Answered: For a transmission line, L=1.8mh/m…

For a transmission line, L=1.8mh/m C=0.01pF/m, then the phase velocity of the line is O a. 2.3X108 O b. 64X108 O c. 2.9X108 Od. 6.28X108

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.35MCQ: The affect of the earth plane is to slightly increase the capacitance, and as the line height...

See similar textbooks

Related questions

Q: The line with symmetrical spacing then the equilateral spacing (Deq) for the three-phase…

A: The line with symmetrical spacing then the equilateral spacing (Deq) for the three-phase inductance…

Q: Derive the relation of SWR in terms of ZL (load impedance) and Zo (Characteristic impedance)

Q: Impedances Z1=5.83<-59 and Z2=8.94<63.43 are in series and carry and effective current of 5.0 A.…

Q: For the given circuit below a. Calculate E, IR, and IL, in phasor form. b. Calculate the total…

Q: Practically in the field, the transmission line connected between the generating station and…

A: We need to tell about transmission line between generation and substations

Q: An inductive circuit draws a line current of 10A. If the reactive component of the line current is…

A: Given, The total current is I=10A And, the reactive component of Total current is 6A i.e, Isinθ=6

Q: ER Es ET IR URS Is !T Rine Rine Rine N Road Road Road U₂ bad Load Load Load

A: Answer : given that Line-to-line voltage URS=400∠30° V Line Resistance Rline=2 ohms Load…

Q: Q) A source of 10 V and frequency 1000 KHz with internal resistance of 10 2 is connected to the…

Q: Problem 6: Given the circuit below, find the total complex, average, and reactive power absorbed by…

A: In this question, We need to determine the total complex power, average power and reactive power.…

Q: A 50-ohm load is attached to a transmission line with characteristic impedance of ZO = 93.6 – j3.64…

Q: Determine the power factor of the system with v(t) = -120sin(wt - 30)V and i(t) = -12sint(wt - 50)A.…

Q: a transmission line has an impedance of 4 12 Ohms/phase, Find the per-unit impedance of this line on…

Q: Transformation [6] Problem A delta and star configuration are shown in Figure 7. Transform the delta…

A: Given ZAB =27.3∠0°ZBC = 27.3∠-30°ZCA =27.3∠30°

Q: 1o(t) 60 2 20 cos (4t – 15°) 5 H 0.01 F

Q: A 220 Ω resistor is in series with an 80 mH inductor. The AC source is 48 at 1 kHz. The power…

A: The power factor for series RL circuit can be written as, p.f=cosθwhere…

Q: A certain 3-phase equilateral transmission line has a total corona loss of 53 kW at 106 kV and a…

Q: Which of the following parameter/s is represented as connected in shunt in the equivalent circuit…

A: Any transmission line is represented by four components namely Resistance, inductance capacitance…

Q: The Full-load and No-load of a regulator are 5.2V and 5.3V, respectively. Then the % load regulation…

Q: A 1002 transmission line with T = 0.447Z63.5°. Find Z1. Select one: a. 25 + 25j О Б. 25 — 25j O c.…

A: consider the given question

Q: 4. The characteristic impedance of a transmission line with impedance and admittance of 16 and 9…

A: In this question, We need to choose the correct options What is characteristics impedance Zc?

Q: 10 Ω j4 Ω + E₁ Μ ~) Vs 2:1 The Ioad on the right is absorbing 650 W - j200 VAR. V, = 80 / 0° V. I1…

A: Given in question, Power absorbed by the load and load voltage are, SL=650 W-j200 VARVL=80∠0° V we…

Q: (³) d- Р [PA~Y (pv₁] V (PVq₂) V p

Q: 2. Determine V and I of a short transmission line, if Z is... a. -300 +j2009 and 200-300 are in…

Q: When a resistor is connected across the terminals of an ac generator (117 V) that has a fixed…

A: The generator voltage and current when only resistor was connected to the generator,When the…

Q: Problem 3.8 Use A-to-Y transformation to find the voltages v1 and v2 in the circuit shown in Fig.…

Q: A certain industrial load has an impedance of 0.6 angle 30 ohms at a frequency of 60 Hz. What…

A: In this question, We need to determine the value of capacitor C to decrease the total angle from 30…

Q: Phase velocity of voltage wave in a distortion less line having characteristic impedance 0.1 kQ,…

Q: R = 80 www VR ZT + E = 100 V / 0° Z X₁ = 60 voo VL

A: We need to find out total impedance and voltage and current for given circuit .

