QUESTION 3Determine the fill and cut volumes of the 10 m by 10 m grid below.AB0.7 F0.7 C0.8 F120.8 CQUESTION 10What is the area of the cut, in square metres (m²)?QUESTION 11What is the average cut, in metres (m)?QUESTION 12What is the volume of cut, in cubic metres (m³)?QUESTION 14What is the average fill, in metres (m)?QUESTION 15What is the volume of fill, in cubic metres (m³)?

Given data:- The below grid is (10mX10m)

Answered: Determine the fill and cut volumes of…

Engineering

Civil Engineering

Determine the fill and cut volumes of the 10 m by 10 m grid below. A B 0.7 F 0.7 C 0.8 F 1 2 0.8 C

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: 5.16 Refer to Figure in which upward seepage is taking place through a granular soil contained in a…

Q: Using the alignment charts of Figure 10.13, determine the effective length factor (k) for column AB…

A: Beams- 300×400 mmColumns- 300×400 mmf'c=28 MpaTo determine- Effective length factor (k) for column…

Q: The table below contains the information about two embankment sections. The distance between them…

A: The given data is shown below: Distance=30 mFormation width=6m to 9m

Q: 2. A simply supported beam carries a service live load of wll and a service dead load of wdl…

Q: Prob. 4. From station 0+200 with center height of 2.8 m. fill, the ground line makes a horizontal…

A: 1.4x = 2.860-x⇒x = 20m

Q: Calculate the quantity of the earthworks in cubic meter for a canal embankment of 100 m long having…

Q: 3.4 Complete the earthwork calculation sheet here and plot the resulting mass diagram. Divide ccy by…

Q: A pipe is use to Connect two reservior, length is 1000m, headloss is 4m, flowrate is 0.6m³/s.…

A: Given data L = 1000m hf = 4m Q = 0.6 m3/sec Find diameter of pipe (D) If 1. f = 0.02 2. n =…

Q: :A puncture of length 250 m, with a trapezoidal section and slope of the sides 1: 1.5, the value of…

A: Solution Given that Length of channel L=250 m n=0.005 side slope x=1.5 The slope of the floor…

Q: SHOW FIGURE Given the following sections: Station 2 + 020 a 0 b +2.5 +3.15 +2.65 Station 2 + 080…

Q: of trapezoidal section has to be √3 excavated throught A power Canal hard Clay at the least cost…

Q: I need help on this problem Manning equation problem for parts a, especially rearranging the…

A: R (hydraulic radius) = A(area)/P(perimeter) = 250*20/(250 + 2*20) = 17.24 Q = 25000 ft3/s Q = 1/n x…

Q: The following cross-sectional areas (m2) are calculated for centre line of a drain trench at 5 m…

Q: The cross section at station 2+60 has a cut area of 9 ft² and a fill area of 4 ft² and the cross…

A: Given data, The cut cross section at station (2+60 ) = 9 ft² The fill cross section at station (2+60…

Q: The canal shown below is laid on a slope of 0.00028. When it reaches a railroad embankment, the flow…

A: Embankment : A road, railway line, or canal is typically lifted onto a compacted dirt embankment to…

Q: QUESTION 7 The cross section at station 2+60 has a cut area of 9 ft² and a fill area of 4 ft2 and…

A: Given data:- The cross section at station 2+60 has a cut area of 9 ft2 and a fill area of 4 ft2 The…

Q: Given the following sections: Station 2 + 020 a b + 2.5 +3.15 2.65 Station 2 + 080 d 2.5 -2.5 -3.65…

Q: The cross section at station 2+60 has a cut area of 9 ft² and a fill area of 4 ft² and the cross…

Q: Compute for the area (m2) of fill, considering b is 8.9 meters: 9.81 8.67 + 4.54 - 6.81

Q: Q3// A culvert used to carry irrigation water has to transport a flow of 995 gpm and maintain a…

Q: In a hydraulically most efficient trapezoidal channel section the ratio of the bed width to depth is

A: Hydraulically efficient channel section: For a given slope, roughness coefficient and area of flow,…

Q: 6. Gilligan is attempting to tunnel off the island. How far below the ground surface can he go…

A: Heaving: Heaving is the upward movement of the soil or clay that occurs when the soil is swelled…

Q: For a triangular channel with the horizontal dimension of the side slope is 3 (i.e Z-3), a normal…

Q: A nearly horizontal rectangular section with a width of 25 feet carries 1500 cfs. There is a…

A: We knowyc=q2g13q=150010=150m3s·myc=q2g13=15029.8113yc=13.18776m

Q: The following cross-sectional areas(m2) are calculated for centre line of a drain trench at 5 m…

