Copy the kinetic data below (concentration vs time) into a spreadsheet program (Excel or equivalent). Plot concentration vs time, In(concentration) vs. time, and 1/concentrationvs time. Based on the linearity of these plots, was this reaction zeroth, first, or second order?Time (s)Concentration (M)02.4612.9723.634.3545.2656.3667.6979.3811.25913.61016.441119.891224.05SecondNone of these plots are linear.FirstZeroth

To determine the order of the reaction based on the data in the table, we can plot the data in…

Answered: Copy the kinetic data below…

Chemistry: Matter and Change

1st Edition

ISBN:9780078746376

Author:Dinah Zike, Laurel Dingrando, Nicholas Hainen, Cheryl Wistrom

Publisher:Dinah Zike, Laurel Dingrando, Nicholas Hainen, Cheryl Wistrom

Chapter16: Reaction Rates

Section: Chapter Questions

Problem 69A

See similar textbooks

Similar questions

Candle wax is a mixture of hydrocarbons. In the reaction of oxygen with candle w ax in Figure 11.2, the rate of consumption of oxygen decreased with time after the flask was covered, and eventually' the flame went out. From the perspective of the kinetic-molecular theory, describe what is happening in the flask. FIGURE 11.2 When a candle burns in a closed container, the flame will diminish and eventually go out. As the amount of oxygen present decreases, the rate of combustion will also decrease. Eventually, the rate of combustion is no longer sufficient to sustain the flame even though there is still some oxygen present in the vessel.
The hydrolysis of the sugar sucrose to the sugars glucose and fructose, C12H22O11+H2OC6H12O6+C6H12O6 follows a first-order rate equation for the disappearance of sucrose: Rate =k[C12H22O11] (The products of the reaction, glucose and fructose, have the same molecular formulas but differ in the arrangement of the atoms in their molecules.) (a) In neutral solution, k=2.11011s1 at 27 C and 8.51011s1 at 37 C. Determine the activation energy, the frequency factor, and the rate constant for this equation at 47 C (assuming the kinetics remain consistent with the Arrhenius equation at this temperature). (b) When a solution of sucrose with an initial concentration of 0.150 M reaches equilibrium, the concentration of sucrose is 1.65107M . How long will it take the solution to reach equilibrium at 27 C in the absence of a catalyst? Because the concentration of sucrose at equilibrium is so low, assume that the reaction is irreversible. (c) Why does assuming that the reaction is irreversible simplify the calculation in pan (b)?
From the given data, use a graphical method to determine the order and rate constant of the following reaction: 2XY+Z Time (s) 5.0 10.0 15.0 20.0 25.0 30.0 35.0 40.0 [X](M) 0.0990 0.0497 0.0332 0.0249 0.0200 0.0166 0.0143 0.0125
The initial rate for a reaction is equal to the slope of the tangent line at t 0 in a plot of [A] versus time. From calculus, initial rate = d[A]dt . Therefore. the differential rate law for a reaction is Rate = d[A]dt=k[A]n. Assuming you have some calculus in your background, derive the zero-, first-, and second-order integrated rate laws using the differential rate law.
If you know some calculus, derive the integrated second-order rate law for the reaction 2Aproducts Follow the same steps listed in Question 121.
Two mechanisms are proposed for the reaction 2NO(g)+O2(g)2NO2(g)Mechanism 1: NO+O2NO3(fast) NO3+NO2NO2(slow) Mechanism 2: NO+ON2O2(fast) N2O2+O22NO2(slow) Show that each of these mechanisms is consistent with the observed rate law: rate=k[ NO2 ]2[ O2 ].
Phenyl acetate, an ester, reacts with water according to the equation The data in the table were collected for this reaction at 5 C. (a) Plot the phenyl acetate concentration versus time, and describe the shape of the curve observed. (b) Calculate the rate of change of the phenyl acetate concentration during the period 15.0 seconds to 30.0 seconds and also during the period 75.0 seconds to 90.0 seconds. Why is one value smaller than the other?
The thermal decomposition of diacetylene, C4H2, was studied at 950 C. Use the following data (K. C. Hou and H. B. Palmer, Journal of Physical Chemistry. Vol. 60, p. 858, 1965) to determine the order of the reaction.
As with any drug, aspirin (acetylsalicylic acid) must remain in the bloodstream long enough to be effective. Assume that the removal of aspirin from the bloodstream into the urine is a lirst-order reaction, with a half-life of about 3 hours. The instructions on an aspirin bottle say to take 1 or 2 tablets every 4 hours. If a person takes 2 aspirin tablets, how much aspirin remains in the bloodstream when it is time for the second dose? (A standard tablet contains 325 mg of aspirin.)
If the reaction:A+BC+D is designated as first order, the rate depends on: a.the concentration of only one reactant. b.the concentration of each reactant. c.no specific concentration. d.the temperature only.
11.32 The following experimental data were obtained for the reaction 2A + 3 B—C + 2D [A](mol L 1) [B](mol L ’) Rate = A(C]/Af (mol L-1 s-1) 0.127 0.15 0.033 0.127 0.30 0.132 0.255 0.15 0.066 Determine the reaction order for each reactant and the value of the rate constant.
You are studying the kinetics of the reaction H2(g) + F2(g) 2HF(g) and you wish to determine a mechanism for the reaction. You run the reaction twice by keeping one reactant at a much higher pressure than the other reactant (this lower-pressure reactant begins at 1.000 atm). Unfortunately, you neglect to record which reactant was at the higher pressure, and you forget which it was later. Your data for the first experiment are: Pressure of HF (atm) Time(min) 0 0 0.300 30.0 0.600 65.8 0.900 110.4 1.200 169.1 1.500 255.9 When you ran the second experiment (in which the higher pressure reactant was run at a much higher pressure), you determine the values of the apparent rate constants to be the same. It also turns out that you find data taken from another person in the lab. This individual found that the reaction proceeds 40.0 times faster at 55C than at 35C. You also know, from the energy-level diagram, that there are three steps to the mechanism, and the first step has the highest activation energy. You look up the bond energies of the species involved and they are (in kJ/mol): H8H (432), F8F (154), and H8F (565). a. Sketch an energy-level diagram (qualitative) that is consistent with the one described previously. Hint: See Exercise 106. b. Develop a reasonable mechanism for the reaction. c. Which reactant was limiting in the experiments?

