Determine the elevation at BM 36.

Q: *12-44. The channel is made of finished concrete and has the cross section shown.If the downward…

A:

Q: determine the difference of elevation of points A and B

A: C value is not given. so I assumed C as 0.381. So there must be variation in the answer option…

Q: mins. and (p)r-02m.

A:

Q: A line of levels of 4 set-ups is run between 2 points using a 13-ft. level rod. The rod used has 0.1…

A: level setup 4 times13 ft level rid0.1 ft sawed off the bottomDifference in elevation 38.92ft

Q: A level is set up and a reading of 2.195 m is taken on a bench mark the elevation of which is 89.54…

A:

Q: An oil burner is installed in a basement. The floor of the basement slopes andthe oil burner must be…

A: Given- An oil burner is installed in a basement. The floor of the basement slopes and the oil burner…

Q: Using the Leveling Template set up and complete the differential level notes for the information…

A: A slope on which differential levelling has been carried out.To make differial level notes use…

Q: For the figure below, find the height of the water (H) needed to make the rectangular gate AB about…

A: Given :-  Gate weight (w) = 343.35 KN Gate length (L) = 3 m  Gate width (b) = 2 m The slope of the…

Q: L = 1268.46 ft 2567 = 2560 + 2.5(L/2) − 2.5(L/2 − 1) + (1.5 + 2.5)/(2L) (L/2 − 1)2 L2 −13L+4=0 BVC…

A: Given:- The initial grade = -2.5% The final grade = +1.5% The elevation of point VPI = 2560.00 ft…

Q: Define the process of levelling and level surface.

A: The leveling process consists of the identification of the height of a level with respect to or with…

Q: An engineer's transit is setup at point B which has an elevation of 145.65m above MSL. Point B is…

A:

Q: H.W Example 2 Rising gradient 0.5 in 100

A: Rising gradients are written as Y:X where, Y is a rise and X is the run. Both numbers must have the…

Q: To make a peg adjustment, the following notes were taken: Wye level at 1 Wye level at 2 Rod reading…

A:

Q: A level is set up and a reading of 2.895 m is taken on a bench mark the elevation of which is 67.145…

A:

Q: problem 1 Offsets were taken 9m apart in the following order; 2m, 3.2m, 4m, 3.5m, 5m, 6m, 7m.…

A: Offset is the perpendicular distance measured from each side of a chain line going in a specific…

Q: ?What is the elevation of point BM1 in the below table if you know that the elevation of BM2 is…

A:

Q: ROD READINGS DIFFERENCE IN ELEVATION STA REDUCED BS IFS FS RISE FALL LEVEL BM100 1.24 525.28m 0+00…

A:

Q: Find the height of the building if the angle of elevation of its top is 61° 37’ when seen from a…

A: Given  angle of elevation = 610 37' distance from the ground L = 675.4 m  Let H be the height of the…

Q: Which of the following is true for a "cut" tape? A) The last foot (or meter) at each end of the tape…

A: Cut tape is a type of tape in which one foot or metre intervals are there. And only one foot is…

Q: Q13. If the known benchmark elevation is 272.5 ft. When surveying you find the rod reading at PT. A…

A:

Q: A level is set up and a reading of 2.195 m is taken on a bench mark the elevation of which is 89.54…

A:

Q: s A, B, C, and D are in straight line. The elevations are 247m, 236m, 314m and 396m respectively.…

A: Given:- The elevations = 247m, 236m, 314m and 396m To find:- a. Compute the height of equal towers…

Q: BS Rod FS Readings Fall Reduced Rod Rise Level Station IFS 3.755 346.75 BM1 2.895 1 1.742 2 1.683 3…

A: To find  Elevation of the Bench mark 2 (BM2) and elevations of all the rod stations.

Q: Degree of static indeterminacy

A: Given data : The value of number of member in truss=3 The value of number of joint in truss=4 The…

Q: A steel post (E = 30x10° psi) having thickness h = in. and height l = 71 in. supports a stop sign…

A: Stress is defined as the force of resistance per unit area given by a body against deformation. The…

Q: Vertical Curve Given: g1 = +4% g2 = -2% BVC Station = 12+00 BVC Elevation = 120.00' L = 800.00' What…

A:

Q: A level is set up and a reading of 2.815 m is taken on a bench mark the elevation of which is 92.145…

A:

Q: What is the true inclined distance? E = 200GPa, A = 3.0 mm² and the coefficient of linear expansion…

A: Calculation of True Inclined Length of Line  using Given Data in problem

Q: III. Differential Leveling 1. Complete the table below. STATION BM1 TP1 TP2 TP3 TP4 TP5 BM2 BS 2.11…

A:

Q: Modern planning and designing demands a very precise system of environmental projects in a building.…

A: Introduction : Green building, also known as green construction or sustainable building, is the…

Q: S.W 20 km TR. at midspan

A:

Q: A level surface is perpendicular to the O Vertical at each ground point Non of the above O Normal at…

A:

Q: POINT B.S I.S F.S HI DESIGN CUT+ FULL- ELEVATION 31.994 0.023 RL A 1.289 33.283 1.312 C 1.267 D…

A: There is A table which is Related to surveying.  It is Done by "Height of Instrument Method" Now…

Q: 3 - Find the level (Azimuth point OA, OB. OC) (A). From the drawing below. ( A vertical angle = 370…

A:

Q: 3. Below is a concrete wall with parabolic surface (x y), determine the magnitude and location of…

A:

Q: how does Dc=21 inches Select spiral size and spacing: Volumetric spiral ratio, using #3 spiral: 4Asp…

A: Solution In the analysis of spiral columns, Dc is calculated for finding various factors.

Q: 6. If the elevation of A is 240.05m, determine the elevation of C. 1 Conc. Wall- -Bottom Line Bottor…

A:

Q: m., and D= 396 m., respectively. Find the height of equal towers on A and D to sight over B and C…

A:

Q: To make a peg adjustment, the following notes were taken: Wye level at 1 wye level at 2 Rod reading…

A: Wye level at 1 ( midway between the PQ) The reading at P = 1.241m The reading at Q = 1.513m. As…

Q: invert levels are used to ensure prope laying elevation of the entire water line? True or False?

A: The height of the inside-bottom of a pipe, trench, culvert, or tunnel is known as an invert level.…

Q: All information is given and Rv is wanted. ( it is a matter of math) HSO = Rv (1-cos(( 28.65* s)/Rv)

A: Given equation is HSO=RV(1-Cos28.65×s/Rv)            (1) HSO=3 s=130 Using values of HSO and s in…

Q: - 1 attachment- Determine the maximum height, h, perpendicular to the ground. h 55.30 ft/s² 25° B…

A:

Q: Horizontal Curve Given: Radius (R) = 1500.00' Delta (A) = 10°-20'-40" External (E)=? O 6.57' 6.01'…

A: