2: Your alloy contains 60% Ag and is at temperature 778.9°Ca) Hypoeutectic or Hypereutectic?b) What phases are present in the alloy at this point?c) What are the compositions of the phases present at this point?d) What proportions of the two phases make up the alloy at this point? (Draw a tie lineand perform lever rule calculations below)e) What constituents are present in the alloy at this point?f) What are the compositions of the constituents present at this point? 2000-Liquidus1000Liquid1800-Solidusa +L1600B+L779°C8008.071.991.2140012006001000a + B80040060020040010020406080(Cu)Composition (wt% Ag)(Ag)Temperature (°C)Temperature (°F)

Given data, alloy contains =60% Ag = WAg Temperature=T=778.9˚c( just below…

2: Your alloy contains 60% Ag and is at temperature 778.9°C a) Hypoeutectic or Hypereutectic? b) What phases are present in the alloy at this point? c) What are the compositions of the phases present at this point? d) What proportions of the two phases make up the alloy at this point? (Draw a tie line and perform lever rule calculations below)

2: Your alloy contains 60% Ag and is at temperature 778.9°C a) Hypoeutectic or Hypereutectic? b) What phases are present in the alloy at this point? c) What are the compositions of the phases present at this point? d) What proportions of the two phases make up the alloy at this point? (Draw a tie line and perform lever rule calculations below)

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

The difference between traditional ceramics and new ceramics is that most traditional ceramics are based primarily on silicates such as clay whereas the new ceramics are based on nonsilicates such as oxides and carbides: Group of answer choices true false
Why does excess silica will cause loss of precious minerals which will form alloy
Clearly show your work
A material has modus of rigidity 250 GN/m and bulk modulus of 450 GN/mm. What will be the value of poison's ratio.
18 Material Science and Engineering
C11 3 sig. figures pls:)
What would you expect if you have a 6061 aluminum alloy bar, heat it for 1 hour in the oven forming a single phase, then severely temper it in water and then heat it at 150 ° for 6 hours. ? a) ductility is increased b) increases yield stress c) hardness is reduced d) the material is over-aged and the yield stress is reduced
Identify the physical properties of the Biotite mineral family, their formation, and uses in Civil Engineering.
34 If the following diagram represents the sintering of the ceramic MgO, what could the curves x and y refer to? increase in property X 1000 1200 1600 sintering temperature (°C) (A) = grain size; y porosity (B) x grain size; y = strength O(C) x porosity; y-grain size 1400 O (D) x strength; y grain size 1800
Need help with this question. Thank you :)
Consider an 6061-T6 aluminun alloy having an elastic modulus of 75 GPa and yield strength of 260 MPa. What is the modulus of resilience of the given material ?
I need the answer at 20 minute