Convert the following from milligrams per liter as CaCO₃ to milligrams per liter as the ion or compound.(a) 10.00 mg · L⁻¹ CO₂(b) 13.50 mg · L⁻¹ Ca(OH)₂(c) 481.00 mg · L⁻¹ HPO₄²⁻(d) 81.00 mg · L⁻¹ H₂PO₄⁻(e) 40.00 mg · L⁻¹ Cl⁻

Given data,concentration in milligrams per lit as caco3 given FINDconvert given concentration to…

Convert the following from milligrams per liter as CaCO3 to milligrams per liter as the ion or compound. L-¹ CO₂ (d) 81.00 mg L-¹ H₂PO (e) 40.00 mg L-¹ CI- (a) 10.00 mg (b) 13.50 mg. L-¹ Ca(OH)2 (c) 481.00 mg.L-¹ HPO2- . .

Convert the following from milligrams per liter as CaCO3 to milligrams per liter as the ion or compound. L-¹ CO₂ (d) 81.00 mg L-¹ H₂PO (e) 40.00 mg L-¹ CI- (a) 10.00 mg (b) 13.50 mg. L-¹ Ca(OH)2 (c) 481.00 mg.L-¹ HPO2- . .

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: L Calculate the mg/, Malorty for (ii) How much oxygen is required to oxide 100 mg/l of Glucose using…

Q: How much bleaching powder is needed to chlorinate 5000l of water whose chlorine demand is 2 mg/l,…

Q: ug/L of NaOH should be added in water to change the pH from 7 to 9 at 25°C.

Q: The disinfection of water is carried out in a stirred tank. The treatment process has water as the…

A: According to given data The disinfection of water is carried out in a stirred tank. The treatment…

Q: through a pipe having an inside diameter of 60 mm Determine the Reynolds number

Q: Benzene and Kerosene has a specific weight of 53 lb/cu. ft and 49 lb/cu. ft, respectively. The…

Q: Ammonia enters the expansion valve of a refrigeration system at a pressure of 10 bar and a…

A: Step 1:Given dataAmmonia is fluid.Inlet(1): P1 = 10bar,T1 = 20oCExit(2): P2 = 2barProcess 1-2 is…

Q: 11-13 The Cu-Za phase diagram is shown in Figure 11-27. (a) Are any intermetallic compounds pres-…

A: Given:- Cu-Zn phase diagram To find:- a) stoichiometric or nonstoichiometric b)Solid solutions…

Q: Radium decomposes at a rate proportional to the quantity of radium present. Suppose that it is found…

A: To determine the half-life of radium with given information. As is it is given, that the…

Q: Which of the following is not a cause of energy loss in pipes? O Boundary friction O Changes in pipe…

A: Answer Option (d ) pipe temperature is correct. The explanation is given in next step.

Q: y the gas during the expansion process. The E and 0.1 m/kg of specific volume. Final specifie…

A: Isothermal process data we have given that PV =1000 P1 = 1000 Kpa P2 = 500 Kpa P1V1…

Q: Example 9.36. Design a Zeolite-Softener for an industrial concern, using the following data : (i)…

Q: A gas undergoes a cycle in a piston-cylinder assembly consisting of the following three processes:…

Q: Convert the concentration of SO2 from 80 pg m temperature of 25°C and a pressure of 101.325 kPa. to…

A: ppm = Conversions are needed to calculate the volume of So2 in cubic meters.

