Describe the energy transformations that occur when a roller coaster car is pushed by acompressed spring at the top of a frictionless track, rolls along the track as shown and finallycomes into contact with a spring bumper. Your description must define the system such that itcan be treated as a closed, isolated system from the time of the car's release through to whenit first comes to rest against the bumper. State where (or when) all relevant maximum orminimum energy values occur during this event. Use diagrams, equations and words in yourresponsHum

We are given a roller coaster car which is released from a compressed spring. The whole track is…

Answered: Describe the energy transformations…

Similar questions

A 60 kg skier skis 2500 m down a long hill with an average kinetic friction coefficient of 0.20.The skier is initially 400 m above his final position. (Assume the long hill is a like a ramp.) If the skierstarts the run at 2 m/s and finishes the run at 18 m/s, how much work does the skier perform using herarms to push? Compute the initial energy.• Compute the final energy.• Compute the work done by the friction.• Use conservation of energy to find the work the skier did.
A child starts at rest and slides down a frictionless slide as in picture. The bottom of the track is a height h above the ground. The child then leaves the track horizontally, stiking the ground at a distance d as shown. a) Using conservation of energy, find the speed the child at the end of the slide b) Using your answer to part(a) and the equation related to a projectile, determine the initial height H of the child above the ground in terms of h and d
This figure shows a mass (1kg) on a spring, with a spring constant of 550N/m, that is compressed 10cm to the left of its equilibrium position. Immediately to the right of the equilibrium position, there is a region where a frictional force is present. This force is dependent on the position as show in the figure. The region extends 4cm to the right of the equilibrium position. a) What is the initial total energy of the system? b) After release, what is the speed of the block at 5cm to the left of the equilibrium position?
Solution to HW problem with all work and explanation, please.
A 2000 N net force acts right on a 5 kg object through a displacement of 2 m right. The initial velocity of the object is 50 m/s right. Find the net work done by the net force through the 2 m displacement. Find the initial kinetic energy of the object. Find the final velocity of the object after the net force has acted through the 2 m displacement.
A 1.2 kg rock is pressed up against a spring with spring constant 30 N/m and then released, causing it to slide across a frictionless horizontal surface and then to slide up a frictonless incline to a height of 20 cm. (a) Fill out the Energy Chart below to calculate the Potential and Kinetic Energy at each time point. Use g = 10 m/s? for easier calcuations. Assume Energy is Conserved throughout the problem. Scene C Scene A Scene B h3D 20 ст- Ax h = 0 Scene A Scene B Scene C | (b) What is the initial compression of the spring, Ax? PEgravity = mgh КЕ = }mv² PEspring = }k(Ax)² 2.
1. A 23.0 kg child is playing on a swing with a length of 2.5 m. If the swing starts from rest and makes an angle of 40.0◦ with the vertical at the top of the swing, a) determine the child’s speed at the bottom of the swing neglecting friction. b) If the swing has a speed of 2.8 m/s at the bottom, determine the work done by friction during the downswing and, bonus) assuming the force of friction is constant, determine the maximum angle the swing attains on the upswing after passing through the bottom. Hint: Use the approximation that cos θ ≈ 1 − 1 2 θ 2 for angles given in radians.
HI, please see attached image for question. Thank you