Q: A. Consider the impedance network below. Calculate the total impedance between terminals A and B.…

Q: 2. For the network shown in the figure and the applied source: liz lic IR R 3 kN X1 4 kN Xc 2 kN i;…

Q: Consider the network given in figure below where the numbers indicate admittances per unit. Find the…

A: To study the load flow analysis of the big network power system, Bus admittance matrix is used.…

Q: Ql: Derive the porimitive flow table for the following asynchronous ciricut.

A: Flow table in asynchronous sequential circuits is same as that of state table in synchronous…

Q: The nature of the characteristic impedance of the line is: a. inductive b. could be any one of these…

Question

For a transmission line, L=1.8mh/m C=0.01pF/m, then the phase velocity of the line is
O a. 2.3X108
Ob. 64X108
O c. 2.9X108
Od. 6.28X108

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Single Phase Controlled and Uncontrolled Rectifiers

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

An inductive circuit draws a line current of 10A. If the reactive component of the line current is 6A, then power factor of the circuit is ___ . a. 0.6 lagging b. 0.857 lagging c. 0.5 lagging d. 0.5 leading
Each phase of a transmission line is a bundle of 4 conductors that form a square with all sides equal to d=33 cm. Each conductor is stranded and has GMR = 0.5 cm. Find GMR of the bundle to be used in inductance calculations. Express your answer in cm with 2 digits after decimal point
A Three-phase transposed line is composed of one conductor per phase with flat horizontal spacing of D = 14 meters, as shown in the below figure. The conductors have a diameter of 2.6 cm and a GMR of 1.012 cm. Find the capacitance per phase per kilometer of the line. a C D D 2D Select one: O a 0.0088 microF/Km Ob. 0.0077 microF/Km Oc 1.455 microF/Km Od. None of these
One circuit of a single-phase transmission line is composed of three solid 0.12" radius wires. The return circuit is composed of two 0.15" radius wires. Find the inductance of the complete line in mH/mi. The distance between wires are 40" horizontally and 25" vertically. A. 2.54 mH/mi B. 2.478 mH/mi C. 2.488 mH/mi D. 2.567 mH/mi Provide Clear Explaination
Q. 40
A single-phase transmission line consisting of two conductors, the radius of each conductor is 0.4 cm, the distance between the conductors is three and half meters and the height above ground is eight 1-The capacitance in uF/km without effect of ground is 2-The capacitance in pF/km with effect of ground is
A three-phase transposed line is composed of one ACSR Bobolink conductor per phase with a horizontal spacing of 11 meters as shown in the figure. phase with a horizontal spacing of 11 meters as shown in the figure. The conductors have a diameter of 3.625 cm and a RMG of 1.439 cm. Calculate the inductance and capacitance to the neutral of the line.
A 3-phase transmission line has its conductors at the corners of an equilateral triangle with side 3 m. The diameter of each conductor is 1.63 cm. The inductance of the line per phase per km is (a) 1.232 mH (c) 1.093 mH (b) 1.182 mH (d) 1.043 mH
The instantaneous power absorbed by the load in a single-phase ac circuit, for a general R LC load under sinusoidal-steady-state excitation. is (a) Nonzero constant (b) Zero (c) Containing double-frequency components
The affect of the earth plane is to slightly increase the capacitance, and as the line height increases, the effect of earth becomes negligible. True False
A three phase transposed line is composed of three conductor bundle. The conductors have a diameter of 2.1793 cm and a GMR (r) of 0.8839 cm. The spacing between the conductors in the bundle is 45 cm, and the GMD-18.8988 m. a b 0,0 45- O 0,0 I D D H 2D and the capacitance per phase is C then the GMRC of the line is
A transmission line has two aluminum conductors in bundle. The self GMD of each conductor is 8.90 mm and the distance between the conductors and phase is 40 cm and 9 m, respectively. What is the inductance of the line per phase? A. 2 μH/m B. 4 μH/m c. 1 μH/m D 3 μH/m