Q: In wastewater treatment plants, ammonium ion is removed from the water by raising the pH to form…

A: a) The equilibrium reaction that describes the process of ammonium conversion to ammonia is given as

Q: 21. To gain structural strength, the dimensions of aluminum are increased. T or F 22. 35% of…

A: Comment As per our policy, we cannot answer all multiple subparts, Since your question has multiple…

Q: EA two-stage distiller system is used to remove TDS from sea water as shown in the figure. The…

A: Given:- two stage distiller To find:- concentration

Q: Ammonia enters the expansion valve of a refrigeration system at a pressure of 10 bar and a…

Q: The second stage nitrification process is presented by the following equation:

A: Nitrogen atomic weight : 14gmsOxygen atomic weight : 32gmsso,In the equation 2 nitrogen requires 2…

Q: TBP Distillation statistics for a petroleum cut are as follows: Distillate volume percentage 10 30…

Q: (Lola) A Glycerin has a Mass(M)= 945 Kg. And a Volume (V)= 0.750 M3.---The Specific Weight .8 岛 :is…

A: Specific Weight is defined as weight per unit volume. Weight is a force. The unit for specific…

Q: The second stage nitrification process is presented by the following equation Nitrobacter 2NO2+ 02…

A: 1.14 answer is c

Q: How much bleaching powder is needed to chlorinate 5000l of water whose chlorine demand is 2 mg/l,…

A: Given: To chlorinate 5000 l of water. Whose chlorine demand is 2 mg/l The bleaching powder required…

Q: etermine the weight of water in grams.

Q: Text - Problem 2.56] (Show your answer in ppmv as well as ppbv.) 56 Convert the concentration of SO₂…

Q: 10 kg of gaseous CO2 contained in a closed system undergoes a reversible at a constant pressure.…

Q: The angular acceleration of a device which is rotating about a fixed axis is given by a = -5zw?,…

Q: (iii) If HOCI (hypochlorous acid) degrades in water per first-order kinetics with a rate constant of…

Q: A container holds 3 liters of a 25% alcohol solution. One half liter of the solution is withdrawn…

A: Question : A container holds 3 liters of a 25% alcohol solution. One half liter of the solution is…

Q: A nuclear fuel pellet consists of an aluminum cladding [E1 = 90 GPa; α1 = 42.2 × 10-6 /°K] with an…

A: There will be compression in Al as Alpha is more.

Q: A water sample contains the following dissolved ions: [Na+] = 75 mg/l [HCO₂] = 250 mg/1 [CH] = 100…

Q: 2.8. You are given a box containing NH3, N₂, and H₂ at equilibrium at 1000 K. The contents are…

Q: The most important buffer system in water is the carbon dioxide system of acid/base reactions.…

A: Alkalinity of any solution defined as the ability to neutralise the H+ ions in the solution. here…

Q: It is connected to a tank in the form of a U- type mercury manometer. Since the G liquid has a…

Q: Henry's law constant for transferring 02 from air into water, at room temperature, mmol - is 1.3…

A: Given data: Henry's law constant at room temperature, k = 1.3 m-mollt-atm Partial pressure, P = 0.21…

Q: A fluid in motion suffers a frictional loss, which is an expenditure of energy required to overcome…

Q: Calculate the ThOD of a 300 mg/L solution of C5H7O₂N.

A: We have to calculate the Thod ThOD of a 300 mg/L solution of C5H8O2N

Q: For a solution with a pH equal to 9.5, express the concentrations of H+ and OH- in units of meq/L…

Q: How much bleaching powder is needed to chlorinate 5000l of water whose chlorine demand is 2 mg/l,…

Q: The concentration of NO₂ in the air at STP is observed as 0.45 ppm. At STP, 1 mole of any gas…

A: The concentration of NO2 in the air at STP is observed as 0.45 ppm.At STP, 1 mole of any gas…

Q: A piston-cylinder assembly contains ammonia, initially at a temperature of -20°C and a quality of…

A: To solve this problem, we can use the first law of thermodynamics, which states:ΔU=Q−W Where:ΔU is…

Q: Calculate the THOD of a 300 mg/L solution of C5H8O2N.

