Draw a diagram (T-V) in the same molar composition as well as a P-xy diagram at 25 ° C and a T-xy diagram at atmospheric pressure for the toluene-cyclohexane system. Hello, solve this question for me in Type ( not handwriting)

Q: Explain in words, why it requires more heat (Q) to raise the temperature of a gas at constant…

A: According to thermodynamics first law, heat Q given to a system is used in two ways 1) in doing some…

Q: Answer the following questions based on the P – T phase diagram of CO2:(a) CO2 at 1 atm pressure and…

A:

Q: Calculate how much heat in J has to be added to a sample of an ideal monoatomic gas at a pressure of…

A:

Q: 1 One mole of an ideal gas (PV=RT) with cv = 1.5R J/mole and cp = 2.5 R J/mole, in the initial state…

A: Here q is the heat involved, w is the work done and u is the internal energy

Q: Air containing 20.0 mole% water vapor at an initial pressure of 1 atm absolute is cooled in a…

A: Given condition: Volume V=1 L. Pressure P1=1 atm. Temperature T1=200°C. Temperature T2=15°C. Mole…

Q: - Consider p-V diagram for an ideal gas shown in figure. PA 1 Constant V V Out of the following…

A:

Q: liquid gas 200 300

A: The straight line pressure is given as,

Q: The velocity of the three molecules is 2 km s1, 4 km s1, 6 km s 1. Find (i) mean square velocity…

A:

Q: - Consider p-V diagram for an ideal gas shown in figure. PA 1 Constant V V Out of the following…

A:

Q: Ethane at 10 MPa and 100°C is heated at constant pressure until its volume has increased by 60…

A: Basic Details For the ideal gas equation, the ratio of volume to that of temperature is constant.…

Q: Estimate the time needed for a glycine molecule to diffuse 15 um in water at 20 degrees Celcius if…

A:

Q: Please explain how (dH/dS)N,P = T and what the value of (dS/dN)H,P is for a monoatomic ideal gas.

A:

Q: 1 mol of ideal gas with Cp = 30J/ mol K, Cy = 20.7 J/ mol K from 400K and 5 atm pressure to 1 atm…

A: Given that Number of moles n = 1 Temperature T = 400 K Initial pressure P1 = 5 atm Final pressure P2…

Q: Convert the universal gas constant R = 8.314 J/mol/K into units of calories/mol/R. Note that the…

A: universal gas constant (R) = 8.314 J/mol/k to convert : the value of R to units calories/mol/Rankine…

Q: A gas mixture contains 3.0 moles of (O2) and 9.0 moles of Argon (Ar) at a temperature of 300.0 K.…

A:

Q: Calculate the internal energy (in joules) of a sample of 152 moles of a gas at a temperature of 69…

A: Internal energy of a gas is basically its kinetic energy at given temperature and is given by the…

Q: Assuming ideal behavior, calculate the volume (in L) occupied by 1.58 moles of N2 at 350 K at a…

A: given   moles of nitrogen n= 1.58m0le temprature T= 350 pressure P = 1* 105pa R=0.08206litere*…

Q: Consider a 22.4 g of N2 gas that follows the given PV diagram. [Answer in 3 significant figures] C₁…

A: To solve the question and complete the chart for the given PV diagram of ( N_2 ) gas, we'll use the…

Q: :A gas contained in a piston-cylinder assembly undergoes two processes, A and B, between the same…

A: Given,  P1= 1 bar=1*102 kPa,     P2= 10 bar= 10*102 kPa, V1= 1 m3,     V2= 0.1 m3, U1= 400 kJ,   U2=…

Q: Shown in the figure below is the cycle undergone by a Refrigerator. Your fridge runs using 22.60…

A:

Q: V. Th To V Room temperature T 293 K Vp The temperature changes from Th to To during process 3. The…

A: work done in thermodynamic process W = ∫ P dV

Q: Consider an ideal gas at 27C and 1.00 atm. To get some idea how close these molecules are to each…

A: Part (a) Given: The temperature of the ideal gas is T=27∘C. The pressure of the ideal gas is P=1.00…

Q: Estimate the time needed for a glycine molecule to diffuse 15 um in water at 20^o C if its…

A:

Q: A sample of oxygen gas has a density of temperature of 55°C. Assume ideal behavior. Submit Answer…

A:

Q: Gas is contained in a 5.00-L vessel at a temperature of 21.0°C and a pressure of 7.50 atm. (a)…

A: Given: The volume of the vessel = 5 L The temperature of the gas = 210 C Pressure = 7.50 atm

Q: What is the mean atmospheric pressure in Denver, Colorado, which is a mile high, assuming an…

A:

Q: An ideal gas undergoes the cycle shown in the figure below: it expands isobarically at pressure p…

A: Given P-V diagram for the three step cycle

Q: Why can any low density gas be used in a constant volume gas thermometer? a) All low density gases…

A: Reasoning: low-density gas is used in a constant volume gas thermometer

Q: 2. Calculate the average speed V and the most probable avg speed V for Oxygen.

A:

Q: What is the new volume of the gas, if the volume of an ideal gas enclosed in a thin, elastic…

A: Yes, your answer is correct, solution has the mistake.

Q: The set up is: For this phase diagram of carbon dioxide, what temperature in kelvin (K) to 4 digits…

A: The triple point of a substance is the point on its temperature-pressure graph where the temperature…

Q: A piston-cylinder assembly contains 3 kg of air at 200 kPa and 27°c . At an initial state the piston…

A: Given Data:  mass (m) = 3 kg Initial Pressure (Pi) = 200 kPa Temperature (T) = 27 o C = 27 + 273 =…

Q: 3) Carbon monoxide gas (CO) contained within a piston-cylinder assembly undergoes three processes in…

A:

Q: You can create ice by adding liquid nitrogen to a container of water. If you want to produce 200g of…

A: mass of ice that has to be created is m1 = 200 g = 0.2 Kg initial mass of water is m2 = 450 g = 0.45…

Q: Estimate the time needed for a glycine molecule  to diffuse a distance of 27 μmμm in water at 20…

A:

Q: Prove the following relation. ds = Cv Ср * (P) P + (), dP T ӘР P dv

A: To prove the given relation: dS=CVT∂T∂PVdP+CPT∂T∂PPdP

Q: Attached Table  gives experimental values of the molar enthalpy of nitrogen at 1 bar and 100 bars.…

A:

Q: 5 mole of an ideal gas for which Cv,m=3/2R, initially at 20 oC and 1 atm undergoes a two-stage…

A:

Q: 2 moles of a monatomic ideal gas undergoes a cyclic process as depicted in the figure below. The…

A: Since it is an ideal gas  PV = nRT 11.5x5.7 = 2 x0.082 xT T = 399.69 K  γ(for monoatomic gas) = 53…

Q: Needs Complete solution with 100 % accuracy don't use chat gpt or ai plz plz plz plz plz.

A: Step 1: Step 2: Step 3: Step 4:

Q: VA In the process 14. the gas system gains heat loses heat O experiences no heat change No answer…

A: Process 1 ---> 4 is an isotherm.  In isothermal process  there is no change in internal energy…