During a dunk, a basketball player will elevate their center of mass 70 cm (or more) while jumping off of one leg. What is the strain energy contribution to the energy required to elevate the center of mass given the following parameters? How much energy has to be contributed by active muscle contraction? mass = 82 kg, K leg = 35000N/m, dispacement = 0.11 m.

Q: Draw the shear and moment diagram for the beam shown and find the maximum moment. 7N A B, C 6m 4m

A:

Q: A bending moment of 160 Nm applied to a hollow bone (outside radius = 2.5 cm; inside radius = 1.9…

A: Given: Bending moment M=160Nm Bending stress σ=16.7×106 N/m2 Outside radius, 2.5 cm= To find: Radius…

Q: in extensible A weight w hangs by an from the circumference of a pulley of radins R and momentof…

A:

Q: in physics,            we have a lot of problems. lets just say we have this problem for instance.…

A: The formula for calculating a square's moment of inertia is as follows:. a denotes the square…

Q: As shown in the figure below, a uniform beam is supported by a cable at one end and the force of…

A:

Q: A uniform symmetrical beam is supported at two pin joints as shown below. It has a length L and a…

A: Consider  is a section x-x from the left end Aat a distance of x meter as shown in the figure below.…

Q: Problem 4 P 60° A 160-lb force P is applied at Point A of a structural member. Calculate (a) the…

A:

Q: The figure shows the cross section of a uniform 177-lb ventilator door hinged about its upper…

A:

Q: A 0.12 kg horizontal beam has length L=0.8 m. It is supported by a fulcrum at d=0.45 m from the left…

A:

Q: Problem- The maximum shear stress induced in a solid circular shaft of diameter 15 cm, when the…

A: Given, Solid circular shaft diameter, D = 15 cm Shaft transmits power, P = 150 kW Shaft speed, N =…

Q: 13 kg horizontal beam has length L3D0.8 m. It is supported by a fulcrum at d=0.45 m from the left…

A:

Q: A rigid body is undergoing planar motion with the velocity of its center of mass vc = 2 m/s i + 5…

A:

Q: loads of PD = 145 kN & PL = 200 kN, and service moments of MDy = 35 kN-m & MLy = 60 kN-m. If Cb =…

A: Given as, W-shape for the beam is W12×65 Unbraced length L = 5 m Concentrated dead load (Tensile…

Q: A homogeneous triangular plate weighing 30 N is suspended by two chords AC and BD as shown, for that…

A: Given:- A homogeneous triangular plate weighing 30 N is suspended by two chords AC and BD as shown,…

Q: You are a stickperson of mass 84.09 with an elastic arm as shown below. Standing on an inclined…

A: Spring Force: The spring force is directly proportional to the change in the length of the spring.…

Q: extends from a building making a 48° angle with it.  A wire is supporting the beam, it is attached…

A: Given  A beam that has a mass of 75kg extends from a building making a 48° angle with it.  A wire is…

Q: For the rigid rotor system, the energy levels get closer together as the length of the rotor…

A: False.   For the rigid rotor system, the energy levels are given by:   E = (h^2 / 8π^2I) * J(J+1)…

Q: The picture shows and A shape ladder. Both sides of the ladder are equal in length. This ladder is…

A:

Q: Show that the true strain rate in extruding a round billet of radius ro as a function of distance x…

A: from the geometry in the die gap and letting x be the distance from die entry we can note that, Or…

Q: 20.0° above the The e system person vonage is at an angle cable is attached to the bridge 5.00 m…

A: Given:       θ=20.0od=1.00 ml=7.09 mh=12.0 m      Mass of the bridge is M=1960 kg distance of cable…

Q: in physics, we have a lot of problems. lets just say we have this problem for instance. we know that…

A: PHYSICAL PENDULUM: Hanging objects are made to oscillate in a manner similar to a simple pendulum.…

Q: The diagram below represents a thin rod of length L and mass m is attached to a solid disc of radius…

A: Given that: Mass of rod, MR=m=3.27 kgLength of rod, L=3.16 mMass of disc, Md=3m=3×3.27 =9.81…

Q: A round pencil lying on its side as in Figure is in neutral equilibrium relative to displacements…

A: There are three kinds of equilibrium namely stable equilibrium, unstable equilibrium and neutral…

Q: (i) State the Principle of Monent (Varignon's Theorem).