A: To Find :- ThOD of a 300 mg/L solution of C5H8O2N

Concept explainers

Unit Conversion

Standard units are also called SI units. SI units are used for measuring a physical quantity satisfying certain conditions. There are two types of units: fundamental units and derived units. Fundamental units are physical quantities that are independent, that is, they do not depend on other quantities like mass, length, or time. There are plenty of quantities in our lives which need to be measured and compared. Measuring is the comparison of a particular physical quantity with its reference value. A unit is a measure of a fixed physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.

Question

Convert the following from milligrams per liter as CaCO₃ to milligrams per liter as the ion or compound.

(a) 10.00 mg · L⁻¹ CO₂

(b) 13.50 mg · L⁻¹ Ca(OH)₂

(c) 481.00 mg · L⁻¹ HPO₄²⁻

(d) 81.00 mg · L⁻¹ H₂PO₄⁻

(e) 40.00 mg · L⁻¹ Cl⁻

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1: step 1

Step 2: step 2

Step 3: step 3

Step 4: step 4

Solution

Trending now

This is a popular solution!

Step by step

Solved in 5 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

I need the answer as soon as possible
Determine the concentration of hydrogen ion and the hydroxide ion (in mg/L) of a solution that has a pH of 9.1
2000 -Liquidus 1000 Liquid 1800 -Solidus a +L 1600 B+L 779°C 800 8.0 71.9 91.2 1400 1200 600 1000 a + B 800 400 600 200 400 100 20 40 60 80 (Cu) Composition (wt% Ag) (Ag) Temperature (°C) Temperature (°F)
Refrigerant 134a expands in a piston-cylinder assembly from p₁ = 140 lb/in² and T₁ = 140°F to p₂ = 30 lb/in² and T₂ = 80°F. The mass of refrigerant is 0.44 lb. During the process, the work done by the refrigerant is 4.32 Btu. Kinetic and potential energy effects are negligible. Determine the initial volume of the refrigerant, V₁, in ft³, and the heat transfer for the process, in Btu. Step 1 * Your answer is incorrect. Determine the initial volume of the refrigerant, V₁, in ft³. V₁ = i 1.6386 ft³
2000 -Liquidus 1000 Liquid 1800 -Solidus a +L 1600 B+L 779°C 800 8.0 71.9 91.2 1400 1200 600 1000 a + B 800 400 600 200 400 100 20 40 60 80 (Cu) Composition (wt% Ag) (Ag) Temperature (°C) Temperature (°F)
Civil Engineering In a steam turbine, steam with the mass flow rate of 201 kg/s enters the turbine al the lemperature of 601°C and the pressure of 16 MPg and exits at the lemperature of 31°C and the quality of 96% Determine the power production in the turbine (in kW), The change in kinetic and potential energies are negligible and the process is steady slate and adlabalic. List all your assumptions
Liquid weighing 0.98 gram and containing 90% of carbon and 8% of hydrogen give the following result in the bomb calorimeter experiment amount of water taken in the calorimeter equal to 450 gram water equivalent of the calorimeter equal to 450 gram rise in temperature of water equal to 1.8 degree centigrade if the latent heat of steam is 587 calorie per gram calculate the cross and net calorific value of the fuel
How much bleaching powder is needed to chlorinate 5000l of water whose chlorine demand is 2 mg/l, assuming that the bleaching powder has 25% available chlorine? A 4 g B 40 g C 140 g D 400 g
The specific volume of a certain gas is 320-cu.ft/slug a. Determine its density b. Calculate its specific weight.
The disinfection of water is carried out in a stirred tank. The treatment process has water as the input at a rate of 48, 000 L/h. The tank carries 3500 L of water at all times. Sufficient chlorine is fed to the water. The rate of disinfection can be described as a first-order reaction with a rate constant of 0.25/min. The efficiency of the system can be expected to be (A) 0.22 (B) 0.32 (C) 0.42 (D) 0.52
) Calculate the concentration of hydroxide ions *Select a concentration between 0.10 and 0.58 d) Calculate the pH of the methylamine solution
The one-hour standard for CO is 35 ppm, Calculate the equivalent concentration in mg/m3.