Answered: Determine the contact pressure under…

Determine the contact pressure under the comers of the (4.5 m x 4.5 m) foundation shown in Figure (3) for a (1000 kN) eccentric loading. B A 10.6 m Figure 3 0.4mX D

Principles of Foundation Engineering (MindTap Course List)

9th Edition

ISBN:9781337705028

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter10: Mat Foundations

Section: Chapter Questions

Problem 10.11P

See similar textbooks

Similar questions

Consider the strip footing and loading shown below. Consider in all calculations that the footing is 1 m long in the out-of-plane direction. What is the maximum moment in kN.m per unit length that can be applied by the column in the direction shown in the figure below without compromising the stability of the foundation? (answer tolerance = 2%). Consider γconcrete = 25 kN/m3, γsoil = 18 kN/m3 and assume the width of the embedded column to be negligible and the entire top of the foundation is covered.
A rectangular footing 6 m x 3 m carries a uniform pressure of 300 kN/m² on the surface of a soil mass. Determine the vertical stress increase at a depth of 5 m below the surface on the centerline 1.0 m inside the long edge of the foundation. a. 62.17 kPa b. 54.67 kPa C. 81.35 kPa d. 88.88 kPa e 74.16 kPa
help me
o T ☺ ť (Q4): For the soil profile shown in figure (2) find the difference in stress in (kPa) at point located at a depth (10m) under the center of the circular foundation when using the below formulas and when using the approximation method 1 Ao, = q [(R/2)* + 1] Dia4m q0.21 N/mm N.G.S Sand e0.8 G.-2.6 3m W.L e0.7 G-2.7 5m Clayey - Sand e045 G.-2.68 مر ر ل لأعلى لاستعراض الفلاتر إضافة شرح. .. mum < II
7.7 Refer to Figure P7.7. Using the procedure outlined in Section 7.10, determine the average stress increase in the clay layer below the center of the foundation due to the net foundation load of 50 tons. [Use Eq. (7.26).] 450 10 A 50 kin tet load Figure P7.7 5nxsn Sand 7-122 1² Sand y 100 lb/m Yu120 vn =0.7 C=0.25 C-0.06 Water table Clay Preconsolidation pressure-2000 lb/n² C
The plan of a mat foundation is shown in Figure 1. Calculate the soil pressure at points A, B, C, D, E and F. (Note: All column sections are planned to be 450mmX450mm). Determine factor of safety of the Mat.
Solve Problem 7.8 using Eq. (7.29). Ignore the post-construction settlement. 7.8 Solve Problem 7.4 with Eq. (7.20). Ignore the correction factor for creep. For the unit weight of soil, use γ = 115 lb/ft3. 7.4 Figure 7.3 shows a foundation of 10 ft × 6.25 ft resting on a sand deposit. The net load per unit area at the level of the foundation, qo, is 3000 lb/ft2. For the sand, μs = 0.3, Es = 3200 lb/in.2, Df = 2.5 ft, and H = 32 ft. Assume that the foundation is rigid and determine the elastic settlement the foundation would undergo. Use Eqs. (7.4) and (7.12).
A 6 m x 9 m rectangular footing xarrying a uniform of 288 kPa is applied to the ground surface.. Compute the total vertical stress in Kpa due to the uniform load at a depth at a depth of 6 m below the center of the loaded area if unit weight of soil is 18.30 kN/m^3. use the influence coefficient method. a. 232.49 b. 714 c. 144.8 d. 60
Problem 2: The following details are given for the vertical rectangular concrete foundation (embedded): Foundation: Length = 2.4 m; Width = Height = 1.8 m Depth of foundation, D/= 1.5 m Unit weight of concrete = 24 kN/m³ Vibrating machine: Weight= 100 kN Frequency dependent amplitude of vibrating force = 9 kN At an operating speed of 500 cpm. Soil: Gs = 25 MPa; G=22 MPa; μ-0.25; ys 18.8 kN/m³ (for side layer) Y= 19.5 kN/m³ (below the base). Determine: a) Damped natural frequency b) Amplitude of vertical vibration at resonance c) Amplitude of vibration at operating speed.
Please solve part 5 only
An eccentrically loaded continuous foundation is shown in Figure P6.18. Determine the ultimate load Qu per unit length that the foundation can carry. Use the reduction factor method [Eq. (6.67)]. 4 ft 2 ft Figure P6.18 Qu 2 ft → -5 ft Y = 105 lb/ft³ Groundwater table Ysat 118 lb/ft³ c' = 0 $' = 35° =
Question 2) For a shallow foundation shown below: A. Estimate the ultimate bearing capacity when the water table located at a depth of 2 m below the ground surface. B. Estimate the moments about the x- and y-axis; assume that the foundation is subjected to a vertical load and a moment. If eg and eL is 0.33 m and 0.12 m, respectively. G.S Iz 2 m (2 m x 3 m) Silty clay Yo=17 kN/m³ , Ysat = 20 kN/m3 %3D 6 m c'=78 kN/m? 0'=35° Shear modulus=250 kN/m? CS Scanned with CamScanner