A: Given data : Area A1=2.5 m2 Area A2=2.7 m2 Area A3=1.8 m2 Area A4=3.5 m2 Area A5=3.7 m2 Area A6=2.9…

Q: The figure shown is a dewatering plan to build the foundations of an office building below the water…

A: Note- Hi! Thank you for the question, As per the honor code, we are allowed to answer three…

Q: if the median size of bed material of a natural channel is 1.2 mm, then the Manning's n coefficient…

A: Given, Median size of bed material of a natural channel, d50 = 1.2 mmWe know that,The manning's…

Q: Determine the size of a circular concrete pipe (n = 0.013) to carry 150 ft³/s of stormwater on a…

A: The flow rate is given by ;Q = 150 cubic ft /sec n = 0.013S = 0.007d = 3.921 ftRequired size of…

Q: An elliptical culvert is 4.5 feet tall and 6.9 feet wide it is filled with water to a depth of 1.05…

A: Given: Elliptical culvert 4.5ft tall and 6.9 ft wide Water depth 1.05 ft.

Q: What is the area of cut in square metre? what is the average cut in metres? what is the volume of…

A: Grid Method is used to find the volume of cut and fill in earthwork. In grid method we divide the…

Q: The length of the levee perpendicular to the paper is 600 m; the sand on top and bottom have k1=750…

Q: 12 10 10-m 10-m 20 5.30 1.5 8.80 DETERMINE THE VALUES OF "a" AND "b"

Concept explainers

Highway Drainage

Highway drainage is the process of extracting and regulating the excess surface water on the pavement by giving the desired slope. The construction of a highway drain helps to divert the water present on the surface, and sub-grade by the means of slope. Highway drainage systems are a necessary part of smooth functioning of traffic, since the highway drainage systems provide proper disposal of unwanted substances from the highways.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Q12. After surveying a borrow pit, the surveyor produced the following pit grade below. What is the total volume (cubic yard)? The unit in the map is ft, the square is 20ft x 20ft. 5.0 4.9 20.0 4.2 3.9 5.4 13.3- -13.3 4.3 4.6 5.4 4.4 -20.0 6.1 5.4 5.8 4.9 4.7 4.8 5.1 4.6 3.9 -13.3- -26.7- 4.6 5.4 4.4 |3.9 5.5 5.1 4.9 4.2 4.2 3.9 4.4 4.7 -20.0 -20.0
Q2. After surveying a borrow pit, the surveyor produced the following pit grade below. What is the total volume (cubic yard)? The unit in the map is ft. -20. O 6.1 5.4 5.8 20, 0 4.7 H3. 3- 4.8 5. 1 4. 6 3.9 -26. 7– 4.6 5.0 4. 4 5.5 5. 1 4. 9 4. 2 3. 7 3. 9 4. 4 3. 7 20.0
Surveying
Determine the volume in cubic meters of the excavation for the borrow pit shown. Compute the total volume in cubic meters using Unit-Area or Borrow-Pit Method. Round off final answer to three decimal places. The numbers at the corners represent the cuts in me
Q3: Figure (3) represent the plan of an area to be excavated, which have been leveled in the form of a square and triangle grid the surface levels are shown beside each point, the grid squares are 20 m on a side, and the required formation level is 20.00 m above datum .Compute the amount of excavation in cubic meters. 28.11 28.24 27-58 2769 27-32 20.00 2763 20.00 Figure (3) 20.00 87.76
Calculate the end areas for depths of fill from 0 to 20 ft using increments of 2 ft for level sections, a 26-ft-wide level roadbed with side slopes of 1-1/2:1. Part C What is the end area for the depth of 4 ft? Express your answer in feet squared as an integer. End Area = Part D OF IVE ΑΣΦ ↓↑ vec What is the end area for the depth of 6 ft? Express your answer in feet squared as an integer. End Area = G| ΑΣΦ ↓↑ vec h ? ? ft² ft²
i need the answer quickly
Solve with graph
Situation No. 10 Solve and Give the complete solutions.
What is the area of cut in square metre? what is the average cut in metres? what is the volume of cut in cubic metres? what is the area of the fill in metre square? what is the average fill? what is volume of full in cubic metres? QUESTION 3. Determine the fill and cut volumes of the 10 m by 10 m grid below. A B 0.7 F 0.7 C 0.8 F 0.8 C 2 1 2
From which formula, y (SHg x Yw) came from?
Given the following data of the cross-section of an earthworks with a base of 10m. a. Compute the area of station 2+120 b. Compute the area of station 2+150 c. Compute the volume between stations using end area method