A vertical cylindrical tank with a diameter of 6 m and a depth of 2 m is filled with water to the top at 20 °C. If the water is heated to 50 °C, calculate the amount of water that will spill over? The unit weight of water at 20 °C and 50 °C is 9.79 kN/m³ and 9.69 kN/m³ , respectively

Q: A water tank full of water of 5 m wide, 8 m long and 4 m high, calculate the pressure (in psi) at…

A:

Q: Find pressure at 10 m depth

A: This question is related to the fluid properties from fluid mechanics.

Q: SITUATION 2. A triangular tank facing downward has unit weight equal to 27 kN/m3 and weighs 0.6 kN.…

A:

Q: A 1.5 m square tank, 3m tall is drained by a 25- mm-diameter orifice located at the its bottom. If…

A: Initial head (H1)=3m Time(t) =45min Cd=0.62

Q: Analyze the figure below and determine the absolute pressure in the tank. Take the density of water…

A: Please refer the attached image for complete solution. THANK YOU.

Q: An oil of viscosity 0.5 N s/m? and relative density 0.6 is flowing through a circular pipe of…

A:

Q: Steady-state flow exists in a pipe that undergoes gradual expansion from a diameter of 15 cm in to a…

A: "SInce, you have asked multiple question, we will solve the first question for you. if you want any…

Q: A 3-m-diameter vertical cylindrical milk tank rotates at a constant rate of 12 rpm. If the pressure…

A: Rotates at constant rate (N) = 12 rpm Pressure at the centre of the bottom surface is 130 kPa.…

Q: The water pressure acting on a masonry dam varies as shown. If the dam is 20 ft wide, determine the…

A: Consider the figure,

Q: 9.2 Determine the change in volume of a thin cylinder of original volume 65.5 x 10-3 m³ and length…

A:

Q: Q.2. Air flows through a constant-area duct is connected to a reservoir at a temperature of 500°C…

A: Given T=500℃ P=500kpa Heat lost=250kj/kg D=0.02m

Q: An open tank has a vertical partition and on one side contains gasoline with a density p = 700 kg/m³…

A: Gate will start to open when the force from water side will be greater than gasoline side When Force…

Q: A sharp-edged circular nozzle with a cross-sectional area of 10 cm2. Water flows from it under the…

A: Actual velocity calculation:…

Q: A child playing in the pool is using a cylindrical can as a boat for his toy soldiers. The can…

A: Following are the given information. Weight of can, F = 778.5 N  Height, H = 1.5 m Diameter, d =…

Q: The depth of water in a cylindrical tank 4 m in diameter is increasing at the rate of 0.79 m/min.…

A:

Q: Problem 2. The hydraulic jack shown below is filled with SAE 30 at 38°C. Neglecting the weight of…

A: Given :

Q: A vessel containing liquid, S = 1.5, is rotated about a vertical axis. The pressure at one point…

A:

Q: A vertical wall shown in the figure is 20 meters wide. Determine the height, h, of the oil in the…

A:

Q: A cylindrical tank of water is 2.0 m in diameter and 3.5 m tall. There is a 2.0 cm diameter hole at…

A: Diameter of the tank= 2.0 mHeight of the tank = 3.5 mDiameter of the hole: 2.0 cmHeight of the…

Q: P, = 90kPa ethyl alcohol,p = 773.3 kg/m³ 60 m oil,p = 899.6 kg/m³ 10 m water,p = 979 kg/m³…

A:

Q: Question 3 A triangular water trough is "a" metres wide and "a" metres deep, as shown in Figure 3.…

A: Given data:- The density of water is, ρw=1000 kg/m3    (Ignore the atmospheric pressure) g=9.81 m/s2…

Q: As shown in the figure below, water behind a dam enters an intake pipe at a pressure of 24 psia and…

A: To solve this problem, first we need to calculate the specific gravity. Then the Bernoulli equation…

Q: An oil of viscosity 0.1 Ns/m2 and relative density 0.9 is flowing through a circular pipe of…

A:

Q: As shown in Figure B2, a cylindrical steel structure (density p = 8000 kg/m³) loosely sits…

A: When a fluid flows relatively past a body, every differential surface area experiences a pair of…

Q: Figure P8.19 shows a pipeline through which water flows at a rate of 0.06 m3/s. The pipe is 3000 m…

A: The given figure is shown below:

Q: A conical tank 4.5m on top and 4,7m tall has a 60mm diameter orifice at its bottom for its outlet.…

A: The given data is as follows: Top width of conical tank=4.5 mHeight of conical tank=4.7 mDiameter of…

Q: The head loss of a 300 m length of tube having a diameter of 79 mm is 99 m. Oil flows through the…

A:

Q: An oil of density 850 kg/m³ is pumped in a pipe of diameter 20 cm. The discharge is measured as…

A: Given data, Oil density =850 kg/m3diameter= 20 cmdischarge = 0.015 m3/sdrop in pressure= 800 mto…

Q: Solve and Draw the figure completely labelled with all the notations used in your solution. A fire…

A: Consider the free body diagram ;

Q: 9. The vapor pressure of water at 100 °C is 101 kN/m², because water boils under these conditions.…

A:

Hydrogen Energy

Energy is a quantity that cannot be defined, its existence can only be felt. In simple language, if a system possesses energy, it can do a specific kind of work. There are many forms of energy sources which people can use to obtain work. Solar energy, tidal energy, hydroelectric energy, geothermal energy, wind energy are some of the renewable energy sources which are primarily used for the production of electricity.