Following are measurements of soil concentrations (in mg/kg) of chromium (Cr) and nickel(Ni) at 20 sites in the area of Cleveland, Ohio. These data are taken from the article"Variation in North American Regulatory Guidance for Heavy Metal Surface SoilContamination at Commercial and Industrial Sites" (A. Jennings and J. Ma, J EnvironmentEng, 2007:587–609).Cr:511341402574496322424269244252761083824183430191Ni:1593423612216334553928337235414032837 47164354376Construct a histogram for each set of concentrations.a.b.Construct comparative boxplots for the two sets of concentrations.Using the boxplots, what differences can be seen between the two sets ofconcentrations?c.

Given the measurements of soil concentrations (in mg/kg) of chromium (Cr) and nickel (Ni) at 20…

Answered: Following are measurements of soil…

MATLAB: An Introduction with Applications

6th Edition

ISBN:9781119256830

Author:Amos Gilat

Publisher:Amos Gilat

Chapter1: Starting With Matlab

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

can you please help me solve sub-parts e, f, g
"1ÄUZ☺ 8:17 K/s You Just now 1. Consider the data below. This data represents the number of miles per gallon that 30 selected four-wheel drive sports utility vehicles obtained in city driving 12 17 16 | 14 16 18 16 18 17 16 17 15 15 16 16 15 16 19 10 14 15 11 15 15 19 13 16 |18 16 20 i) Calculate mean (Using Direct and Indirect method), median and mode of ungrouped data.
3. Consider a gas in a piston-cylinder device in which the temperature is held constant. As the volume of the device was changed, the pressure was meas- ured. The volume and pressure values are reported in the following table: Volume, m Pressure, kPa, when I = 300 K 1 2494 2 1247 3 831 4. 623 5 499 416 (a) Usc lincar interpolation to cstimate the pressure when the volume is 3.8 m. (b) Usc cubic spline interpolation to estimate the pressurc when the vol umc is 3.8 m'. (c) Usc lincar interpolation to cstimate the volume if the pressure is meas- urcd to be 1000 kPa. (d) Usc cubic spline interpolation to estimate the volume if the pressure is mcasured to be 1000 kPa.
Please use the accompanying Excel data set or accompanying Text file data set when completing the following exercise. An article in Urban Ecosystems, "Urbanization and Warming of Phoenix (Arizona, USA): Impacts, Feedbacks and Mitigation" (2002, Vol. 6, pp. 183–203), mentions that Phoenix is ideal to study the effects of an urban heat island because it has grown from a population of 300,000 to approximately 3 million over the last 50 years and this is a period with a continuous, detailed climate record. The 50-year averages of the mean annual temperatures at eight sites in Phoenix are shown below. Check the assumption of normality in the population with a probability plot. Construct a 95% confidence interval for the standard deviation over the sites of the mean annual temperatures. Site Sky Harbor Airport 23.3 Average Mean Temperature (°C) Phoenix Greenway 21.7 Phoenix Encanto Waddell 21.6 21.7
The following data represent the results from the specific gravity test performed in a soil laboratory including twenty samples of sand. * :The value of Root Mean Square is Specific Gravity 2.30-2.39 Number of Samples 1 2.40-2.49 2.50-2.59 3 2.60-2.69 2.70-2.79 6. 7 2.80-2.89 1 3.6-3.8 2.97-3.0 2.4-2.5 2.85-2.95 2.75-2.84 1.5-2.0 2.6-2.7 2.32-2.39
2. The 2 data sets are replicates of pH values of an alkaline solution (set A) and acidic solution (set B). (1) which is more precise? (2) which is more accurate? 11.2, 10.7, 10.9, 11.3, 11.5, 10.5, 10.8, 11.1, 11.2, 11.0 (x, = 10.7) B) 5.2, 6.0, 5.2, 5.9, 6.1, 5.5, 5.8, 5.7, 5-7, 6.o (x = 5.8) %3D
4.) A person's muscle mass is expected to decrease with age. To explore this relationship, a researcher randomly selected 10 persons from ages 40 to 79 years old and measured their muscle mass (unit). The result is as follows: X (age) Y (muscle mass) 71 64 43 67 56 73 68 56 76 65 82 91 100 68 87 73 78 80 65 84 Based on the given data, do the following: a) Plot the scatter diagram of the given data. [3pts] b) Obtain the regression line equation. [4pts] c) Estimate the muscle mass when age of the person is 60 years old. [3pts] 5.) Recognize how each shape has transformed. [2pts each] a.) b.) c.)
3. Air samples. An environmental study looked at suspended particulate matter in air samples (µg/m3) at two different sites. Data are listed here. Construct a stemplot of for each site (here is where side-by-side stemplots would be helpful but not required) and then compare the distribution of suspended particulate matter between the two sites (remember to mention center and spread). No calculations necessary. Site 1: 68 22 36 32 42 24 28 38 Site 2: 36 38 39 40 36 34 33 32
5. Two different analytical tests are used to determine the impurity level in steel alloys. Ten specimens are tested using both procedures, and results are tabulated as follows: Specimen Test 1 1.3 Test 2 1.5 1.4 1.2 1.2 1.3 1.8 1.6 1.5 1.3 6. 1.7 1.4 1.8 1.4 1.4 1.3 1.3 1.6 10 1.5 1.7 Assume the impurity levels are normally distributed, construct a 95% confidence interval for the ratio of variances of impurity levels measured using the two different analytical tests. ii. Based on your answer in part (a), are you 95% confident that the variances of impurity levels are different when measured using different analytical tests? Verify your answer. 1234 n0709
Following are measurements of soil concentrations (in mg /kg) of chromium (Cr) and nickel (Ni) at20 sites in the area of Cleveland, Ohio. These data are taken from the article "Variation in NorthAmerican Regulatory Guidance for Heavy Metal Surface Soil Contamination at Commercial andIndustrial Sites" (A. Jennings and J. Ma, J. Environment Eng, 2007:587-609). Cr: 260 19 36 247 263 319 317 277 319 264 23 29 61 119 33 281 21 35 64 30Ni: 435 377 359 53 38 38 54 188 397 33 92 490 28 35 799 347 321 32 74 508 (a) Construct a histogram for each set of concentrations. (b) Find the 1st, 2nd and 3rd quartiles for the Cr concentrations (c) Find the 1st, 2nd and 3rd quartiles for the Ni concentrations.
How much noisier are streets where cars travel faster? The article "Modeling of Urban Area Stop-and-Go Traffic Noise" (P. Pamanikabud and C. Tharasawatpipat, Journal of Transportation Engineering, 1999:152–159) reports noise levels in decibels and average speed in kilometers per hour for a sample of roads. The following table presents the results. Speed Noise 28.26 78.1 36.22 79.6 38.73 81.0 29.07 78.7 30.28 78.6 30.25 78.5 29.03 78.4 33.17 79.6 Compute the least-squares line for predicting noise level (y) from speed (x). b. Compute the erTor standard deviation estimate s. Construct a 95% confidence interval for the slope. Find a 95% confidence interval for the mean noise level for streets whose average speed is 30 kilometers per hour. Can you conclude that the mean noise level for streets whose average speed is 30 kilometers per hour is greater than 78 decibels? Perform a hypothesis test and report a. C. d. e. the P-value. f. Find a 95% prediction interval for the mean noise level for…
The authors of the paper "Statistical Methods for Assessing Agreement Between Two Methods of Clinical Measurement"† compared two different instruments for measuring a person's ability to breathe out air. (This measurement is helpful in diagnosing various lung disorders.) The two instruments considered were a Wright peak flow meter and a mini-Wright peak flow meter. Seventeen people participated in the study, and for each person air flow was measured once using the Wright meter and once using the mini-Wright meter. Subject Mini-WrightMeter WrightMeter Subject Mini-WrightMeter WrightMeter 1 512 494 10 445 433 2 430 395 11 432 417 3 520 516 12 626 656 4 428 434 13 260 267 5 500 476 14 477 478 6 600 557 15 259 178 7 364 413 16 350 423 8 380 442 17 451 427 9 658 650 (a) Suppose that the Wright meter is considered to provide a better measure of air flow, but the mini-Wright meter is easier to transport and to use. If the two types of meters produce…

