Answered: Environmental Engineering-2…

Environmental Engineering-2 Evaluate the size and slope of a sanitary trunk sewer serving a population of 0.4 million. Water consumption is estimated to be 300 lpcd?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: A wastewater treatment plant is being designed for a small, growing community. Average flow to a…

Q: A tank has 40L of sewage runoff. It initially consists of 60% water and 40% pollutants. Another…

Q: 39 286 7.900 Determine the possible flow into MH DI from the WWS piping in Chesapeake Bay, which is…

A: Total sewage flow per person = 1200 L/day / 3.1 = 387.1 L/day/personTotal flow into MIH DI ≈…

Q: Design a sanitary sewer from MH 5 to MH 6. Show your steps to get full score. Given: 100…

A: GIVEN: 5 dwelling units per gross acre area from MH5 TO MH6 A3=30 acres total dwelling unit from…

Q: The diameter of a sewer pipe is 500 mm, Coeff. of roughness is 0.012 and slope of energy gradient is…

A: To find maximum discharge

Q: briefly explain why there is flow observed in the sewer when there is no rainfal

A: INTRODUCTION: Sewer system is designed to transport the waste water . runoff water from the…

Q: During heavy rainstorms, sewer systems in some older cities can be overwhelmed with water. This can…

A: The various impacts of sewage being discharged into waterways are: Now a day’s there is an…

Q: How does feed rate feed inlet diameter, diameter of vorters finder and diameter of apex influence…

A: The answer is below:

Q: Q- If in a district of area 30 hectare has density of population 300 per hectare and quota for water…

A: Area of district = 30 hectarePopulation = The average rate of sewage produced is =?

Q: a. Why do we need an accurate estimation of the sewage flow? b. In a residential area, there are 250…

A: (a) An accurate estimation of sewage flow is crucial for the efficient and effective…

Q: Which one of these processes is considered losses in the sub - surface flow ? A- Groundwater flow.…

A: To find subsurface losses :-

Q: Mention four (4) important ways to improve uniformity of water distribution in a sprinkler system

A: Irrigation is the artificial method of watering to the crops to ensure that sufficient moisture is…

Q: You were involved in the design of a drain for an urban road. What were the limitations that you…

A: Solution: Rational Method or Rational Equation: The formula for the calculation of runoff or peak…

Q: The sewage collection system is comprised of pipes of three diameters of 1.00m, 0.50m and 0.10m,…

A: Given Data: Diameter of pipe 1 is d1=1 m. Diameter of pipe 2 is d2=0.5 m. Diameter of pipe 3 is…

Q: F E Water Tower Hydraulics Pump A в Figure 1 Water Supply and Distribution System ¢ ¢ ¢ ¢ ¢

A: Given data: No. of villa's = 15 No. of peoples present in one villa = 20 Total no. of peoples = 15 x…

Q: Calculate the required capacity of the pipe distribution system

A: Given:- The annual quantity delivered to the city = 120,000,000 m3 The population of the…

Q: Shown below is the table of minimum requirements for Water Closets. What is the minimum number of…

A: Given, Industrial building with 400 occupants To find : Minimum number of water closets

Q: Using the ASCE and Griff methods, estimate the average, peak, and low rates of flow in the sewer…

A: As per company guidelines we are supposed to answer only the first three sub-parts. Kindly repost…

Q: For the storm sewer system shown below, determine the required diameter of the sewers; extended from…

Q: A wastewater that has TOC concentration of 200 mg/L is to be treated by a fixed-bed granular carbon…

A: concentration=200mg/l flow=227m3/d Ceff=20mg/TOC

Q: A wastewater treatment plant receives, at an average, 75% and 125% of water supply during dry and…

A: Given Data: The average municipal water demand (Liter per capita day)=550 lpcd Do the following to…

Q: i. Environmental Policy? How environmental policy is formulated through policy cycle? What are sewer…

A: ANS 3 To Calculate the Energy of individual waste material first we have to know some properties…

Q: estimate the average flow rates. Also,

Q: During the winter storm of February 13 to 17 2021, the power company of City of Birds, requested the…

A: Elevation of water at lake birds (ha) = 50 mElevation of water at storage tanks (hb) = 100 mLength…

Q: A wastewater treatment plant treats a wastewater at a flowrate of 10 million liters per day. The…

Q: Biological wastewater treatment is the exclusive territory of microorganisms, higher organisms such…

A: ANSWER " TRUE"

Q: Q1: A mid size city with populations of 62000, 70000 and 81000 for the years 1990, 2000 and 2010,…

Q: A transmission main needs to be sized from a new well field to the water distribution system.…

A: Average flow rate, To find: The required pipe diameter size to avoid soil deposition.

Q: total Average Day Demand in a Development is 52,000gals, Determine the required volume of water tank…

A: Given Average demand per day 52,000 gallons Additional requirements 20% Fire demand 350pgm for 30…

Q: What is the required diameter (in mm) for a sewer that will drain a catchment with 250 people? The…

Q: 9- The slope of sewer shall be : A-Given in the direction of natural slope of ground B-Given in the…

A: The slope of sewer shall be :- Given option A) Given in the direction of natural slope of ground B)…

Q: Calculate the total wastewater quantity that will be produced from the said tehsil.

