For the equilibrium below, pKa₁ = 7.9 and pKa2 = 10.1. At what pH is [HA] equal to[A²-]?H₂A <=> H+ + HA <=> 2H+ + A²-OpH = 7.9pH < 7.9OpH > 10.1pH = 10.1

Answered: For the equilibrium below, pKa₁ = 7.9…

Science

Biochemistry

For the equilibrium below, pKa₁ = 7.9 and pKa2 = 10.1. At what pH is [HA] equal to [A²-]?

Biochemistry

9th Edition

ISBN:9781319114671

Author:Lubert Stryer, Jeremy M. Berg, John L. Tymoczko, Gregory J. Gatto Jr.

Publisher:Lubert Stryer, Jeremy M. Berg, John L. Tymoczko, Gregory J. Gatto Jr.

Chapter1: Biochemistry: An Evolving Science

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Calculate the pH at which the β-carboxyl group of aspartic acid is 75.0 % dissociated. The pKa of the β-carboxyl group in aspartic acid is 3.70.
None
If your initial absorbance from undiluted crude dialysate is 4.50, determine the fold dilution needed to yield an absorbance of approximately 0.700. If you want to prepare 1.0 ml of diluted crude, what volume (mL) of crude dialysate must you add? Your Answer: Answer units It is possible to estimate the molar extinction coefficient of a protein from knowledge of its amino acid composition, as shown from your experiences with EXPASY. From the molar extinction coefficient of tyrosine, tryptophan and cystine (cysteine does not absorb appreciably at wavelengths >260 nm, while cystine does) at a given wavelength, the extinction coefficient of the native protein in water can be computed using the following equation: e(Protein) = #(Tyr)*E(Tyr) + #(Trp)*E(Trp) + #(Cystine)*E(Cystine) Where (if A280 measured in water): E (Tyr) = 1490, ɛ (Trp) = 5500, e (Cystine) = 125 Estimate the molar extinction coefficient of lysozyme using the above equation and the amino acid composition data you found…
This is a plot under standard conditions of free energy corresponding to a chemical reaction of A+B to C+D. What will happen if only C+D are present under standard temperature and pressure? Please explain why.
Given the balanced equation, Na2SO4(aq) + BaCl2(aq) → 2 NaCl(aq) + BaSO4(s), how many moles of BaCl2 are required to produce 1.02 g of NaCl?
The melting points of a series of 18-carbon fatty acids are: stearic acid, 69.6 °C; oleic acid, 13.4 °C; linoleic acid, −5 °C; and linolenic acid, −11 °C.(a) What structural aspect of these 18-carbon fatty acids can be correlated with the melting point?(b) Draw all the possible triacylglycerols that can be constructed from glycerol, palmitic acid, and oleic acid. Rank them in order of increasing melting point.(c) Branched-chain fatty acids are found in some bacterial membrane lipids. Would their presence increase or decrease the fluidity of the membrane (that is, give the lipids a lower or higher melting point)? Why?
At what pressure in atm does ethane (C₂H₆) have a density of 37.2 g/L at 75.0 °C?
Given that the AG" values for the hydrolysis of glucose 1-phosphate and glucose 6-phosphate are approximately -21 kJ/mol and –14 kJ/mol, respectively, which statement is true regarding the isomerization shown? glucose 1-phosphate → glucose 6-phosphate O The reaction can likely proceed in either direction and will therefore depend on the concentrations of glucose 1-phosphate and glucose 6-phosphate. O Only the anabolic direction will occur because the free energy change is positive. O The reaction will proceed in both directions simultaneously. This reaction can only proceed in one direction and must be the rate limiting reaction for this point in metabolism.
Acetone, CH3–(C=0) –CH3, and urea, NH2–(C=0)–NH2, have similar chemical structures. (a) Compare the possible intermolecular forces for acetone with those for urea. (b) Compare the intermolecular forces between phycocyanin and acetone with those between phycocyanin and water. Briefly explain how acetone disrupts the folding in phycocyanin. (c) Compare the intermolecular forces between phycocyanin and urea with those between phycocyanin and water. Briefly explain how urea disrupts the folding in phycocyanin. (d) Compare your experimental observation on the disruption of phycocyanin folding in the presence of acetone with that in the presence of urea. Briefly explain whether your comparison is consistent with the properties of acetone and urea.
The reaction quotient is Q=1.6×10-26 Part B What pH is needed to produce this value of Q if the concentration and pressure values are [Br2]=2.50×10−4M , [Br−]=11.65M, [SO42−]=9.50M, and PSO2=3.50×10−5atm ? Express your answer numerically to two decimal places.
The quantitative differences in biological activity between the two enantiomers of a compound are sometimes quite large. For example, the D isomer of the drug isoproterenol, used to treat mild asthma, is 50 to 80 times more effective as a bronchodilator than the L isomer. Identify whether each of the indicated atoms in isoproterenol is a chiral center or achiral. HO HO chiral center OH C. H achiral CH₂ Isoproterenol H H H— - N с CH 3 achiral chiral center CH 3
If a particular polypeptide that is very compact in 0.01 M NaCl expands considerably in 0.5 M NaCl, what forces are probably important in determining its overall size and shape?