force on the pin from the slot, respectively, are

Q: Air at 1 atmosphere and a temperature of 60 F enters 1/2-in. id tube with a velocity of 80 fps. The…

A:

Q: 3. Find the axial forces on members FH, FI, GI and HI. (Use any method) 40 kN 40 kN 40 kN H Upload…

A:

Q: The 198-lb exerciser is beginning to execute a bicep curl. When in the position shown with his right…

A:

Q: A pole is stabilized in a plane using four cables. The tension in each cable is shown in the figure.…

A: If P(x1,y1) and Q(x2,y2) are two points located in a plane, then the position vector PQ can be…

Q: 9-67. Determine the principal stress, the maximum in-plane shear stress, and average normal stress…

A: Given:σx=350 MPaσy=-200 MPaζxy=500 MPa

Q: Calculate the tension in each cable around the pulley.

A:

Q: Determine the tensions in cables AB, AC, and AD please do not round off anythin

A:

Q: The yoke-and-rod connection is subjected to a tensile force of 135 kN. The material of pin A has a…

A:

Q: Find the greatest weight that can be applied without the front wheels lifting off the ground. The…

A:

Q: if the forces are

A:

Q: A person pulls on a 500 N desk with a 200 N force acting at 30° angle above the horizontal. The desk…

A: QuestionA person pulls on a 500 N desk with a 200 N force acting at 30° angle above the horizontal.…

Q: The springs in are shown in the equilibrium position. 3m 3 m KAC = 20 N/m KAB = 30 N/m wwwww KAD-40…

A:

Q: Express your answer to three significant figures and include the appropriate units. ? Fmax = Value…

A:

Q: If a cylinder had an internal diameter of 2 in and operates at a pressure of 300 psig, calculate the…

A: Write the expression to obtain the area.

Q: plve for the forces in wires a, b, c and d. 45° b. 60 150 lb C.

A:

Q: Which force member is equal to zero?

A:

Q: A vacuum gauge mounted on a condenser reads 0.56 m Hg. What is the absolute pressure in the…

A:

Q: loft 146t 144 146t SPreader Barc Cenkred Fube, Tube A A Cogo Net

A: Draw the free-body diagram of cargo net with tube A.

Q: Equation of Equilibrium. Referring to the free-body diagram of the beam shown in Fig. a, +1£F, = 0;…

A:

Q: The force per unit area.

A: Given; Flow between the plates is solely due to motion of the top plate.Top plate is sliding…

Q: PROBLEM: 3 Determine 4 2 ft H B C 2ft2ft 80lb force in G 80 lb D LL 60lb F 1.5A+ ↑ 2ft ↓ 40 16 BC,…

A: Determine force in BC, BH HC and label under tension or compression.

Q: You can use the lever to increase force, distance, and speed. True or False? (answer only)

A:

Q: The red arrows represent the force of?

A: The red arrow represents the direction of motion of the Object.

Q: In a hydraulic press, the small cylinder has a diamter of 1 in, while the large piston has a…

A: To Find : The force on the large piston. Given :  The diameter of larger piston is d=8 in. The…

Q: Which of the following does the frictional forces depend on: 1- Smoothness of the surface 2- Normal…

A: Frictional Force: The force exerted between surfaces to resist the relative motion between them is…

Q: In the parallel jaw pliers shown, the clamping jaws remain parallel as objects of various sizes are…

A: Parallel jaw pliers     Force applied to the handles = 60 N     To find Out:- What is the force…

Q: The forc on member BD is 758.73N I need to find the force at Ay and the total force at A?

A:

Q: Determine the force in each member of the truss shown in Fig. and indicate whether the members are…

A:

Q: What is the normal force between the crate and the wedge? What is the smallest force P needed to…

A:

Q: 6500 N 4.5 m- 4.5 m - A 1.5 m 2 m E B

A:

Q: The specialty wrench shown in the figure is designed for access to the hold-down bolt on certain…

A: Given data: F=290 Na=80 mmd=115 mmh=170 mmθ=26° Need to determine the moment about the point O and…

Q: change in the forces so D is 300N and B is 200N. Need help solving for Ay and Cy.

A: Draw the free-body diagram of the given system.

Q: Determine the horizontal force required to hold the plate.

A:

Q: I am looking for the moment and the tension required to hold the bracket up

A: Given: The angle made by the cable from the horizontal is: →p=38.66° And all the distances are given…

Q: The block shown in the figure below is acted on by its weight, W = 1300 Lbs, a horizontal force H =…

A:

Q: A 1-lb ball A is thrown horizontally at block B at 20 ft/s, where positive motion is to the right.…

A:

Q: 2. The size of 1/2 in. would refer to the with regard to ACR copper tubing.

A: The correct option is (b)  Outer Diameter (OD)

Q: Complete the following gas tables:

A: Given data  Given table

Q: C and Z components of the 80 lb force R. 3° B.

A:

Free Body Diagram

The system of forces acting on a body tends to either rotate it or make the body undergo motion. In general, when an external agent exerts a force on a body, the body undergoes translational motion and rotational motion. The body has six degrees of freedom under the influence of that force. Here, three degrees of freedom are from the translational motion while the other three are from the rotation motion. However, sometimes the bodies are not allowed to undergo any motion and are fixed, under such conditions the body is said to be constrained.