A: The wastewater quantity depends on the water demand of any particular regions for various purposes.…

Q: Determine the required water supply flow volume (gpm) required for a planned development that will…

A: The given data is as follows: Population=13,000Area of upholstering shop=10,000 ft2

Q: : Design a sanitary sewer for a City “A”, using the following data: - Population of the…

A: Given- Population of the city (P)= 8000) personsAverage water consumption, Qavg = (80) Lpcd Area…

Q: A water treatment plant is designed to treat 1 m³/s of raw water. It has 14 sand filters. Surface…

A: To determine the loading rate with 2 filter out of service of routine back washing.

Q: For Smart irrigation System List three(3) nonfunctional requirements for your project

A: The smart irrigation project is a technology approach that seeks to optimise and raise the…

Q: A water treatment plant is designed to treat 1 m³/s of raw water. It has 14 sand filters. Surface…

A: Given- Discharge Q=1 m3/s, 14 sand filters, Surface area SA=50 m2, 2 filters out of service,

Q: A wastewater treatment plant has 155000 Ib of mixed liquor volatile suspended solids (MLVSS) in the…

Q: Question A water treatment plant is designed to treat 1 m³/s of raw water. It has 14 sand filters.…

A: Given- Flow- Q=1 m3/s,14 sand filters,surface area of each filter=50 m2,2 filters out of service. It…

Q: Your company is designing a sewage treatment plant (STP) that receives wastewater from a new…

A: Average hourly flow rate = Total population * per capita daily flow rate

Q: List all the main wastewater sources that need treatment before discharge to the environment.

Q: Question 2 What is the lifetime risk if 0.094 mg/L trichloroethylene (TCE) in groundwater used for…

A: Permissible limit of trichloroethylene TCE in drinking water is 5 ppm or 0.005 mg/l lifetime risk =…

Q: what are some past and current wastewater treatment methods in Singapore? (please mention pro and…

A: Given, * Singapore has a long history of implementing innovative and effective waste water treatment…

Q: A lateral sewer is to be designed to receive flow from 30 acres of a city in an area where the…

A: Design flow rate

Q: Q/How to increase rainwater infiltration in an urban environment?

A: We should stop cutting down of trees. We should make pit regularly at some distance so that water…

Concept explainers

Collection Systems

The collection systems form a part of sanitary engineering, which is a sub-branch of civil engineering. It is also known as public health engineering and wastewater engineering. It is a methodology followed to remove and properly dispose of human waste, along with creating systems to provide safe and clean usable water. These measures ensure a hygienic and disease-free community. Sanitary engineering, apart from building sewer disposal units, is also involved in plumbing, fire protection, hydraulics, life safety, environmental protection, information technology, microbiology, pathology, and so on.

Question

Plz, solve this problem.

Environmental Engineering-2

Evaluate the size and slope of a sanitary trunk sewer serving a population of 0.4 million. Water consumption is estimated to be 300 lpcd?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1 Calculate Required Water supply

VIEW

Step 2 Calculate Design Flow

VIEW

Step 3 Find Size of Sanitary trunk sewer

VIEW

Step 4 Find Slope required

VIEW

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

b.) Estimate the peak runoff flow rate observed in the combined sewer system in cfs generated only from storm water.
An average of 85 gallons of screenings is removed from the wastewater during a 24hour period. What is the screening removal in cubic feet per day?
A city has a current total population of 40,000 residents. The estimated design population is 55,000 at the end of a design period of 20 years. Determine the design average, peak, and minimum flow rates. Use the following data. Current daily average flow to the wastewater treatment plant Daily average I/I flow Hourly peak I/I flow = 18,400 m³/d = 80 Lpcd = 180 Lpcd A new junior college will attract 1500 nonresident students per day. The daily average wastewater flow is 50 Lpcd. A new industry will add a daily average flow of 900 m /d for a 24 h/d operation. An hourly peak flow of 1500 m’/d will occur during the day shift. The plant will be shut down one day a week. It is expected that 10% per capita reduction in wastewater flow will occur with the future population growth. The minimum to average flow ratio is 0.4 for the current dry weather wastewater flow.
Design a water treatment plant for a town with a 2020 population of 25000 persons, average population growth rate of 1.5% annually and average PCWC of 120 liters per day. The treatment plant will have a design life of 20 years and expected to start operation in 2024 and will be designed to treat 1.3 times the average water requirement. The source of water supply is a river and the water treatment plant must adequately remove very fine suspended solids and microorganspisms.
Wastewater discharges from two businesses were sampled. The BOD concentrations from Company “A” and Company “B” were 400 mg/L and 250 mg/L within DO concentrations 2.5 mg/L and 6.2 mg/L, respectively. Which company discharge would cause the greatest reduction in Nitrogen concentration (nitrification) in the body of water the discharge was flowing into? Group of answer choices B A and B None of these A
Compare and contrast Waterborne systems for excreta disposaland dry sanitation systems for excreta disposal.
Can you help me solve this homework problem
Environment engg
Wastewater is collected from a 50 hectare area that consists of 600 residential unit and 0.7 hectare of commercial centre. The average water consumption is 200 liter/capita/day. Calculate the average flow and peak flow of wastewater into sanitary sewer.
Estimate the total demand in (MGD) for a city of 5.2 x 106 persons, Fire Demand, Total Demand, if average daily flow = Qave = 225 Lpcd , Maximum Daily Demand = Qmax =1.8 %3D Qave. Select one: a. None of the options O b. 50112 O c. 105.12 O d. 501.12
Determine the surface dimensions and number of filters required to treat 23,000 m³/d if the rate of filtration is not to exceed 8 gallons per minute/square feet (gpm/sf).
What happens to your wastewater? Describe the wastewater treatment facilities that serveyour residence at either home or school. The description should list the individual unit processes that comprise the treatment system and what each process accomplishes.