FIODICH INO. 2 The frame shown below is subjected to the load of 1.5 kip. For the pins at A and B has allowable shear stress tallow 5000 psi. Pin A is subjected to double shear, whereas pin B is subjected to single shear. Based on this information answer the following question: A W 5 ft- B 5 ft 2 ft 5 ft D 1.5 kip

Q: A thin and weightless beam is supported by a pin connection at 4 and by a roller at B (see figure…

A:

Q: The uniform link AB, has a mass of 3 kg and is pin connected at both of its ends. The rod BD, having…

A: The given figure is shown below:

Q: The rigid beam is supported by three rods, each having a cross- sectional area of 850 mm². Rods AB…

A: Area of rod (A) = 850 mm2For 2014-T6 Aluminium,α =25×10-6 /°CE = 69 GPaFor 304 stainless steel,α =…

Q: B 1 A 1/2 IP 1/2 IP 1/2 D A frame ABCD is supported by a roller at A and is on hinge at C as shown…

A:

Q: Please solve the following problem with step by step solutions

A:

Q: Question 3 Consider the beam below: (a) Determine if the beam is statically determinate or not, (b)…

A: Given, A beam:- Number of Members = m= 4 Number of joints =j = 5 Reaction = R= 1+1+3=5

Q: For the beam shown, using the Müller-Breslau principle, do the following: (a) Draw the influence…

A:

Q: Please help solve Quiestion 3 part A

A: Given data in question  Load 60 kN Length 18 m Internal hinges To find out  Indeterminacy  Note Ds=…

Q: Determine  Y component of reaction at A Y component of reaction at B X component of reaction at E…

A:

Q: Member ABCD in figure below lies in the plane of the paper. If length L is large compared with the…

A: Consider beam section ABC and draw free body diagram

Q: Question 1) Determine the x and z components of reaction at the journal bearing A and the tension in…

A: F1 = -800 k F2 = 350 j

Q: 4.0m A 2358 Fixed Y 3.0m B Hingo at F Intorn 2.0m 25 KN To at 2.0m D and C D 10 KN/m E 3.0m 3.0m 15…

A: When a hinge is present, there is no restriction on rotation, and when another hinge is present, the…

Q: What is the maximum load, F, that can be applied such that the reaction at C does not exceed 150kN…

A: Asked: To determine the largest value of load F, such that the reaction at support C does not exceed…

Q: L B Determine the reaction at the roller support and draw the bending moment diagram for the beam…

A:

Q: A IS a Tixed connec Lion. a) determine the normal force the pin at C exerts on the smooth slot. b)…

A:

Q: ying two points loads L

A:

Sizing Joists and Rafters

In civil engineering and building construction, joists and rafters are the major components including beams and columns. Almost every structural construction including buildings, skyscrapers, bridges, commercial complexes, and so on makes use of joists and rafters to provide structural integrity to the building. Joists are primarily thick long pieces of metals, concrete, or wood that are used to support the floor and ceiling. On the other hand, rafters form the major component of pitched roofs, which are a series of sloped long pieces extending from a ridged area that makes contact with the plane area of the wall. They account for the load-bearing of the building along with the beams.