SEE MORE QUESTIONS

Recommended textbooks for you

Chemistry: Matter and Change

Chemistry

ISBN:

9780078746376

Author:

Dinah Zike, Laurel Dingrando, Nicholas Hainen, Cheryl Wistrom

Publisher:

Glencoe/McGraw-Hill School Pub Co

Chemistry: Principles and Practice

Chemistry

ISBN:

9780534420123

Author:

Daniel L. Reger, Scott R. Goode, David W. Ball, Edward Mercer

Publisher:

Cengage Learning

Chemistry: The Molecular Science

Chemistry

ISBN:

9781285199047

Author:

John W. Moore, Conrad L. Stanitski

Publisher:

Cengage Learning

Chemistry: Matter and Change

Chemistry

ISBN:

9780078746376

Author:

Dinah Zike, Laurel Dingrando, Nicholas Hainen, Cheryl Wistrom

Publisher:

Glencoe/McGraw-Hill School Pub Co

Chemistry: Principles and Practice

Chemistry

ISBN:

9780534420123

Author:

Daniel L. Reger, Scott R. Goode, David W. Ball, Edward Mercer

Publisher:

Cengage Learning

Chemistry: The Molecular Science

Chemistry

ISBN:

9781285199047

Author:

John W. Moore, Conrad L. Stanitski

Publisher:

Cengage Learning

Chemistry for Engineering Students

Chemistry

ISBN:

9781337398909

Author:

Lawrence S. Brown, Tom Holme

Publisher:

Cengage Learning

Chemistry by OpenStax (2015-05-04)

Chemistry

ISBN:

9781938168390

Author:

Klaus Theopold, Richard H Langley, Paul Flowers, William R. Robinson, Mark Blaser

Publisher:

OpenStax

Chemistry

ISBN:

9781305957404

Author:

Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS