Mention four (4) important ways to improve uniformity of water distribution in a sprinkler system

Q: Determine the maximum flow rate for a bleed-down orifice designed to discharge half of a 12.39 ac-…

A: Q = half of 12.39 ac ft  t =24 to 30 hours

Q: Disinfection, sedimentation, flocculation, coagulation, and filtration are processes for a surface…

A: Coagulation is defined as a water treatment process in which chemicals which are known as coagulants…

Q: Which of the following statements is false? Group of answer choices Infiltration increases as…

A: Given statements and asked to find which of the following statements are false. 1. Infiltration…

Q: what are the possible effects of replacing a pump inlet line with a conductor that has an inside…

A: Brief concept- There are several factors that affect the characteristics of a pump. These factors…

Q: Subject Environmental Engineering Please answer question 1-6

A:

Q: You are given a task to design a water treatment plant for treating 30 000 m³/d water from screening…

A: The screen chambers consists of a rectangular channel. The flow of the channels is normally 7-15cm…

Q: Inspection access Access for cleaning Inspection access Wastewater from house Scum Outlet to drain…

A: There Are different Parts of the Septic tank Are given.  Our aim is to,  Define each parts of the…

Q: For the storm sewer system shown below, determine the required diameter of the sewers; extended from…

A:

Q: 13. Which of the following is correct? a) There will be no flow across the streamtube b) There will…

A: Option A is correct  There will be no flow across the stream tube.

Q: Fill the table below with a proper letter. Choose one air pollution control device for each…

A: Ambient temperature air stream containing coarse particulates: For capturing coarse particulates in…

Q: This question about Sanitary Engineering Note: Assume any missing information. Question: Design a…

A: Given data- A rectangular sedimentation tank- Population P=1 million = 106, Rate of water supply…

Q: Given concepts of water quality: Some of the more important general water quality parameters can be…

A: Some of the more important general water quality parameters can be listed as  a) Turbidity b)…

Q: 1) Chlorine contact tank (Wastewater Treatment) An activated sludge plant has a design flow (average…

A: Given: The average flow rate is 11 MGD. The depth of the tank is 10 ft. The relation between length…

Q: Describe the difference between primary, secondary, and tertiary water treatment

A:

Q: 1. Design a screening chamber for the wastewater flowing at the rate of (10650/10) gpm, using the…

A: Given Data: Rate of flow is Q=10650 gpm = 0.672 m3/s. Length : Width = 2:1 Size of bars is 40 mm x…

Q: Why would one use a "low pass filter" when designing a water filltration system?

A: Low pass filters are used to eliminate noise in a circuit. When a sound is passed through a low pass…

Engineering Standards and Codes

Standards are technical publications designed to ensure the reliability of goods, products, methods, or services. They establish technical requirements, specifications, guidelines, features, or design procedures. Standards recommend a set of tolerance for design, processes, operations, production methods, or equipments used in a particular area. Standards are not legally binding unless they are accepted as code or regulation.