EX. 5.3 At a point in the structural member, the stresses are represented as shown below. Employ Mohr's circle to determine (a) the magnitude and orientation of the principal stresses and (b) the magnitude and orientation of the maximum shear stress and associated normal stresses. In each case, show the results on a properly oriented element. Sol. 40 MPa 30 MPa 80 MPa

Q: At a point on the free surface of a stressed body, the normal stresses are 20 ksi (T) on a vertical…

A:

Q: Determine approximately the principal stresses of a point whose stress states are shown below.…

A: In the above stress diagrams,  are not given with values so considered 0.

Q: For the given state of stress, determine the planes with compressive normal stress equal to 15 MPa.…

A:

Q: A set of stresses applied on the 50-mm x 50-mm ABCD plate cause the plate to deform as shown where…

A:

Q: 2.16. The stress at a point is defined by the components Oxx = MPa, Ozz = 70 MPa, Ory = -80 MPa, ơyz…

A:

Q: 2.4. The stress at a point is defined by the components Og =0 MPa, Oyy =100 MPa, Oxy = Oyx = -40…

A: Given Data⇒σxx=0 MPaσyy=100 Mpaσxy=σyx=-40 MPaProblem definition⇒Problem says find principle…

Q: s, (c) the orientation of the planes maximur num in-plane shearing stress, (e) the cor

A: Given data sigma x = 18 kpsi sigma y = 12 kpsi shear stress = -8 kpsi  required  Principal stress…

Q: Given the plane element shown which is an element acted upon by combined stresses. a. Use Mohr's…

A:

Q: Draw Mohr's circle that describes each of the following states of stress.

A: Given data:- σx =-8 ksi σy =12 ksi τxv=-6 ksi To draw:- Mohrs circle

Q: Two vertical forces, each of magnitude P = 22 kips, are applied to a beam of the cross section…

A:

Q: B

A: Given DataHorizontal force at end D of the lever, P=150 lbThe diameter of portion AB of the lever,…

Q: 5. consider a point in a structural member that is subjected to plane stress. Normal and shear…

A: if you have any doubt please comment

Q: 2. A figure shows a state of stress; determine the shearing stresses and normal stresses after the…

A: Given data σx=8 ksiσy=-12 ksiτxy=6 ksi Here, σ represents the normal stress and τ is the shear…

Q: Problem 2. Amaterial element in plane stress is subjected to stresses: = -5000 psi Ox Oy = -2000 psi…

A:

Stress transformation

The term stress indicates the measure of internal forces that develop due to an external force's application on an object. When a specific external force is applied to an object, internal stress generates in the material. The value of stress can obtain by taking the ratio of the externally applied force and cross-sectional area of the object. There are different types of stress depending on the type of external force.