SEE MORE QUESTIONS

Recommended textbooks for you

MATLAB: An Introduction with Applications

Statistics

ISBN:

9781119256830

Author:

Amos Gilat

Publisher:

John Wiley & Sons Inc

Probability and Statistics for Engineering and th…

Statistics

ISBN:

9781305251809

Author:

Jay L. Devore

Publisher:

Cengage Learning

Statistics for The Behavioral Sciences (MindTap C…

Statistics

ISBN:

9781305504912

Author:

Frederick J Gravetter, Larry B. Wallnau

Publisher:

Cengage Learning

MATLAB: An Introduction with Applications

Statistics

ISBN:

9781119256830

Author:

Amos Gilat

Publisher:

John Wiley & Sons Inc

Probability and Statistics for Engineering and th…

Statistics

ISBN:

9781305251809

Author:

Jay L. Devore

Publisher:

Cengage Learning

Statistics for The Behavioral Sciences (MindTap C…

Statistics

ISBN:

9781305504912

Author:

Frederick J Gravetter, Larry B. Wallnau

Publisher:

Cengage Learning

Elementary Statistics: Picturing the World (7th E…

Statistics

ISBN:

9780134683416

Author:

Ron Larson, Betsy Farber

Publisher:

PEARSON

The Basic Practice of Statistics

Statistics

ISBN:

9781319042578

Author:

David S. Moore, William I. Notz, Michael A. Fligner

Publisher:

W. H. Freeman

Introduction to the Practice of Statistics

Statistics

ISBN:

9781319013387

Author:

David S. Moore, George P. McCabe, Bruce A. Craig

Publisher:

W. H. Freeman

SEE MORE TEXTBOOKS