SHOW FIGURE Given the following sections: Station 2 + 020 a 0 b +2.5 +3.15 +2.65 Station 2 + 080 c 0 d -2.5 -2.5 -3.65 Base for cut = 12 m, Sideslope for cut = 1.5:1 Base for fill = 12 m, Sideslope for fill = 2:1 Required: 1. What is the stationing of the end of excavation? 2. Find the volume of fill by end area method. 3. Compute the volume of excavation by end area

Q: - () 4 B+tan R 2- B = and H = for triangular spoil bank \L+tan R, 2 HIN

A:

Q: STATION 5 +000 5 + 100 5 + 200 5 + 300 5 + 400 5 + 500 5 + 600 5 + 700 5 + 800 5 + 900 6 +000 6 +…

A:

Q: Q: In the figure below, the depth of excavation required to form a cutting at 20 m intervals are…

A: Given  Width of roadways = 5 m Length of roadways = 80 m  Intervals of depth measurement, h = 20 m…

Q: Q-31 Find the excavation and backfill quantities for (3*4) m service room with footing of 0.8m width…

A:

Q: 2. What FS reading is required to establish the correct excavation depth? EL= 120.532 EL = 290.667…

A:

Q: Q2/ The levelling reading for proposed project is shown in table below. If the D.L for the points…

A: Given data The D.L for the points A, E and H are 31.0, 31.5, 30.0 The elevation of point E = 30.09 m

Q: Determine the amount of total excavation in BCY needed for the spread footing shown below. A…

A: Before the construction of the footing, the excavation of the land is proceeding because the…

Q: Baseline 4,21 0m 6,85 m 6,31 5 6,80 Offsets South Offsets North 3,54 6 4,80 12,83 12 7,93 13 7,15 15…

A: A baseline is given in the above figure. Some offsets are given on both sides of baseline. We have…

Q: b. Volume of the Work Area Building Perimeter ii Centerline of Work Area: i Volume of Work Area…

A: To find the total volume of excavation.

Q: QUESTION 2 The cross section at station 2+60 has a cut area of 9 ft2 and a f fill between these…

A:

Q: An earthwork excavation project required digging soil from stations A (3+56), B (4+94) to C (11+82).…

A: The area at station A = The space at station B = The space at station C = Soil swell factor =

Q: Given the following set of slope staking notes, find X2:

A:

Q: QUESTION 3 The cross section at station 2+60 has a cut area of 9 ft2 and a fill area of 4 ft² and…

A:

Q: 1) Which statement is correct about Point A at station 20+00? a) No earthwork is needed at this…

A: 1. At point A, the cumulated volume is zero. From the mass diagram earthwork is required for cut and…

Q: QUESTION 2 The cross section at station 2+60 has a cut area of 9 ft² and a fill area of 4 ft2² and…

A: For Station 2+60Cut Area of 9 ft2Fill area of 4 ft2 For Station 3+00Cut area of 7 ft2 Fill area of 8…

Measuring site work, Excavation and Piling

Bid drawings typically include very little material about the precise requirements of site work operations, measuring site work and excavation work differs from measuring most other works on a construction project. The actual site work conditions are not provided and also the dimensions of the excavations are not known during the pre-construction phase. The precise measurement of the excavation and backfill of the earth material and topsoil is important for a contractor to decide upon the total cost required for the process. All the works should be carried out under OSHA (Occupational Safety and Health Administration) standards to ensure the safety of the workers.