Match the excavator to the job: 1. Excavation for a 1” water line to your home. Length of trench= 50 feet, depth of trench 5 feet 2. Excavating the vertical face of a gravel pit from a location in the bottom of the pit 3. Excavating with a long reach in a pond filled with water removing gravel from bottom of pond. 4. Excavating in a deep vertical pit for a pump station foundation pit walls have steel sheet piling to protect from cave-ins.

Q: A hydraulic excavator with a 2 cubic yard heaped capacity bucket is excavating in common earth. The…

A:

Q: A contractor is to excavate an area of 350′ × 150′ to a depth of 9′ and haul it by dump truck to a…

A: Following are the given information. Excavation area =350′ × 150′ Excavation depth =9' Swell factor…

Q: 3- Describe the methods of stabilizing the sides of the excavation when making piles in loose soil…

A: A number of fundamental considerations should be taken into account while designing stable sides.…

Q: What is the procedure for Rock Core Drilling?

A: Coring is done to gather samples of rock to analyze its geological characteristics. For the same…

Q: Describe the  process of  Scraper spreading  soil hauled from an earth-cut area.

A: Generally, the process of scrapper soil spreading consists of three operations:

Q: 2 - A boring was taken and a split spoon sampler was advanced with a 140 pound donut hammer falling…

A: Uncorrected vale of the   SPT  test is considered No. of belows needed for the penetration of 12…

Q: Define Pile Load Tests.

A: Pile Load test is defined as the test which is performed to determine the load carrying capacity of…

Q: Kindly solve this question under Measurement and Specifications for Civil Engineers.

A: Based on the information you provided and the specifications in the contract, here's the takeoff for…

Q: Station 0 +00 1+00 2+00 Complete the earthwork calculation sheet and plot the resulting mass…

A: To find:           (a) Plot the mass diagram.           (b) maximum and average haul distance.…

Q: SHOW FIGURE Given the following sections: Station 2 + 020 a 0 b +2.5 +3.15 +2.65 Station 2 + 080…

A:

Q: State THREE (3) excavation works involve in pad footing construction. 1. Excavation for......... 2.…

A:

Q: Describe how the process of segmentation works on the most fundamental level. What makes it distinct…

A: Introduction- Process of segmentation- There are 5 steps in the segmentation process:1) segment…

Q: Prepare a bare cost estimate based on national average prices for the following storm drain…

A: Trench size =350 ft ×4 ft × 5 ft Pipe diameter = 18 in Swell factor = 22% Shrinkage factor = 15%…

Q: A shovel having a 6-cy bucket whose cost per hour, including the wages to an operator, is $85 will…

A: The capacity of a shovel (Q) = 6 cy The cost per hour including wages = $85 The swell percent = 60%…

Measuring site work, Excavation and Piling

Bid drawings typically include very little material about the precise requirements of site work operations, measuring site work and excavation work differs from measuring most other works on a construction project. The actual site work conditions are not provided and also the dimensions of the excavations are not known during the pre-construction phase. The precise measurement of the excavation and backfill of the earth material and topsoil is important for a contractor to decide upon the total cost required for the process. All the works should be carried out under OSHA (Occupational Safety and Health Administration) standards to ensure the safety of the workers.