Q13. If the known benchmark elevation is 272.5 ft. When surveying you find the rod reading at PT. A is 3.83 ft, PT. B is 4.95 ft, PT. C is 6.23ft, and the rod reading at the benchmark is 5.52. What is the elevation of PT. A, B and C. Sketch the BM, HI, BS and FS.

Q: A pre-engineering baseline was run down a very steep hill (see Rather than measure horizontally…

A: Vertical angle = -21o26' Height of range pole from the ground, h = 4.88 ft Slope distance between…

Q: aN 4N 6 m ET 13N F find for ce BC , FE , CF

A:

Q: The base of a cut section is typically smaller than the base of a fill section. True False

A: Answer :    False  For more explanation see next step.

Q: A line of levels of 4 set-ups is run between 2 points using a 13-ft. level rod. The rod used has 0.1…

A: level setup 4 times13 ft level rid0.1 ft sawed off the bottomDifference in elevation 38.92ft

Q: Q3/A levelling survey was done for a project at station A to draw the cross section. The design…

A:

Q: 2. What FS reading is required to establish the correct excavation depth? EL= 120.532 EL = 290.667…

A:

Q: The cross-section notes shown below are for a ground excavation for a 9m wide roadway. STA 16+600…

A:

Q: The figure shown below provides the rod readings in the order in which they were taken. The…

A: Given Data  Actual elevation of BMB = 92.50 ft  Determine the elevation of BMB and Error of Closure…

Q: Using the Leveling Template set up and complete the differential level notes for the information…

A: A slope on which differential levelling has been carried out.To make differial level notes use…

Q: What is coefficient of lateral earth pressure?

A: The coefficient of lateral earth pressure can be defined as it is the ratio of the horizontal over…

Q: A mine survey is being conducted from a benchmark located at the coordinate position of N 8300, E…

A: Given: coordinate position of benchmark (say o) = N 8300, E 2400And distances of points a, b, c with…

Q: b) A level run was carried out, using the data below compute the difference in level between points…

A: Given Reduced level of datum = 50 m

Q: What is the basic principle considered in application of electric resistivity survey in foundation…

A: Brief concept- Foundation exploration- Foundation is the underground structure over which the…

Site Plan Requirements

A site plan (also known as a plot plan) is a diagram or process to show the proposed improvements on an existing property. A site plan is important, as it provides information regarding the landscape features of a given plot of land.  Zoning is done or can be understood with the help of a site plan.