Answered: During normal gait a person 1.94m tall…

During normal gait a person 1.94m tall swings their leg from 89 degrees hip extension to 37 degrees hip flexion. Calculate the curvilinear distance traveled by their toes to 3 decimal places. Answer:

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A ceiling fan with 89-cmcm-diameter blades is turning at 70 rpmrpm . Suppose the fan coasts to a stop 30 ss after being turned off What is the speed of the tip of a blade 10 ss after the fan is turned off?
While installing new spark plugs in your car, the manual specifies they be tightened to 43 Nm. If you can only apply a force to the wrench 22 cm from the plug, and only at an angle of 62 degrees, What magnitude force should you apply to the wrench?
A 19 kg. rock is thrown straight down toward the Earth from a distance of 10 earth radii above the surface of the Earth with a speed of 5400 m/s. The radius of the Earth is 6370000 meters. The mass of the earth is 5.98e+24 kg. (A)Find the initial kinetic energy of the rock (in J) (B)Find the initial potential energy (in J) of the rock (HINT: the "r" in the potential energy formula is measured from the CENTER of the Earth). (C)Find the total initial energy (in J) of the rock (D)What is the potential energy (in J) of the rock after it has fallen 4 Earth radii from its original position. (E)Using the Conservation of Energy, find the speed (in m/s) of the rock after it has fallen 4 Earth radii from its original position.
IP A popular ride at amusement parks is illustrated in the figure ( Eigure 1). In this ride, people sit in a swing that is suspended from a rotating arm. Riders are at a distance of 12 m from the axis of rotation and move with a speed of 35 mi/h. Figure 12 m 1 of 1 T Part A Find the centripetal acceleration of the riders. Express your answer using two significant figures. G| ΑΣΦ 5 Submit Part B Request Answer Find the angle the supporting wires make with the vertical. Express your answer using two significant figures. 195] ΑΣΦΑ Submit Request Answer ?
Problem 3: A rod of negligible mass is attached to a vertical beam by a hinge at point A and a horizontal cable at point B, as shown in the figure. The angle between the rod and the beam is θ, and the distance between points A and B is L. Part (c) Given the values T=257.4N, L=2.81m, and θ=20.2∘, calculate the magnitude, in newton meters, of the torque τ 1→ Part (e) Given the values L=2.81mm, θ=20.2∘, T=257.4N, and f=0.777, calculate the magnitude, in newtons, of the force F→ needed to balance the torque from the tension in the cable.
A ballerina prepares to entera spin.She swings her extended arms and one extended leg around, jumps up on the otherleg, straightens out both arms and legs close to her vertical axis, and speeds up significantly. If her period of rotation is 1sec on the run-up, estimate what is her period of rotation during the spinin mid-air.
In the construction of railroads, curvature of the track is measured in the following way. First a 100.0-ft-long chord is measured. Then the curvature is reported as the angle subtended by two radii at the endpoints of the chord. (The angle is measured by determining the angle between two tangents 100.0 ft apart; since each tangent is perpendicular to a radius, the angles are the same.) In modern railroad construction, track curvature is kept below 1.20°. What is the radius of curvature of a “1.20° curve”? answer in ft
Problem 2: A bicycle wheel has a radius r = 0.22 m and rotates at a constant frequency of f = 89 rev/min. Randomized Variables r = 0.22 m f = 89 rev/min Part (a) Calculate the period of rotation of the wheel T in seconds. Numeric : A numeric value is expected and not an expression. T = Part (b) What is the tangential speed of a point on the wheel's outer edge in m/s? Numeric : A numeric value is expected and not an expression. V =
Convert 46.0° to radians, 14.0 rad to revolutions, and 73.0 rpm to rad/s. HINT (a) 46.0° to radians rad (b) 14.0 rad to revolutions rev (c) 73.0 rpm to rad/s rad/s
=J (e) (b) Fe= () 6. A pendulum that consists of a ball (m = 1.50 kg) attached to a light cord rotates in a circular path of radius r = 0.800 m at constant speed v, as shown in Figure. Here the angle 0 = 65°, and we ignore air friction and assume the mass of the light cord is negligible. (a) Calculate the tension T in the cord. = L. (b) Calculate the centripetal force acting on the ball. = 'd (c) Calculate the velocity v of this uniform circular motion. Answers:
An object on the Earth has a center of gravity that is 6.0 cm above its base. If the same object was taken to the Moon, where the acceleration due to gravity is 1/6th the value on Earth, how far above the base (cm) would the center of gravity be? O 6.0 O 15 O 3.0 O 2.4 O 36 O 8.4 O 3.6 O 1.0
A rotating flywheel rotates at 400 revolutions in the first minute. In the next minute, it rotates 240 revolutions. If the number of revolutions decreases as a constant rate, how many revolutions will the wheel make before coming to a rest?