A: In this question we have to answer related to the Principal of Moment. Please give positive feedback…

Q: A jumper with a leg stiffness of 38000 N/m exerts a peak force of 4360 N. What was the center of…

A:

Q: Draw shear force and bending moment diagram for the beam shown below Pu=60kN Pu=60kN Wu-50KN/m 2 3 4

A:

Q: A string is wound around a uniform disc ofradius 0.49 m and mass 2.2 kg. The disc isreleased from…

A: The angular velocity of the uniform disc is

Q: Problem 9: The rotational inertia of a collapsing spinning star drops from an initial value Ii= 9 x…

A: solution is given as

Q: A small lightweight rocket is attached to a 7-kg disc that is initially at rest. The disc with a…

A:

Q: A 0.19 kg horizontal beam has length L-0.8 m. It is supported by a fulcrum at d=0.50 m from the left…

A:

Q: A 0.17 kg horizontal beam has length L=1.0 m. It is supported by a fulcrum at d=0.50 m from the left…

A:

Q: A paddle for a boat is constructed of a stick of length L and a parabolic end piece. The end can be…

A: Let us consider a thin strip of width dx at a distance x from the origin. The area of the strip is…

Q: A uniform rod has a mass of 2.53 kg and has a length of 1.17 m. It is hinged to a wall by a pivot at…

A: The free-body diagram is shown below. Here, T, m, and L are the tension, mass, and the length.

Q: Uniform rod of mass (Mr) and length (L) is suspended from ceiling. It is also mounted on a…

A: solution: First of all, consider the projection of the ball only. The ball is projected at an angle…

Q: You can create a simple gyroscope by hanging a wheel on a string as shown in the picture. We can…

A:

Q: Proof that the energy stored in the compact bone is given by E = AL0 (Sb) ^ 2 / 2γ. When Sb is bone…

A:

Q: Pwo forces can be replaced by an equivalent force R acting at point B on the beam Determine the…

A: Solution:-Given that

Q: Am=0.24kg mass is attached to end of a thin uniform rod of mass M =1.22kg and length L=4.38m which…

A: m=0.24 kg M=1.22 kg L=4.38 m Since, we knowEi=3L4mg+L4mgEf=12mv2+12Iω2+-3L4mg+-L4Mgω=v/L'and…

Q: A person on horseback is on a drawbridge which is at an angle 8 = 20.0° above the horizontal, as…

A: See below

Q: A uniform solid disk of mass M and radius R hangs from a string of length ℓ attached to a smooth…

A:

Q: A uniform rod AB of weight 500 N and length 4.0 m is supported at two points P and Q as shown below.…

A: Weight of rod, w, AB=500 N Length of the rod, AB= 4 m AP=QB=0.8 m Weight of man, wm=800 N

Q: A fulcrum is placed under a meter stick at its center of mass at 40 cm. This is the place where the…

A: Location of center of mass = 40 cm First mass (m) = 150 g location of center of mass (d) = 10 cm…

Q: An athlete begins with the arm in a relaxed upright position OA, in which the elastic band is not…

A: please see the next step for solution

Q: The spool has a mass of 30 kg and a radius of gyration of ko= 0.4 m, and r is 0.3 m. Neglect the…

A:

Q: As shown below, on Mars a beam of length L is leaning against a frictionless wall and is in static…

A:

Mechanical Properties of Solids

There are three types of matter- solid, liquid and gas. Out of them, solids have a rigid shaped and size. The intermolecular forces of attractions in solids are greatest. Mechanical properties are the physical properties of a material which it shows, when it is provided with certain amount of force or load. These properties are to be kept in mind for various purposes. When a force is applied to an object, the object may or may not get deformed depending upon its elastic property. But every time the object develops a restoring force against the force applied. This is commonly known as stress. If the object changes its dimensions due to the force applied it develops strain ( which is the ratio of change in dimension to the original dimension).