from the toe? a = 15 m b= 13 m 2m a b 2m 2m 15m
An initially empty tank on Earth is being filled with water so that the height of the water in the tank increases at a steady rate. Which one of the following graphs best describes the gauge pressure P at a point on the bottom of this tank as a function of time t during the filling process? Assume the tank starts filling at time t = Os and that the top of the tank is open to the atmosphere. The atmospheric pressure does not change during the process. The water in the tank does not overflow or reach the top of the tank during this process. A) D) P B)
Please solve the question.
In the figure,which fluid will a pressure of 700kPa first be achieved? P, = 90kPa ethyl alcohol,p = 773.3 kg/m³ 60 m oil,p = 899.6 kg/m³ 10 m water,p = 979 kg/m³ glycerin,p =1236 kg/m³ 5 m 5 m
Mato 1
Determine the natural frequency of the simple spring-mass system shown.
Q-8 In an aeroplane model of size 1/10 of its prototype the pressure drop is 7.5 kN/m². The model is tested in water. Find the corresponding pressure drop in the prototype. Take Density of air = 1.24 kg/m³.Density of water = 1000 kg/m³. Viscosity of air = 0.00018 poise Viscosity of water = 0.01 poise
7. Two water tanks are connected to each other through a mercury manometer with inclined tubes, as shown in figure. If the pressure difference between the two tanks is 20 kPa, determine the value of ? in degrees. (2 decimal)