NOW REVIEW VIEW5-12- == 1.TT E¶‹ParagraphA Text Direction -[]Align Text-Convert to SmartArt-5ооALLG½ \^ { } ☆neArrange QuickStyles-SolutionDrawingExample 6Four channels are multiplexed using TDM. If eachchannel sends 100 bytes/s and we multiplex 1 byte perchannel,lesShape Fill-FindShape Outline - ac ReplaceShape EffectsSelect -Editing1- show the frame traveling on the link,2- the size of the frame,3- the duration of a frame, the frame rate, and the bit ratefor the link.Frame 4 bytesA

Given here a TDM Based question and asked to fine the frame size, duration of the frame, frame rate,…

Example 6 Four channels are multiplexed using TDM. If each channel sends 100 bytes/s and we multiplex 1 byte per channel. 1- show the frame traveling on the link, 2- the size of the frame, 3- the duration of a frame, the frame rate, and the bit rate for the link.

Example 6 Four channels are multiplexed using TDM. If each channel sends 100 bytes/s and we multiplex 1 byte per channel. 1- show the frame traveling on the link, 2- the size of the frame, 3- the duration of a frame, the frame rate, and the bit rate for the link.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Q1. Binary data are transmitted through an AWGN channel with SNR = 5 dB and bandwidth of B Hz. Channel coding is used to ensure reliable communication. a) What is the maximum bit rate for data transmission in terms of channel bandwidth? b) If the bit rate is increased to 3B, how much the channel SNR must be to ensure reliable transmission of data?
Please answer with solution You digitize an analog signal that has a frequency bandwidth of 16kHz, using a bit depth of 8. What data rate must be supported? a. 640 kbps b. 64 kbps c. 32 kbps d. 256 kbps
For a 16 ary PSK signals having bit rate equal to 250 kbps the BW efficiency will be? A 1 B 1.5 C 2 D 0.5
b) Consider the below figure in which three hosts, with private IP addresses 10.0.1.12, 10.0.1.15, 10.0.1.18 are in a local network behind a router configured with NAT that sits between these three hosts and the larger Internet. IP datagrams being sent from, or destined to, these three hosts must pass through this NAT router. The router's interface on the LAN side has IP address 10.0.1.25, while the router's address on the Internet side has IP address 135.122.199.206. NAT translation table WAN side addr LAN side addr .1.. .1. D: S: D: D: .., .1. Suppose that the host with IP address 10.0.1.12 sends an IP datagram destined to host 128.119.180.182. The source port is 3376, and the destination port is 80. Find the source and destination IP addresses in packets at step 1,2, 3 and 4. Packet Source IP (S) Destination IP (D) 1 2 3
With respect to time-division multiplexing (TDM), frequency division multiplexing (FDM) and code division multiplexing (CDM), which one of the following statements is false? O CDM assigns a unique code to each signal. The direct sequence technique is used in TDM, whereas, frequency hopping technique is used in FDM. OTDM assigns all the available BW to each signal for a specific time slot. Frequency hopping is a form of the CDM technique. OCDM assigns all the available BW to each signal for all time. OFDM assigns a specific part of available BW to each signal for all time.
Q16: A FDM system uses SSB – SC modulation and AM main carrier modulation. There are forty (40) equal amplitude voice input channels; each bandlimited to 3.3 kHz. A 0.7 kHz guard band has allowed between channels and below the first channels. (a) Determine the final transmission BW. (b) Compute the degradation in signal- to- noise of input No. 40 when compared to input No.1, assuming that PSD of noise (two – sided) is f2 uw/Hz. Ans: 160 kHz, 36 dB.
Twenty two sources, four with a bit rate of 400 Mbps, ten with a bit rate of 200 Mbpsand eight with a bit rate of 100 Mbps are to be combined using TDM. If the unit size is20 bits determine the following questions:i. How this can be achieved?ii. Input time slotiii. Frame Sizeiv. Output time slot
QUESTION 1 Refer to an 8-bit adder in Figure Q.1b. Circuit X is a 4-bit Ripple-Carry Adder and circuit Y is a 4-bit Carry-Look ahead Adder. Assume all FA are implemented using two HA and 1 OR gate, delay for gate XOR = 2t, OR = AND= 1t, carry generate g¡ = 1t, and carry propagate pi =lt. Determine the propagation delay to generate C4, S3, C8, and S7. a74 b7:4 a3:0 b3.0 C8 C4 Y 4 S74 S30 Figure Q.1b Answer: tpd (C4) = tpd (S3) = tpd (C8) = tpd (S7) =
An alternativeapproach that is similar to ADSL; uses coaxial, fiber-optic or twistedpair cable for short distances (300 to1800 meters) a. Very High Bit Rate DSLb. High Bit Rate DSLc. RADSLd. SDSL
8) Data packets containing 100 bits are transmitted over a communication link A transmitted bit is received in error with probability p, independent of other bits. a) What is the probability that k bits received are in error? b) Probability that 3 or less bits are received in error.
Type your question here A FDM system uses SSB-SC modulation and AM main carrier modulation. There are forty (40) equal amplitude voice input channels; each bandlimited to 3.3 kHz. A 0.7 kHz guard band has allowed between channels and below first channels. (a) Determine the final transmission BW. (b) Compute the degradation in signal- to- noise of input No. 40 when compared to input No.1, assuming that PSD of noise (two - sided) is f2 uw/Hz.
During the period of call, other users can share the same channel in FDMA. a) True b) False